You have a garden that is 125’ x 125’ and are setting up a sprinkler system for irrigation. Each sprinkler can cover 1000 ft2 and uses 3.0 GPM. The flow rate of your water source is 14 GPM. How many zones will be required to irrigate this area? a. 2 b. 3 c. 4 d. 5

You have a garden that is 125’ x 125’ and are setting up a sprinkler system for irrigation. Each sprinkler can cover 1000 ft2 and uses 3.0 GPM. The flow rate of your water source is 14 GPM. How many zones will be required to irrigate this area? a. 2 b. 3 c. 4 d. 5

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Related questions

Q: Surface irrigation is the oldest irrigation method, therefore it is always the least efficient…

A: Surface irrigation Answer is True Surface irrigation is the oldest irrigation method and it…

Q: Describe any other conceivable elements that influence energy loss in open channel flow.

A: Following are the conceivable elements that influence energy loss: 1) Material : Rougher is the bed…

Q: The Stormwater Control Measure (SCM) behind McMichael Science Center is 140ft long, 50ft wide, and…

A: Given data, Dimensions of sto control measure Length L = 140 feet Width W = 50 feet Depth H = 3 feet…

Q: Write an essay about how prolonged low-intensity rainfall will affect the Generation of overland…

A: Low intensity rainfall depends on the duration of the period for which the rainfall happened.Because…

Q: which of the following information can be used to measure the Uniformity of Irrigation? Infiltration…

A: The distribution uniformity is expressed in percentage which is given by taking the ratio of average…

Q: For irrigated areas calculate the drain spacing for a falling water table assuming the hydraulic…

Q: Determine the design discharge capacity of a solid set sprinkler system to irrigate 1.62 hectares…

A: Given: The area to be irrigated is 1.62 ha. The sprinkler operated time is 10 hr. The field capacity…

Q: A boiler feed booster pump supplies 0.0373 m3 /s of water at 1500 rpm. Its suction speed is 3.5 and…

A: Given, Q= 0.0373 m3 /s N= 1500 rpm. net positive suction head NPSHa=5m. Nss=3.5

Q: The annual demand is 600 550 *Observed inflow adjusted for evaporation and required reieases for…

Q: Question 5 Show the 10-yr, 15-min, constant-intensity design storm for a watershed in Baltimore.…

A: A constant design storm represents the rainfall intensity of a particular location. The design storm…

Q: Given an evapotranspiration rate of 5 mm day-1, what is the corresponding amount of water lost to…

A: Rate of evapotranspiration = 5 mm/day area of land = A = 5× 104 number of hour in water lost = 60…

Q: Use the rainfall data below to determine the o index for the watershed if the runoff depth was 8.2…

Q: If the ratio between the length of the tape to its width is 45, the number of tapes used to irrigate…

A: Given that, LB=45 The number of tapes used to irrigate the field is N=300. The irrigation time per…

Q: A 6 stories building was constructed for an engineering company. The building is an ordinary type…

A: Determine, Maximum rate and total demand for both fire demand and domastic.

Q: 4. Determine the diameter of a water main to serve a residential area, assuming (a) average water…

A: Solution: Coincident draft = Maximum daily draft + free draft Maximum daily draft: =1.8×average…

Q: The catchment area of a sewer is 50 hectares. Estimate the storm water flow corresponding to…

A: Catchment area = 50 hec Rainfall = 40 mm Time concentration = 30 min Impervious area = 55%

Q: In a wheat growing area, the cultivable land is 200 acres and wheat will be cultivated to all of the…

Q: HYDROLOGY AND DRAINAGE: For a RE-development that has 3 acres Managed Turf and 3 acres Impervious…

A: In the planning and construction of hydraulic structures, hydrology is essential. In city water…

Q: A canal supplies water to an area growing wheat over 100 hectares. The duration between the first…

A: Given data- Area A=100 ha, Time period B2=120 days, Total depth of water ∆2=35 cm, kor depth- ∆1=12…

Q: 1. Design a sanitary sewer made up of a pre-cast concrete for Town “A", having a population of…

A: Water consumption = Population x Consumption Water consumption = 120000×65⇒Water consumption…

Q: Q3/ How many emitters, laterals and Manifolds needed to irrigate (100 m*100 m) coff field with drip…

A: To determine the number of emitters, laterals, and manifolds needed to irrigate a 100m x 100m corn…

Q: If the irrigation efficiency is 80%, conveyance losses are 20% and the actual depth of the watering…

A: Irrigation efficiency-To Find-The depth of water required at the canal outlet (D).

Q: Show all possible water balance components (all express in equivalent depth of water) for a potted…

A: For a potted plant with holes at the bottom of the container placed in an open field, the water…

Q: 4. Determine the diameter of a water main to serve a residential area, assuming (a) average water…

A: Given :

Q: Ex 12-5: Farm is irrigated with irrigation interval 8 days, leaching depth in one irrigation 2.5 cm,…

Q: 2a) Design a drain field layout with an application rate of: a.) 1.5 gallons/square foot/day b.)…

A: Note: As the population is not mentioned the design is done per million population Water requirement…

Q: A Motel with toilet, bath and kitchen facilities is to serve a maximum of 300 persons. Determine the…

A: “Since you have asked multiple question, we will solve the first question for you. If you want any…

Q: As a site development engineer, you are considering the drainage for a shopping complex with 1 acre…

