Whether the Hume-Rothery rules are applicable for ceramic systems.

Question

Want to see the full answer?

Answer 1

Question

Chapter 12, Problem 34QAP

To determine

To find:

Whether the Hume-Rothery rules are applicable for ceramic systems.

Expert Solution & Answer

Want to see the full answer?

Check out a sample textbook solution

See solution

Students have asked these similar questions

Design a full-wave rectifier power supply using a 9.52:1 transformer. Assume that the outlet is120 V rms @ 60 Hz. Further assume that the diode turn-on voltage V D(on) is 0.7 V. Pick the valueof CL such that vo has a maximum ripple of 1 V p-p . Solve for the average value of vo = Vo (notethat this may be greater than 12 V) and iD(ave) = ID.

Light-emitting diodes (LEDs) are diodes made with III-V compound semiconductor materials such as aluminum gallium arsenide (AlGaAs), aluminum indium gallium phosphide (AlInGaP) or indium gallium nitride (InGaN), instead of silicon. The LEDs emit light when the device is operated under forward bias. LEDs of different colors have different turn-on voltages VD(on). For example: VD(on) : Red: ~ 1.6 V Yellow: ~ 1.7 V Green: ~ 1.8 V Blue: ~ 2.8 V White: ~ 3.8 V (a) Model these five LEDs with a simplified piecewise linear model (b) A rule of thumb is that it takes about 1 mA of current to “light” an LED while ~ 10 mA is needed for it to appear bright. Use the piecewise linear model for the LEDs, for the over-voltage indicator circuit to the right, find the values of Vin which will cause D1 or D2 to light (i.e. when ID1 or ID2 exceeds 1 mA).

The farming plan of steel structure has 30 ft long simply supported beams spaced at 8 ft apart. The beams carry dead loads (D) and live loads (L). The selected beam size is W 18x50. 1) Based on 0.3Fy allowable stress limit due to dead loads only (D), what will be the maximum D load in psf that can be applied to the beams? Ignore beam weight. 2) Using the D load obtained from Part 1 and based on 0.6Fy allowable stress limit due to combined dead loads and live loads, what will be the maximum live load L in psf that can be applied to the beams? 3) If the maximum mid span deflection due to live loads (L) is L/360 ( or 1.0 in in this case), what will be the maximum L load in psf that can be applied to the beams?