
Physical Science
10th Edition
ISBN: 9780073513898
Author: Bill Tillery
Publisher: MCGRAW-HILL HIGHER EDUCATION
expand_more
expand_more
format_list_bulleted
Concept explainers
Question
Chapter 17, Problem 8QFT
To determine
To explain: The basic difference between the igneous, metamorphic and sedimentary rocks on the basis of their mode of formation.
Expert Solution & Answer

Want to see the full answer?
Check out a sample textbook solution
Students have asked these similar questions
Shrinking Loop. A circular loop of flexible iron wire has an initial circumference of 161 cm , but its circumference is decreasing at a constant rate of 15.0 cm/s due to a tangential pull on the wire. The loop is in a constant uniform magnetic field of magnitude 1.00 T , which is oriented perpendicular to the plane of the loop. Assume that you are facing the loop and that the magnetic field points into the loop. Find the magnitude of the emf E induced in the loop after exactly time 9.00 s has passed since the circumference of the loop started to decrease. Find the direction of the induced current in the loop as viewed looking along the direction of the magnetic field. Please explain all steps
Make up an application physics principle problem that provides three (3) significant equations based on the concepts of capacitors and ohm's law.
A straight horizontal garden hose 38.0 m long with an interior diameter of 1.50 cm is used to deliver 20oC water at the rate of 0.590 liters/s. Assuming that Poiseuille's Law applies, estimate the pressure drop (in Pa) from one end of the hose to the other.
Chapter 17 Solutions
Physical Science
Ch. 17 - 1. A naturally occurring inorganic solid element...Ch. 17 - 2. A structural unit that is repeated in three...Ch. 17 - 3. Which element is the most abundant in Earth’s...Ch. 17 - 4. Minerals are classified as
a. silicates.
b....Ch. 17 - 5. The most abundant class of nonsilicates is...Ch. 17 - 6. Silicates are classified into two groups based...Ch. 17 - 7. The color of a mineral when it is finely...Ch. 17 - 8. The hardness of a mineral is rated using the
a....Ch. 17 - 9. The ratio of the mineral’s density to the...Ch. 17 -
10. Molten rock material from which minerals...
Ch. 17 -
11. An aggregation of one or more minerals that...Ch. 17 -
12. Rocks that are formed from molten minerals...Ch. 17 -
13. Igneous rock that slowly cooled deep below...Ch. 17 -
14. The rock that makes up the bulk of Earth’s...Ch. 17 -
15. The rock that makes up the ocean basins and...Ch. 17 -
16. Rocks that are formed from particles of other...Ch. 17 - 17. Accumulations of silt, sand, or other...Ch. 17 - 18. Limestone and dolomite are
a. sandstone.
b....Ch. 17 - 19. Heat and pressure change rocks into
a.igneous...Ch. 17 - 20. The relationship between rocks that are...Ch. 17 - 21. The thin layer that covers Earth’s surface is...Ch. 17 - 22. Based on its abundance in Earth's crust, most...Ch. 17 - 23. The most common rock in Earth's crust is
a....Ch. 17 - 24. An intrusive igneous rock will have which type...Ch. 17 - 25. Which igneous rock would have the greatest...Ch. 17 - 26. Which of the following formed from previously...Ch. 17 - 27. Sedimentary rocks are formed by the processes...Ch. 17 - 28. The greatest extent of metamorphic changes has...Ch. 17 - 29. Which type of rock probably existed first,...Ch. 17 - 30. Earth is unique because it has
a. CO2 in its...Ch. 17 - 31. The common structural feature of all silicates...Ch. 17 - 32. The one group that is not a subgroup of the...Ch. 17 - 33. The property that is not considered useful in...Ch. 17 - 34. The specific gravity of a mineral depends on...Ch. 17 - 35. Fluorite is a mineral that floats in liquid...Ch. 17 - 36. The group that is not a class of rocks is
a....Ch. 17 - 37. The classification of rocks is based on
a....Ch. 17 - 38. An example of a sedimentary rock is
a....Ch. 17 - 39. The term that does not describe a size of...Ch. 17 - 40. Dissolved rock materials form
a. chemical...Ch. 17 - 41. An example of a metamorphic rock is
a....Ch. 17 - 42. Extrusive igneous rocks are formed on Earth’s...Ch. 17 - 43. Foliation is found in
a. sedimentary rocks.
b....Ch. 17 - Prob. 1QFTCh. 17 - Prob. 2QFTCh. 17 - 3. Explain why each mineral has its own unique set...Ch. 17 - 4. Identify at least eight physical properties...Ch. 17 - 5. Explain how the identity of an unknown mineral...Ch. 17 - 6. What is a rock?
