In an ICPMS instrument, the interface between the ICP torch and mass spectrometer needs to be explained. Concept introduction: ICPMS processes the analytical work only after ionizing the sample. This is done by the ICP torch. The ICP has the necessary interface with other parts/operations of the mass spectrometer.

Question

Don't used hand raiting

Answer 1

Question

Chapter 11, Problem 11.6QAP

Interpretation Introduction

Interpretation:

In an ICPMS instrument, the interface between the ICP torch and mass spectrometer needs to be explained.

Concept introduction:

ICPMS processes the analytical work only after ionizing the sample. This is done by the ICP torch. The ICP has the necessary interface with other parts/operations of the mass spectrometer.

Expert Solution & Answer

Trending nowThis is a popular solution!

See solution

Check out sample textbook solution

Students have asked these similar questions

Don't used hand raiting

at 32.0 °C? What is the osmotic pressure (in atm) of a 1.46 M aqueous solution of urea [(NH2), CO] at 3 Round your answer to 3 significant digits.

Reagan is doing an atomic absorption experiment that requires a set of zinc standards in the 0.4-1.6 ppm range. A 1000 ppm Zn solution was prepared by dissolving the necessary amount of solid Zn(NO3)2 in water. The standards can be prepared by diluting the 1000 ppm Zn solution. Table 1 shows one possible set of serial dilutions (stepwise dilution of a solution) that Reagan could perform to make the necessary standards. Solution A was prepared by diluting 5.00 ml of the 1000 ppm Zn standard to 50.00 ml. Solutions C-E are called "calibration standards" because they will be used to calibrate the atomic absorption spectrometer. a. Compare the solution concentrations expressed as ppm Zn and ppm Zn(NO3)2. Compare the concentrations expressed as M Zn and M Zn(NO3)2 - Which units allow easy conversion between chemical species (e.g. Zn and Zn(NO3)2)? - Which units express concentrations in numbers with easily expressed magnitudes? - Suppose you have an analyte for which you don't know the molar…