How many protons give rise to each given signal for a compound with the formula C 11 H 14 is to be calculated. Concept introduction: The greater the height of integral stair step, greater is the number of protons that contribute to that signal. The area under an absorption peak is proportional to the number of protons that generate that peak. Division of the each stair case height by the smallest values gives the respective number of H. It is convenient to convert the output from integration to the smallest set of whole-number ratios because the number of hydrogen atoms each signal represents must be a whole number. The actual number of hydrogen atoms each signal represents is either the same as that in the ratio or a multiple of it.

Question

Want to see the full answer?

Answer 1

Question

Chapter 16, Problem 16.54P

Interpretation Introduction

Interpretation:

How many protons give rise to each given signal for a compound with the formula C11H14 is to be calculated.

Concept introduction:

The greater the height of integral stair step, greater is the number of protons that contribute to that signal. The area under an absorption peak is proportional to the number of protons that generate that peak. Division of the each stair case height by the smallest values gives the respective number of H.

It is convenient to convert the output from integration to the smallest set of whole-number ratios because the number of hydrogen atoms each signal represents must be a whole number. The actual number of hydrogen atoms each signal represents is either the same as that in the ratio or a multiple of it.

Expert Solution & Answer

Want to see the full answer?

Check out a sample textbook solution

See solution

Students have asked these similar questions

One method for the analysis of Fe3+, which is used with a variety of sample matrices, is to form the highly colored Fe3+–thioglycolic acid complex. The complex absorbs strongly at 535 nm. Standardizing the method is accomplished using external standards. A 10.00-ppm Fe3+ working standard is prepared by transferring a 10-mL aliquot of a 100.0 ppm stock solution of Fe3+ to a 100-mL volumetric flask and diluting to volume. Calibration standards of 1.00, 2.00, 3.00, 4.00, and 5.00 ppm are prepared by transferring appropriate amounts of the 10.0 ppm working solution into separate 50-mL volumetric flasks, each of which contains 5 mL of thioglycolic acid, 2 mL of 20% w/v ammonium citrate, and 5 mL of 0.22 M NH3. After diluting to volume and mixing, the absorbances of the external standards are measured against an appropriate blank. Samples are prepared for analysis by taking a portion known to contain approximately 0.1 g of Fe3+, dissolving it in a minimum amount of HNO3, and diluting to…

Absorbance and transmittance are related by: A = -log(T) A solution has a transmittance of 35% in a 1-cm-pathlength cell at a certain wavelength. Calculate the transmittance if you dilute 25.0 mL of the solution to 50.0 mL? (A = εbc) What is the transmittance of the original solution if the pathlength is increased to 10 cm?

Under what conditions will Beer’s Law most likely NO LONGER be linear? When the absorbing species is very dilute. When the absorbing species participates in a concentration-dependent equilibrium. When the solution being studied contains a mixture of ions.