You want to investigate voltage, V, induced in a coil due to motion of the magnet. A setup is shown in the figure. You want to test all the possible parameters and create a model equation of V. Which are the possible components you should be testing? Choose all reasonable components

You want to investigate voltage, V, induced in a coil due to motion of the magnet. A setup is shown in the figure. You want to test all the possible parameters and create a model equation of V. Which are the possible components you should be testing? Choose all reasonable components

College Physics

11th Edition

ISBN:9781305952300

Author:Raymond A. Serway, Chris Vuille

Publisher:Raymond A. Serway, Chris Vuille

Chapter1: Units, Trigonometry. And Vectors

Section: Chapter Questions

Problem 1CQ: Estimate the order of magnitude of the length, in meters, of each of the following; (a) a mouse, (b)...

See similar textbooks

Similar questions

The rod shown below moves to the right on essentially zero-resistance rails at a speed of v = 3.0 m/s. If B = 0.75 T everywhere in the region, what is the current through the 5.0-Ω resistor? Does the current circulate clockwise or counterclockwise?
A generator has a 46-turn coil with an area of 0.07 m2 that turns at 25.0 rad/s in a 0.48 T magnetic field. What is the current through the coil when the normal to the coil makes an angle of 30o with the magnetic field? The resistance in the coil is 7.84 Ohms. Give your answer in Amperes.
Refer to the figure below. What is the emf induced when a 6.61-cm conducting rod attached to a U-shaped conductor moves at 1.96 m/s perpendicular to a magnetic field of strength 14 T? Please write the numeric answer in terms of V (volts). Normal format with 3 SF. - AA B (outward) vAt
The problem below explores the basic principle behind electric motors, which we will discuss in class in detail. A rectangular loop of wire consists of 163 closely wound turns. The height of the coil is H=7.76m and the width of the coil is W=7.69m. A current of I=6.62A flows through the coil as indicated. One of the sides of the coil is attached to a vertical hinge and free to rotate around the z axis. A magnetic field of 5.03T is applied horizontally at 30 degree angle to the plane of the coil. What is the size of the torque acting on the coil in N.m?
A circuit is set up as the figure below. . (a) Find current I₁ and I2. (b) If the 3 resistor is a heater and is heating a cup of 30 g of water and 10 g of ice that is originally at 0°C. What would be the final temperature of the water after 30 minutes? (c) Draw two arrows at location P to show the direction of magnetic field due to Wirel and Wire2, respectively. 18 V L 4Ω M 202 12 02 P 1₁ AAA 1Ω Wire1 Wire2 3Ω
You want to investigate the voltage, V, induced in a coil due to motion of the magnet. A setup is shown in the figure. You want to test all the possible parameters and create a model equation of V. Which of the following equations are the possible candidate models for investigation based on educated guess? Choose all that apply voltage in N S In the listed model, n is number of turns in the coil; r is radius of the coil; B is strength of magnet; t is the time of motion of the magnet; 0 is the angle of the magnet Ov = nBr²e t V = n Br²V0 None in the list V = nBVr²0 12
The sketches below show a circular coil and a permanent magnet; the arrows indicate both the magnitude and the direction of the velocities of the magnet and coil. Select all the true statements. If no statements are true, select "None of the above." A. The induced voltage in A is zero.B. The induced voltage in F is non-zero.C. The induced voltage in D is zero.D. The induced voltage in C is non-zero.E. The induced voltage in E is zero.F. The induced voltage in B is zero.G. The induced voltage in G is non-zero.H. None of the above. I keep thinking that the correct statements are B. C. D. but I keep getting the question wrong.
A magnet and a coil are oriented as shown. The magnet is moved rapidly into the coil, held stationary in the coil for a short time, and then rapidly pulled back out of the coil. Sketch a graph showing the reading of the ammeter as a function of time. The ammeter registers a positive value when current goes into the " +" terminal.
A large power plant generates electricity at 12.0 kV. Its old transformer once converted the voltage to 315 kV. The secondary coil of this transformer is being replaced so that its output can be 725 kV for more efficient cross-country transmission on upgraded transmission lines. V1 = 315 kVV2 = 725 kV What is the ratio of turns in the new secondary to the number of turns in the old secondary? What is the ratio of new current output to the old current output for the same power input to the transformer? If the upgraded transmission lines have the same resistance as the original ones, what is the ratio of new line power loss to the old?
50. A paramagnetic substance, in an external magnetic field, is thermally isolated. The field is then removed. As a result: A. the magnetic energy of the magnetic dipoles decreases В. the temperature of the substance increases C. the magnetization decreases, but only slightly D. the magnetization reverses direction E. none of the above ans: E
There are a lot of numbers in this problem. Just about the only way to get it right is to work out each step symbolically first, and then plug numbers into the final symbolic result. Two coils of wire are aligned with their axes along the z-axis, as shown in the diagram. Coil 1 is connected to a power supply and conventional current flows clockwise through coil 1, as seen from the location of coil 2. Coil 2 is connected to a voltmeter. The distance between the centers of the coils is 0.18 m. Coil 1 has N1 = 540 turns of wire, and its radius is R1 = 0.09 m. The current through coil 1 is changing with time. At t=0 s, the current through coil 1 is Io = 18 A. At t=0.4 s, the current through coil 1 is Io.4 = 6 A. Coil 2 has N2 250 turns of wire, and its radius is R2 0.03 m. Inside coil 2, what is the direction of -dB/dt during this interval? ---Select--- What is the direction of the electric field inside the wire of coil 2, at a location on the top of coil 2? ---Select--- At time t=0, what…
A circuit is made with a resistor of resistance 25 ohms and a movable bar with length 15 cm moving to the left with speed 8 m/s. The whole circuit is in a magnetic field B = 1.5 T (into page). Use this set up to answer the following questions. What is the current through the resistor in amps? Answer to 3 decimal places.