A: Paved parking area: 1 acresSidewalk area: 0.3 acresLandscaping area: 0.5 acres

Q: Determine the flow required for a residential area consisting of homes of ordinary construction,…

A: Given: An area consisting of homes of ordinary construction 2505 ft2 ,10 ft apart and 13 storey wood…

Q: What happens to actual rate of infiltration if rainfall intensity is less than the infiltration…

Q: If the ratio between the length of the tape to its width is 45, the number of tapes used to irrigate…

A: The design flow rate is the flow rate for which the hydro turbine is designed. The flow rate at…

Q: Problem-8, What is the work done by a 1 kN of water jet moving with a velocity of 60 m/sec when it…

A: Given- Force F = 1 kN, Velocity of the jet V=60 m/s, Velocity of the vane u = 9 m/s, It is needed…

Q: Q2/ How many emitters,laterals and Manifolds needed to irrigate (100 m*100 m) corn field with drip…

A: To design the drip irrigation system for a 100m x 100m corn field, we need to determine the number…

Q: A water treatment plant is designed to treat 1 m³/s of raw water. It has 14 sand filters. Surface…

A: Given- Discharge Q=1 m3/s, 14 sand filters, Surface area SA=50 m2, 2 filters out of service,

Q: An outlet irrigates an area of 20 ha. The discharge (1/s) required at this outlet to meet the…

A: Area = 20 ha. Evapotranspiration requirement = 20 mm Time= 20 days It is needed to find the…

Q: Q.2. A four-story wooden-frame building has each floor of area (510 m²). This wooden building is…

Concept explainers

Probability, risk and uncertainty analysis for hydrological design

It gives a framework that is financially critical for finding the exceptional designs of hydrological systems with a reduced cost in total inclusive of the project cost and the disaster mitigation cost. But there would be hardly any assessment of a decent quality damage function. Hence, errors in demonstrating the hydrologic events, incorrect model parameters, and so on may occur. Here, we will discuss a specific hydrological design that of a detention basin for studying and understanding the risk-based procedure, uncertainties, and probability analysis by following a systematic framework.

Question

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1: Calculation of total flow rate required by the sprinklers

VIEW

Step 2: Calculation of number of zones required to irrigate this area

VIEW

Solution

VIEW

Step by step

Solved in 3 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Probability, risk and uncertainty analysis for hydrological design

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

An outlet irrigates an area of 20 ha. Find the discharge required at this outlet to meet the evapotranspiration requirement of 20 mm occuring uniformly in 20 days. Neglect other kind of losses.
4-Calculate the amount of rain falling (storm water) on a water shed area, if you know the following: 1- Inlet time of flow = 6 min. 2- Travel (flow) time =7 min. 3- Runoff coefficient = 0.40 4- Water shed area = 10 ha.
Find the time required to irrigate a strip of an area of (120 X 15) m² by a stream of discharge of 40 liter/sec with an average depth of water to be applied of 10 cm and an average rate of infiltration of 0.833 mm/min. is:
b) Looking into the future with mean temperature levels exceeding 2.50C above pre-industrial levels it is considered that the maximum size of the water drain pipe would increase by 4m3/second every decade . Provide a table of expected maximum drain loads over a period from 2030 to 2130 and plot this on a graph. You are advised to plot the maximum expected rainfall against pipe diameter.
A Palm Spring golf course has requested a permit to install a 40000 ft2 pond to enhance the beauty of its facilities. Since the evaporation rates are very high in Palm Springs, it is likely they will need to pump a lot of groundwater to keep the pond full. The city has hired you (a water resources engineer) to determine how much water needs to be pumped per year in order to keep the pond filled. There is a small creek that discharges an average of 0.25 m3/s into the pond. The outlet valve from the pond releases an average rate of 0.30 m3/s (to keep the pond from getting stagnant). Precipitation on the pond is 260 mm/year, and the annual evaporation is estimated to be 105 inches/year. The pond will be lined with concrete to prevent any drainage or seepage from the bottom. Using a water balance, what volume (on average) of groundwater (in cubic meters) must be added to the lake each year to keep the pond at a constant level? Draw a schematic of the problem to identify the control volume…
A 100-year storm occurs in Northern Nevada. You wish to find the precipitation and infiltration rate that occurs at the local duck pond over the course of the 1-day storm. In the city records, the area of the duck pond is 10 ft2. The local parks department reports that the evaporation for the pond was 48 inches and the runoff from the pond is 3 feet. The reported change in storage was found to be 0.5 feet. Draw the duck pond system and label each of the elements used in the balance. Find the precipitation (ft) that occurred during the 1-day storm. Determine the infiltration rate (ft/hr.) over the duration of the 1-day storm.
a reservoir has been built 4 km away from a farm having a water requirement of 100m3/day And half of dsily supply id pumped within 10 hours. hf is 20m. calculate the size of supply main
determine The input power requirement of a pump running at an efficiency of 75 %. The NPSH available.
Along a day, precipitation is monitored four times with equal time intervals. The recorded data were 10, 12, 16, 8 mm for a catchment has an area of 3000m2. If the measured runoff in this day was 90m3, the infiltration rate is equal to
PLS ANSWER ASAP THANKS!
I need answer. Please avoid handwritten solution
19. A building roof contains 15000 square foots, of horizontal project area. If design is based on a (4 in /hr) rainfall intensity. How many (6 in ) diameter roof drain would be required? One Leader O Two Leader O Three Leader O No Leader