Bundle: Comptia A+ Guide To It Technical Support, 10th + Mindtap, 1 Term Printed Access Card
10th Edition
ISBN: 9780357012789
Author: Jean Andrews, Joy Dark, Jill West
Publisher: Cengage Learning
expand_more
expand_more
format_list_bulleted
Concept explainers
Videos
Textbook Question
Chapter 16, Problem 13TC
You have set up a user group named Accounting and have put all employees in the Accounting department in this group, which has been given permission to use the Financial folder on a file server. You are now asked to create a subfolder under Financial named Payroll. Megan, the payroll officer, is the only employee in the Accounting department allowed to access this folder. What is the best way to configure the new share?
a. Assign Megan read/write permissions to the Payroll folder, and explain to your boss that it is not a best practice to give only one employee access to an important folder.
b. Assign Megan read/write permissions to the Payroll folder.
c. Create a new user group named Payroll, put Megan in the group, and assign the group read/write permissions to the Payroll folder.
d. Ask your boss to allow you to put the folder outside of the Financial folder so you can assign a new user group read/write permissions to this folder that will not conflict with the Accounting user group.
Expert Solution & Answer
Want to see the full answer?
Check out a sample textbook solution
Students have asked these similar questions
15 points
Save ARS
Consider the following scenario in which host 10.0.0.1 is communicating with an external SMTP mail server at IP
address 128.119.40.186.
NAT translation table
WAN side addr
LAN side addr
(c), 5051
(d), 3031
S: (e),5051
SMTP
B
D (f.(g)
10.0.0.4
server
138.76.29.7
128.119.40.186
(a) is the source IP address at A, and its value.
S: (a),3031
D: (b), 25
10.0.0.1
A
10.0.0.2.
1. 138.76.29.7
10.0.0.3
6.3A-3. Multiple Access protocols (3). Consider the figure below, which shows the arrival of 6
messages for transmission at different multiple access wireless nodes at times t=0.1, 1.4, 1.8, 3.2,
3.3, 4.1. Each transmission requires exactly one time unit.
1
t=0.0
2
3
45
t=1.0
t-2.0
t-3.0
6
t=4.0
t-5.0
For the CSMA protocol (without collision detection), indicate which packets are successfully
transmitted. You should assume that it takes .2 time units for a signal to propagate from one node to
each of the other nodes. You can assume that if a packet experiences a collision or senses the
channel busy, then that node will not attempt a retransmission of that packet until sometime after
t=5. Hint: consider propagation times carefully here. (Note: You can find more examples of problems similar to this here B.]
☐
U
ப
5
-
3
1
4
6
2
Just wanted to know, if you had a scene graph, how do you get multiple components from a specific scene node within a scene graph? Like if I wanted to get a component from wheel from the scene graph, does that require traversing still?
Like if a physics component requires a transform component and these two component are part of the same scene node. How does the physics component knows how to get the scene object's transform it is attached to, this being in a scene graph?
Chapter 16 Solutions
Bundle: Comptia A+ Guide To It Technical Support, 10th + Mindtap, 1 Term Printed Access Card
Knowledge Booster
Learn more about
Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, computer-science and related others by exploring similar questions and additional content below.Similar questions
- How to develop a C program that receives the message sent by the provided program and displays the name and email included in the message on the screen?Here is the code of the program that sends the message for reference: typedef struct { long tipo; struct { char nome[50]; char email[40]; } dados;} MsgStruct; int main() { int msg_id, status; msg_id = msgget(1000, 0600 | IPC_CREAT); exit_on_error(msg_id, "Creation/Connection"); MsgStruct msg; msg.tipo = 5; strcpy(msg.dados.nome, "Pedro Silva"); strcpy(msg.dados.email, "pedro@sapo.pt"); status = msgsnd(msg_id, &msg, sizeof(msg.dados), 0); exit_on_error(status, "Send"); printf("Message sent!\n");}arrow_forward9. Let L₁=L(ab*aa), L₂=L(a*bba*). Find a regular expression for (L₁ UL2)*L2. 10. Show that the language is not regular. L= {a":n≥1} 11. Show a derivation tree for the string aabbbb with the grammar S→ABλ, A→aB, B→Sb. Give a verbal description of the language generated by this grammar.arrow_forward14. Show that the language L= {wna (w) < Nь (w) < Nc (w)} is not context free.arrow_forward
