You are given a 1 M MgSO4 solution and a 0.5 M EDTA solution. Calculate how to make a 250 mL solution containing 25 mM MgSO4 and 1 mM EDTA. List the amounts of all components including water. Note: this involves two separate calculations, doing one at a time. Calculate the MgSO4 without considering the EDTA, then do the opposite. Subtract these volumes from the final volume to determine the amount of water to use.   MgSO4 EDTA Water

Q: a U W . . Titration Curve The chemist making the pH curve above added bromothymol blue to the sample…

A: Visual indicators are the compounds, usually weak acids that change color with pH. These are used to…

Q: 11.The pKa of a weak acid was determined by measuring the pH of a solution containing the weak acid…

A:

Q: The titration on the right was performed by placing 10.00 mL solution in an Erlenmeyer flask and…

A: The above questions is titration of  a solution with 0.1M HCl.

Q: An unknown Ca solution was prepared by weighing a 2.122 g sample, dissolving it in HCl and then…

A:

Q: A chemist is given a piece of limestone and told that 50.00% of the sample exists as calcium oxide…

A: EDTA forms 1:1 complex with Ca+2.The balanced equation is     Ca+2 + EDTA–4 ------->…

Q: How much 0.0500 M EDTA is needed to titrate the Mg and Ca in a 0.2385-g sample that is 92.5%…

A: Given,  Molarity of EDTA = 0.0500 M  Mass of the sample = 0.2385 g  Mass percent of dolomite = 92.5%…

Q: When doing a titration, it is helpful to know approximately the volume of titrant that will be…

A: The equation to calculate the unknown value from known value is given by, M1V1=M2V2 where M is the…

Q: In the titration of 25.00 mL of a water sample, it took 20.690 mL of 4.050x 10−3 M EDTA solution to…

A: Number of moles of EDTA is determined as follows,

Q: A buffer solution containing 0.403 M hypochlorous acid and 0.360 M of the conjugate base,…

A: The objective of this question is to calculate the pH of a buffer solution. The buffer solution is…

Q: 10. 10 mL of a river water sample containing an unknown concentration of Cu2+ is titrated with 0.1…

A: We’ll answer the first question since the exact one wasn’t specified. Please submit a new question…

Q: Unlike propanoic acid, magnesium hydroxide, Mg(OH)2 does not dissolve well in water.  The Ksp of…

A:

Q: This question has two parts. a. Calculate the pH of the solution resulting from the addition of 15.0…

A: First, we need to calculate the moles of HCl and aniline. The number of moles is calculated by…

Q: If a 35.0-mL water sample required 10.25 mL of 0.0150 M EDTA solution to reach equivalence point,…

A:

Q: You titrate 50.00 mL of hard water with 14.86 mL of 0.0100 M EDTA solution. How many moles of Ca²+…

A:

Q: If it takes 12.24 mL of 1.0 M HCl solution to titrate 5.0 mL of saturated borax solution, what is…

A: Given data, 5.0 mL saturated solution of borax is titrated with 12.24 mL of 1.0 (M) HCl solution. We…

Q: You are asked to determine the amounts of calcium ion in a 200 mL water sample using EDTA to titrate…

A: The equation representing titration of Ca2+ ion with EDTA:Ca2+ (aq) + EDTA4- (aq)  Ca(EDTA)2- (aq)

Q: 6.00 mL of 0.0100 M EDTA is mixed with 5.00 mL of 0.0100 M Ca2+. The pH is adjusted to 10 and DI…

A:

Q: Based on the graph below, 1. molar concentration of HCO3- 2. alkalinity in ppm CaCO3

A: Step1: Here, the HCl is added to CaCO3. So, the reaction will be shown as Here, CaCO3 and HCl react…

Q: 3. A 100 mL sample of hard water is titrated with 22.4 mL of the EDTA solution from problem 2. The…

A: Its given as

Q: procedure on how to make this solution

A: In the given question we have to describe the procedure of how the given elution buffer is…

Q: You are asked to determine the amounts of calcium ion in a 200 mL water sample using EDTA to titrate…

A: The equation representing titration of Ca2+ ion with EDTA: Ca2+ (aq) + EDTA4- (aq) → Ca(EDTA)2- (aq)

Q: At room temperature, how would you expect the solubility of AgCl in deionized water to compare to…

A: Given: AgCl in deionized water and AgCl in 0.10 M NaCl. Since AgCl is an insoluble salt. Hence it…

Q: If 150 ml of 0.50M HCIO, was required to complete an alkalinity test on 100 ml of water sampled from…

A: