
Review. Two boys are sliding toward each other on a frictionless, ice-covered parking lot. Jacob, mass 45.0 kg, is gliding to the right at 8.00 m/s, and Ethan, mass 31.0 kg, is gliding to the left at 11.0 m/s along the same line. When they meet, they grab each other and hang on. (a) What is their velocity immediately thereafter? (b) What fraction of their original kinetic energy is still mechanical energy after their collision? That was so much fun that the boys repeat the collision with the same original velocities, this time moving along parallel lines 1.20 m apart. At closest approach, they lock arms and start rotating about their common center of mass. Model the boys as particles and their arms as a cord that does not stretch. (c) Find the velocity of their center of mass. (d) Find their angular speed. (e) What fraction of their original kinetic energy is still mechanical energy after they link arms? (f) Why are the answers to parts (b) and (e) so different?
(a)

The velocity of Jacob and Ethan immediate thereafter.
Answer to Problem 38AP
The velocity of Jacob and Ethan immediate thereafter is
Explanation of Solution
The mass of Jacob is
The momentum is conserved in the isolated system of two boys then,
Here,
Substitute
Conclusion:
Therefore, the velocity of Jacob and Ethan immediate thereafter is
(b)

The fraction of their original kinetic energy is still mechanical energy after their collision.
Answer to Problem 38AP
The fraction of their original kinetic energy is still mechanical energy after their collision is
Explanation of Solution
The formula to calculate initial kinetic energy of the system is,
Substitute
The formula to calculate final kinetic energy of the system is,
Substitute
The formula to calculate fraction of kinetic energy is,
Conclusion:
Therefore, the fraction of their original kinetic energy is still mechanical energy after their collision is
(c)

The velocity of the centre of mass of Jacob and Ethan.
Answer to Problem 38AP
The velocity of the centre of mass of Jacob and Ethan is
Explanation of Solution
The velocity of the centre of mass of Jacob and Ethan is still remains same as calculated in part (a) because the conservation of momentum calculations will be same as part (a).
Then, the velocity of the centre of mass of Jacob and Ethan is,
Conclusion:
Therefore, the velocity of the centre of mass of Jacob and Ethan is
(d)

The angular speed of Jacob and Ethan.
Answer to Problem 38AP
The angular speed of Jacob and Ethan is
Explanation of Solution
The position of the centre of mass of the boys is,
Substitute
The Jacob is
The angular momentum is,
Substitute
Conclusion:
Therefore, the angular speed of Jacob and Ethan is
(e)

The fraction of their original kinetic energy that is still mechanical energy after they link arms.
Answer to Problem 38AP
The fraction of their original kinetic energy that is still mechanical energy after they link arms is
Explanation of Solution
Refer to the section 1 of part (b), the initial kinetic energy is,
The formula to calculate final kinetic energy of the system is,
Substitute
The fraction of kinetic energy is,
Conclusion:
Therefore, the fraction of their original kinetic energy is still mechanical energy after they link arms is
(f)

