ZL=200<-45° Ohm What is the Zab impedance?

Q: Obtain the form factor of a half rectified sinewave mm sine kn -ot

A:

Q: A complex number is represented as Z=4+j3 ohm. What will be magnitude and phase of this complex…

A: For any complex number, C=A+jB, the magnitude and phase of the complex number can be expressed as

Q: A 100nF capacitor and a resistor are connected in series with a function generator. If the supply…

A: Given RC series circuit shown    Capacitor c=100 nFSupply voltage vs=10∠-46.7° v frequency f=1 kHz…

Q: Impedances Z1 connected in series. Express the total impedance in polar coordinates. (Please check…

A:

Q: HW Ithe Cilof previsusHw)is :- uwounded by auniform field o.6axto.udy t'0.5aZ ub/m2 O find the…

A: Given :Area of the coil, A=10 cm2=10x10-4 m2 Current in the loop, I=50 AThe uniform magnetic field,…

Q: Q10. In a transformer modeling, the value of the impedance referred to primary side is N/N2 P* Z2…

A:

Q: Impedances Z1=5.83<-59 and Z2=8.94<63.43 are in series and carry and effective current of 5.0 A.…

A:

Q: Determine the total impedance. elb j4n

A: According to the question we have to calculate the value of total impedance ZT.

Q: Three impedances, Z1 =10020•2, Z2 =63.25418.43•Qand Z3 =1002-90•N are connected in star. Convert the…

A:

Q: Using Rouths Stabilty criteria determine if the system with characteristic equation s+8s+…

A: in the RH criteria if the sign is changed in the first row then the system is called as the unstable…

Q: For the power electronics circuit shown; a) Draw the waveforms of V.. b) Find the conduction angle…

A: Given circuit is Half wave rectifier with LE load   to plot output voltage when Vs=100 sin 120πt

Q: cirwitshown sipnal plus noue forthe 9) Determine Heoulput below . Assume that the urwit is operetinp…

A: An Op-Amp (operational amplifier) is an integrated electronic circuit that is used to amplify weak…

Q: 5. 15cis60+35cis210

A: It is given that: I=15cos60°+35cos210°

Q: Kr=0.31+jo.31 and Zo=50 Using the law below find the Value of Zv Zr Kr= Zr-20 Zr + Zo

A: We need to find out the value of load resistor for given reflection coefficient

Q: • 1. Determine the equivalent impedance and the equivalent admittance. Zeq -jion 1202 jisa M 652 :8…

A:

Q: i, = 3 sin(377t + 60°) R1.2 N XL 1.20 Ω Χ. 20 Xc

A: The solution is given below

Q: From the data obtained in steps 6, 12 and 18, draw the voltage phasor diagram. 6- Using the digital…

A:

Q: An alternahng with a value f 16 A. uns tantaneous value eand find fugueney . 50HZ U has an ms Wsuite…

A: (5) f=50 HzIrms=10 A

Q: 3) Given the circuit with an AC sinusoidal current source and an AC sinusoidal voltage source: ZR1…

A:

Q: Please show complete solutioj. Final answer must contain 3 decimals only. Last 30 minutes left Thank…

A:

Q: During fast decoupled Method load flow analysis in one of the loads the calculated reactive power…

A: The power system analysis has non linear equations of power. The equations are  involving voltage…

Q: the shunt capacitance is a capacitor O a. Between a phase and the ground O b. between phases and a…

A: In this question,   We need to choose the correct options What is shunt capacitance is a capacitor?…

Q: Referring o figure shown below, determine the total impedance at point a and b. 42-90°0 2430°0

A:

Q: CONVERT THE GIVEN COMPLEX NUMBERS: 1. A = 6+ 7i POLAR FORM 2. B = 5230 → RECTANGULAR FORM 3. C = 15…

A:

Q: Impedances Z1=5.83<-59 and Z2=8.94<63.43 are in series and carry and effective current of 5.0 A.…

A:

Q: Evaluate 8/10° +62-20° 9280°-4250° O 0.50 +j2.24 O -0.50-12.24 O 50-j224 O -50-j224 and express the…

A:

Q: Find the current through the capacitor of (-j5) capacitance reactance using NODAL ANALYSIS. Current…

A:

Q: Explain why the phasor and the impedance have the same angle

A:

Q: 図2j20 J122 201 Zs 25 10-jloSL 回a 回 ZE 248-j6 CALGULATE (A) THE TOTAL IMPEDANGE, (B) THE GURRENT Z3…

A:

Q: Find 1 and 12 in the given circuit. Please report your answer so the magnitude is positive and all…

A: The current through both sides of the circuit needs to be calculated. The impact on the primary due…

Q: İR İL ic is (1 R = 1,2Ω XL =D 2Ω Xc = 5Ω +

A: NOTE :-  As per our company policy, only FIRST 3 sub-parts of the Question at a time, so only Q.(a),…

Q: Given Zc - j339 , R₁ = 414 , RL = 12420 2 and a=0.24, what is the magnitude of the source voltage Vs…

A:

Q: ational speed w can be adju esponse @) when increment

A:

Q: Q2:If the carrier frequency 1000hz and reference voltage =10 V with modulation Index 0.4 and…

A: Brief description : For the above given amplitude modulation system we need to calculate output…

Q: Q q:- Cal culate An-s !. 5Z_y Ųrms if V £t): So+Yo Sin wt

A:

Q: (2) 1435 2014 220 50 S 50HZ For the circull shown find ZR,ZL, ZI T VR, VL, VC

A:

Q: The Full-load and No-load of a regulator are 5.2V and 5.3V, respectively. Then the % load regulation…

A:

Q: The wave power per length is 1740 W/m, the device-width of the wave energy system is 5.1 m, the…

A:

Q: 5A rms /60Hz L1 100mH L2 www. 150mH C1 = 2.2μF 2 + 10V rms 60Hz + R1 V 1kQ 1

A:

Q: Two impedances, Z1 = 2+j6 Q and Z2 = 6-j12 0 are connected in series with a 220-V 60-Hz supply. At…

A: In this question, choose the correct option  What is frequency if both impedance is connected in…

Q: 1.) Griven the pole and zoro configuration. below. Draw the root-loans diagram. S-plane ojiz jro…

A: According to the question, for the given pole-zero diagram as shown below We need to draw the root…

Q: ww a totu r o .20 A load consists of a resistance connected in parallel with a capacitive reactance…

A: power dissipated in load resistor = Voltage across load2resistance. reactive power supplied by…

Q: Impedances Z1=5.83<-59 and Z2=8.94<63.43 are in series and carry and effective current of 5.0 A.…

A: Here we deal with the concept related to the AC circuit &amp; reactive power.

Q: mpedances Z1=5.83<-59 and Z2=8.94<63.43 are in series and carry and effective current of 5.0 A.…

A:

Q: SUNB Desian aproblem for wge delta transformations Dterminc the eauivalend resistance betreen the…

A: In this question , we have to find out equivalent resistance across A and B..

Norton Theorem

In the current circuit law, the Norton theorem (also known as the Mayer-Norton theorem) is a simplification that can be applied to networks generated by a constant line of opposition, power sources, and current assets. In two network terminals, it can be switched on with a current supply and single resistor respectively.