Chapter 15, Problem 6ST

Solve on Paper not using chatgpt

I need help with this problem and an explanation of the solution for the image described below. (Introduction to Signals and Systems)

Given 10AWG, copper, RHW, 44 C, 3 conductors, find ampacity

ACS712 PV Nov ID Voltage RD R1 sensing VDS R2 MOSFET S VGS Gate PWM driver Oscilloscope Vpv, Ip AO Arduino A1 Serial interface 01 Computer Fig. 4. The proposed electronics load to measure PV characteristics.

explain the circuit and the curve

explain the circuit

Solve on paper not using chatgpt

Assume that a building manager instructed you to install a water heater. The specs on the water heater nameplate reveals the following 240V, 2PH, 60HZ, 5.7KW. The manager insisted for the installation to be done with 10 AWG copper THWN-2 conductor, the length of run is 1200 FT away from the service panel. Calculate the voltage after the installation.

Please confirm that my solution is correct, especially the block diagram. Please DRAW (not type) what the block diagram would look like if it's incorrect.  thank you