- 7. What language is accepted by the following generalized transition graph? a+b a+b* a a+b+c a+b 8. Construct a right-linear grammar for the language L ((aaab*ab)*).arrow_forward5. Find an nfa with three states that accepts the language L = {a^ : n≥1} U {b³a* : m≥0, k≥0}. 6. Find a regular expression for L = {vwv: v, wЄ {a, b}*, |v|≤4}.arrow_forward15. The below figure (sequence of moves) shows several stages of the process for a simple initial configuration. 90 a a 90 b a 90 91 b b b b Represent the action of the Turing machine (a) move from one configuration to another, and also (b) represent in the form of arbitrary number of moves.arrow_forward
- 12. Eliminate useless productions from Sa aA BC, AaBλ, B→ Aa, C CCD, D→ ddd Cd. Also, eliminate all unit-productions from the grammar. 13. Construct an npda that accepts the language L = {a"b":n≥0,n‡m}.arrow_forwardYou are given a rope of length n meters and scissors that can cut the rope into any two pieces. For simplification, only consider cutting the rope at an integer position by the meter metric. Each cut has a cost associated with it, c(m), which is the cost of cutting the rope at position m. (You can call c(m) at any time to return the cost value.) The goal is to cut the rope into k smaller pieces, minimizing the total cost of cutting. B Provide the pseudo-code of your dynamic programming algorithm f(n,k) that will return the minimum cost of cutting the rope of length n into k pieces. Briefly explain your algorithm. What is the benefit of using dynamic programming for this problem? What are the key principles of dynamic programming used in your algorithm?arrow_forwardDetermine whether each of the problems below is NP-Complete or P A. 3-SAT B. Traveling Salesman Problem C. Minimum Spanning Tree D. Checking if a positive integer is prime or not. E. Given a set of linear inequalities with integer variables, finding a set of values for the variables that satisfies all inequalities and maximizes or minimizes a given linear objective function.arrow_forward
- 1. Based on our lecture on NP-Complete, can an NP-Complete problem not have a polynomial-time algorithm? Explain your answer. 2. Prove the conjecture that if any problem in NP is not polynomial-time solvable, then no NP-Complete problem is polynomial-time solvable. (You can't use Theorem 1 and 2 directly) 3. After you complete your proof in b), discuss how this conjecture can be used to solve the problem of whether P=NP.arrow_forwardBased on our lectures and the BELLMAN-FORD algorithm below, answer the following questions. BELLMAN-FORD (G, w, s) 1 INITIALIZE-SINGLE-SOURCE (G, s) 2 for i = 1 to |G. VI - 1 3 4 5 6 7 8 for each edge (u, v) = G.E RELAX(u, v, w) for each edge (u, v) = G.E if v.d> u.d+w(u, v) return FALSE return TRUE 1. What does the algorithm return? 2. Analyze the complexity of the algorithm.arrow_forward(Short-answer) b. Continue from the previous question. Suppose part of the data you extracted from the data warehouse is the following. Identify the missing values you think exist in the dataset. Use Column letter and Row number to refer to each missing value in the dataset. Please write down how you want to address each particular missing value (you can group them if they receive same treatment). For imputation, you do not need to calculate the exact imputed values but just describe what kind of value you want to use to impute.arrow_forward
arrow_back_ios
SEE MORE QUESTIONS
arrow_forward_ios
Recommended textbooks for you
A+ Guide To It Technical SupportComputer ScienceISBN:9780357108291Author:ANDREWS, Jean.Publisher:Cengage,
Microsoft Visual C#Computer ScienceISBN:9781337102100Author:Joyce, Farrell.Publisher:Cengage Learning,
EBK JAVA PROGRAMMINGComputer ScienceISBN:9781337671385Author:FARRELLPublisher:CENGAGE LEARNING - CONSIGNMENT
A+ Guide To It Technical Support
Computer Science
ISBN:9780357108291
Author:ANDREWS, Jean.
Publisher:Cengage,
Microsoft Visual C#
Computer Science
ISBN:9781337102100
Author:Joyce, Farrell.
Publisher:Cengage Learning,
EBK JAVA PROGRAMMING
Computer Science
ISBN:9781337671385
Author:FARRELL
Publisher:CENGAGE LEARNING - CONSIGNMENT
Linux - Tutorial for Beginners in 13 MINUTES! [ UPDATED ]; Author: bai;https://www.youtube.com/watch?v=BMGixkvJ-6w;License: Standard YouTube License, CC-BY
What is Linux?; Author: Techquickie;https://www.youtube.com/watch?v=zA3vmx0GaO8;License: Standard YouTube License, CC-BY
Introduction to Linux and Basic Linux Commands for Beginners; Author: sakitech;https://www.youtube.com/watch?v=IVquJh3DXUA;License: Standard Youtube License