Draw the top, the front and the right side orthogonal views of the given object and indicate when an object needs only one or two views.
Answer to Problem 1P
The top, front and right-side orthogonal view of the given object has been drawn and object which needs one or two views are investigated.
Explanation of Solution
Calculation:
Sketch the given figure as follows,
When the observer observes the object from the front side, the view captured on the front plane is represented below Figure 2.
When the observer observes the object from the top side, the view captured on the top plane is represented below in Figure 3.
When the observer observers the object from the right side, the view captured on the right side plane is represented below in Figure 4.
Refer to Figure 4, the dashed lines are indicates the intersection of two planes that are not visible from the direction of the observer.
Here, the given object is complex geometry. Hence, it requires at least three plane of projected views namely front, top and side views for the full description of object.
Conclusion:
Hence, the top, front and right-side orthogonal views of the given object have been drawn and object which needs one or two views are investigated.
Want to see more full solutions like this?
Chapter 16 Solutions
EBK ENGINEERING FUNDAMENTALS: AN INTROD
- Use the cutting planes shown to draw the sectional views.arrow_forwardA. 3 view B. isometric C. Perspective D. Obliquearrow_forwardProjections of various points are given in fig. 9-7. State the position of each point with respect to the planes of projection, giving the distances in centimetres. FIG. 9-7arrow_forward
- List commands used, to transform the following figure. (Note: Skip onthe 2 dimensional drawing, start of converting 2D objects to 3D)arrow_forwardSubject: Engineering Drawing or AutoCAD Instruction: Draw the 2D Orthographic Projection (Front, Top, and Right or Left Side Views) of the indicated 3D Drawing (Isometric View). You can frechand draw or use AutoCAD. Note: Indicate the Dimensions. FRONT **units in mm 10arrow_forward40 10 80 Draw the isometric perspective and the ortogrophic views of the object (4 views in total). Indicate dimensions for all of the views.arrow_forward
- 4. Given two Orthographic views of an object, construct an Auxiliary view of the indicated ( —P) inclined surface. Draw construction lines lightly and edge lines boldly. Please show lines clearly.arrow_forwardDraw the top, the front, and the right side orthographic views of the objects shown. Indicate when an object needs only one or two views to be fully described.arrow_forwardIsometric drawingarrow_forward
Engineering Fundamentals: An Introduction to Engi...Civil EngineeringISBN:9781305084766Author:Saeed MoaveniPublisher:Cengage Learning