Ch. 17 - 7. Describe the concept of the rock cycle.
Ch. 17 - Prob. 8QFTCh. 17 - 9. Which major kind of rock, based on the way it...Ch. 17 -
10. What is the difference between magma and...Ch. 17 -
11. What is meant by the “texture" of an igneous...Ch. 17 -
12. What are the basic differences between...Ch. 17 -
13. Explain why a cooled and crystallized magma...Ch. 17 - Prob. 14QFTCh. 17 -
15. What are clastic sediments? How are they...Ch. 17 -
16. Briefly describe the rock-forming process...Ch. 17 - 17. What are metamorphic rocks? What limits the...Ch. 17 - 18. Describe what happens to the minerals as shale...Ch. 17 - Prob. 19QFTCh. 17 - 1. What are the significant similarities and...Ch. 17 - 2. Is ice a mineral? Describe reasons to support...Ch. 17 - 3. If ice is a mineral, is a glacier a rock?...Ch. 17 - Prob. 4FFACh. 17 - 1. A sample of the mineral sylvite measures 2.68...Ch. 17 - 2. A rectangular crystal of calcium plagioclase...Ch. 17 - 3. A spherical specimen of the mineral quartz...Ch. 17 - 4. Geologists separate nonferromagnesian silicates...Ch. 17 - 5. Compare the mineral halite (NaCl, hardness of...Ch. 17 - 6. Mica is a sheet silicate while quartz is a...Ch. 17 - 7. Magnesite is a magnesium ore mineral and has...Ch. 17 - 8. Magnetite and hematite are iron ore minerals....Ch. 17 - 9. An iron mine has an ore deposit estimated at...Ch. 17 - 10. An ore deposit consisting of chert and...Ch. 17 -
11. For a given igneous rock type, the proportion...Ch. 17 -
12. Based on Figure 17.13, what is the average...Ch. 17 -
13. A gabbro countertop measuring 4.70 m long by...Ch. 17 -
14. A sandstone building stone measuring 50.0 cm...Ch. 17 - Prob. 15PEB
Knowledge Booster
Learn more about
Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.Similar questions
- A rectangle measuring 30.0 cm by 40.0 cm is located inside a region of a spatially uniform magnetic field of 1.70 T , with the field perpendicular to the plane of the coil (the figure (Figure 1)). The coil is pulled out at a steady rate of 2.00 cm/s traveling perpendicular to the field lines. The region of the field ends abruptly as shown. Find the emf induced in this coil when it is all inside the field, when it is partly in the field, and when it is fully outside. Please show all steps.arrow_forwardA rectangular circuit is moved at a constant velocity of 3.00 m/s into, through, and then out of a uniform 1.25 T magnetic field, as shown in the figure (Figure 1). The magnetic field region is considerably wider than 50.0 cm . Find the direction (clockwise or counterclockwise) of the current induced in the circuit as it is going into the magnetic field (the first case), totally within the magnetic field but still moving (the second case), and moving out of the field (the third case). Find the magnitude of the current induced in the circuit as it is going into the magnetic field . Find the magnitude of the current induced in the circuit as it is totally within the magnetic field but still moving. Find the magnitude of the current induced in the circuit as it is moving out of the field. Please show all stepsarrow_forwardShrinking Loop. A circular loop of flexible iron wire has an initial circumference of 161 cm , but its circumference is decreasing at a constant rate of 15.0 cm/s due to a tangential pull on the wire. The loop is in a constant uniform magnetic field of magnitude 1.00 T , which is oriented perpendicular to the plane of the loop. Assume that you are facing the loop and that the magnetic field points into the loop. Find the magnitude of the emf E induced in the loop after exactly time 9.00 s has passed since the circumference of the loop started to decrease. Find the direction of the induced current in the loop as viewed looking along the direction of the magnetic field. Please explain all stepsarrow_forward