The reason for the answer of part (b) and part (e) is so different.
Answer to Problem 38AP
The answer of part (b) and part (e) is so different because the head on collision between similarly sized objects are grossly inefficient.
Explanation of Solution
The deformation is a process in which one form of energy changed into the other form. The head on collision between similarly sized objects are grossly inefficient. So the answers are so different. If the two kids were the same size and had the same velocity; conservation of the momentum states that they lose all their kinetic energy. On the other hand, glancing blows like this one allow a lot of energy to be transferred into the rotational kinetic energy, causing much less energy to be lost on impact.
Conclusion:
Therefore, the answer of part (b) and part (e) is so different because the head on collision between similarly sized objects are grossly inefficient.
Want to see more full solutions like this?
Chapter 11 Solutions
Physics:f/sci.+engrs.,ap Ed.
- You are standing a distance x = 1.75 m away from this mirror. The object you are looking at is y = 0.29 m from the mirror. The angle of incidence is θ = 30°. What is the exact distance from you to the image?arrow_forwardFor each of the actions depicted below, a magnet and/or metal loop moves with velocity v→ (v→ is constant and has the same magnitude in all parts). Determine whether a current is induced in the metal loop. If so, indicate the direction of the current in the loop, either clockwise or counterclockwise when seen from the right of the loop. The axis of the magnet is lined up with the center of the loop. For the action depicted in (Figure 5), indicate the direction of the induced current in the loop (clockwise, counterclockwise or zero, when seen from the right of the loop). I know that the current is clockwise, I just dont understand why. Please fully explain why it's clockwise, Thank youarrow_forwardA planar double pendulum consists of two point masses \[m_1 = 1.00~\mathrm{kg}, \qquad m_2 = 1.00~\mathrm{kg}\]connected by massless, rigid rods of lengths \[L_1 = 1.00~\mathrm{m}, \qquad L_2 = 1.20~\mathrm{m}.\]The upper rod is hinged to a fixed pivot; gravity acts vertically downward with\[g = 9.81~\mathrm{m\,s^{-2}}.\]Define the generalized coordinates \(\theta_1,\theta_2\) as the angles each rod makes with thedownward vertical (positive anticlockwise, measured in radians unless stated otherwise).At \(t=0\) the system is released from rest with \[\theta_1(0)=120^{\circ}, \qquad\theta_2(0)=-10^{\circ}, \qquad\dot{\theta}_1(0)=\dot{\theta}_2(0)=0 .\]Using the exact nonlinear equations of motion (no small-angle or planar-pendulumapproximations) and assuming the rods never stretch or slip, determine the angle\(\theta_2\) at the instant\[t = 10.0~\mathrm{s}.\]Give the result in degrees, in the interval \((-180^{\circ},180^{\circ}]\).arrow_forward
- What are the expected readings of the ammeter and voltmeter for the circuit in the figure below? (R = 5.60 Ω, ΔV = 6.30 V) ammeter I =arrow_forwardsimple diagram to illustrate the setup for each law- coulombs law and biot savart lawarrow_forwardA circular coil with 100 turns and a radius of 0.05 m is placed in a magnetic field that changes at auniform rate from 0.2 T to 0.8 T in 0.1 seconds. The plane of the coil is perpendicular to the field.• Calculate the induced electric field in the coil.• Calculate the current density in the coil given its conductivity σ.arrow_forward
- An L-C circuit has an inductance of 0.410 H and a capacitance of 0.250 nF . During the current oscillations, the maximum current in the inductor is 1.80 A . What is the maximum energy Emax stored in the capacitor at any time during the current oscillations? How many times per second does the capacitor contain the amount of energy found in part A? Please show all steps.arrow_forwardA long, straight wire carries a current of 10 A along what we’ll define to the be x-axis. A square loopin the x-y plane with side length 0.1 m is placed near the wire such that its closest side is parallel tothe wire and 0.05 m away.• Calculate the magnetic flux through the loop using Ampere’s law.arrow_forwardDescribe the motion of a charged particle entering a uniform magnetic field at an angle to the fieldlines. Include a diagram showing the velocity vector, magnetic field lines, and the path of the particle.arrow_forward
- Discuss the differences between the Biot-Savart law and Coulomb’s law in terms of their applicationsand the physical quantities they describe.arrow_forwardExplain why Ampere’s law can be used to find the magnetic field inside a solenoid but not outside.arrow_forward3. An Atwood machine consists of two masses, mA and m B, which are connected by an inelastic cord of negligible mass that passes over a pulley. If the pulley has radius RO and moment of inertia I about its axle, determine the acceleration of the masses mA and m B, and compare to the situation where the moment of inertia of the pulley is ignored. Ignore friction at the axle O. Use angular momentum and torque in this solutionarrow_forward
- Physics for Scientists and Engineers: Foundations...PhysicsISBN:9781133939146Author:Katz, Debora M.Publisher:Cengage LearningPrinciples of Physics: A Calculus-Based TextPhysicsISBN:9781133104261Author:Raymond A. Serway, John W. JewettPublisher:Cengage LearningPhysics for Scientists and Engineers with Modern ...PhysicsISBN:9781337553292Author:Raymond A. Serway, John W. JewettPublisher:Cengage Learning
- College PhysicsPhysicsISBN:9781305952300Author:Raymond A. Serway, Chris VuillePublisher:Cengage LearningUniversity Physics Volume 1PhysicsISBN:9781938168277Author:William Moebs, Samuel J. Ling, Jeff SannyPublisher:OpenStax - Rice UniversityClassical Dynamics of Particles and SystemsPhysicsISBN:9780534408961Author:Stephen T. Thornton, Jerry B. MarionPublisher:Cengage Learning