- A circular loop of wire with radius 0.0480 m and resistance 0.163 Ω is in a region of spatially uniform magnetic field, as shown in the following figure (Figure 1). The magnetic field is directed out of the plane of the figure. The magnetic field has an initial value of 7.88 T and is decreasing at a rate of -0.696 T/s . Is the induced current in the loop clockwise or counterclockwise? What is the rate at which electrical energy is being dissipated by the resistance of the loop? Please explain all stepsarrow_forwardA 0.333 m long metal bar is pulled to the left by an applied force F and moves to the left at a constant speed of 5.90 m/s. The bar rides on parallel metal rails connected through a 46.7 Ω resistor, as shown in (Figure 1), so the apparatus makes a complete circuit. You can ignore the resistance of the bar and rails. The circuit is in a uniform 0.625 T magnetic field that is directed out of the plane of the figure. Is the induced current in the circuit clockwise or counterclockwise? What is the rate at which the applied force is doing work on the bar? Please explain all stepsarrow_forwardA 0.850-m-long metal bar is pulled to the right at a steady 5.0 m/s perpendicular to a uniform, 0.650-T magnetic field. The bar rides on parallel metal rails connected through a 25-Ω, resistor (Figure 1), so the apparatus makes a complete circuit. Ignore the resistance of the bar and the rails. Calculate the magnitude of the emf induced in the circuit. Find the direction of the current induced in the circuit. Calculate the current through the resistor.arrow_forward
- In the figure, a conducting rod with length L = 29.0 cm moves in a magnetic field B→ of magnitude 0.510 T directed into the plane of the figure. The rod moves with speed v = 5.00 m/s in the direction shown. When the charges in the rod are in equilibrium, which point, a or b, has an excess of positive charge and where does the electric field point? What is the magnitude E of the electric field within the rod, the potential difference between the ends of the rod, and the magnitude E of the motional emf induced in the rod? Which point has a higher potential? Please explain all stepsarrow_forwardExamine the data and % error values in Data Table 2 where the mass of the pendulum bob increased but the angular displacement and length of the simple pendulum remained constant. Describe whether or not your data shows that the period of the pendulum depends on the mass of the pendulum bob, to within a reasonable percent error.arrow_forwardPlease graph, my software isn't working - Data Table 4 of Period, T vs √L . (Note: variables are identified for graphing as y vs x.) On the graph insert a best fit line or curve and display the equation on the graph. Thank you!arrow_forward
- I need help with problems 93 and 94arrow_forwardSince the instruction says to use SI units with the correct sig-fig, should I only have 2 s for each trial in the Period column? Determine the theoretical period of the pendulum using the equation T= 2π √L/g using the pendulum length, L, from Data Table 2. Calculate the % error in the periods measured for each trial in Data Table 2 then recordarrow_forwardA radiography contingent are carrying out industrial radiography. A worker accidentally crossed a barrier exposing themselves for 15 seconds at a distance of 2 metres from an Ir-192 source of approximately 200 Bq worth of activity. What dose would they have received during the time they were exposed?arrow_forward
arrow_back_ios
SEE MORE QUESTIONS
arrow_forward_ios
Recommended textbooks for you
- An Introduction to Physical SciencePhysicsISBN:9781305079137Author:James Shipman, Jerry D. Wilson, Charles A. Higgins, Omar TorresPublisher:Cengage LearningAstronomyPhysicsISBN:9781938168284Author:Andrew Fraknoi; David Morrison; Sidney C. WolffPublisher:OpenStax

An Introduction to Physical Science
Physics
ISBN:9781305079137
Author:James Shipman, Jerry D. Wilson, Charles A. Higgins, Omar Torres
Publisher:Cengage Learning

Astronomy
Physics
ISBN:9781938168284
Author:Andrew Fraknoi; David Morrison; Sidney C. Wolff
Publisher:OpenStax
A Level Physics – Ideal Gas Equation; Author: Atomi;https://www.youtube.com/watch?v=k0EFrmah7h0;License: Standard YouTube License, CC-BY