I need the answer as soon as possible A common analogy used to describe the different types of power in AC circuits is a mug ofbeer that also contains foam:MugFoamBeerExplain this analogy, relating the quantities of beer and foam to the different types of powerin an AC circuit, and also why this analogy is often employed to describe the "desirability" ofeach power type in a circuit.

It is being given that a mug of beer and this analogy needs to be explained.

xplain this analogy, relating the quantities of beer and foam to the different types of power n an AC circuit, and also why this analogy is often employed to describe the "desirability" of -ach power type in a circuit.

xplain this analogy, relating the quantities of beer and foam to the different types of power n an AC circuit, and also why this analogy is often employed to describe the "desirability" of -ach power type in a circuit.

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter4: Transmission Line Parameters

Section: Chapter Questions

Problem 4.8MCQ: An ac resistance is higher than a dc resistance. True False

See similar textbooks

Related questions

Q: Design base resistor bias circuit for a CE amplifier such that operating point is VCE = 8V and Ic= 2…

A: Note: Here, To design base resistor for CE amplifier only question is considered .

Q: 1.7)The armature of a 4-pole de machine rotates at 840 rpm .The armature length and diameter are 40…

A: The answer to the above problem is provided below. Hope it helps.

Q: Obtain the closed-loop pulse transfer function (G(2)=C(=)/R(=)) of the following system. Ris) Els)…

A: Circuit is given as,

Q: O Find the conualution bdween xLE) and hit 수 h(e) at 94 yt)=D+ htt) the find yCW}>check the result…

A: In this question, Find the convolution of the given signals using the convolution property. We…

Q: Power Spectral Density (PSD) of a er a. can never be zero

A: Power Spectral Density : The power spectral density of the signal described the power present in…

Q: Ex:- a- find the general from of the equation for the stream lines of the field E = 10 xy āx +5x2ay…

A: GivenE¯=10xya¯x+5x2a¯y

Q: Plot the root loci for closed-loop control system whose open-loop transfer function is GH(s) =…

A: In the question, Draw the root locus for the closed loop system. Open loop transfer function is…

Q: Q10/ For the PNP transistor circuit below, it is known that Rp = 130 k2, VE = 2 V and VEB = 0.7 V.…

Q: 1) Determine the complex exponential Fourier transform for the following periodic signal shown. i)…

A: Both the question are independent so as per our company guidelines we are supposed to answer only…

Q: [Q3] Choose appropriate values for this Sallen-Key high-pass filter circuit to give it a cutoff…

Q: 1: For the network of figure termine Z, ,Z, Av, and A; by using the complete hybrid equivalent model…

Q: 13) You plan to use lateral spacing of 5 feet and emitter spacing (on the laterals) of 2 feet. If…

Q: Q1/ A narrowband FM signal has a carrier frequency of 90 kHz and a deviation ratio of 0.05. The…

A: Narrowband FM signals are commonly utilised in walkie-talkies and other low-cost two-way radio…

Q: For the circuit shown, find the operating point assume ß = 45 Rc1.2 k2 Ic Cc Cin V BE. 100 kn Rg…

Q: Whats the maximam numper that can be represented by 10 digit decimal number and 10 digit binury…

A: As we know that maximum single digit decimal number is (9)10 which is 1 less than 101. Similarly…

Q: Q11-250 V d.c. Shunt motor has an armature current of 20A when running at 1000 r.p.m at full load.…

A: DC Shunt Motor Flux should be taken as constant until any magnetization or demagnetization is not…

Q: Determine the gate output shown in figure (b) for the input waveforms in figure (a) and draw the…

Q: We met at the restaurant 8pm." in on O at Other: She left London. the 4th of March. * in on at

A: In the given questions we have to fill the Blanks by correct preposition. In, on, at , etc

Q: Calculate the total charge internal the volume 0<ps2,0 <¢ <T/2 and 0 <z<3 if the charge density is…

A: 3. It is given that: 0≤ρ≤20≤φ≤π20≤z≤3charge density=ρ=4xyz

Q: • The message signal m(t) =a cos(2nf t)is used to either FM or PM for the carrier A, cos(27f t).…

Q: B. For the circuit shown in the figure below, the delays of XOR gates, multiplexers and AND gates…

A: Given, the propagation delay of AND gate is 2 nS, XOR gate is 4 nS and MUX is 1 nS. All the inputs…

Q: 1/ The self-inductance of a coil whose number of turns is 500=N, has a measure of L=0.25H. If 60% of…

Q: How to derive the coefficients for high frequency coaxial cable R. L. C. G

Q: QI The magnetic field intensity is given in square region 0.5 < x<1, z-0, 1<y<1.5 by H =z2 ax + x3…

A: As per our company guidelines we are supposed to answer only first 3 subpart kindly repost other…

Q: If a person wants to reach for book on the table, closed loop system can be represented as in Fig.…

Q: Find the time constant for the RC circuit in Fig. 7.81. 7.2 120 2 122 ww s0 V 80 2 0.5 mF Figure…

Q: 1. Design the transistor inverter of Fig. 11-4 to operate with a saturation current of 8 mA using a…

A: A transistor is an electrical signal amplifier or switch that is made of silicon.. In today's…

Q: A 2000/5 A CT has 28.45 cm2 and secondary resistance 0.31 ohm .The maximum primary current for the…

A: 1- The given values are The ratio of primary and secondary current of a CT is 2000/5 A Secondary…

Q: Question 6 a) Obtain the transfer function for the block diagram shown, by using the signal flow…

Q: Q.2 Determine Rrand / for the following network of Fig.2. ch P- 30v- B3 102 10 4 612 Fig.2 R1

Q: Suppose the two capacitors in the example above are connected in series (instead of parallel). What…

Q: 1- If the voltage VIN shown below was applied to ADC circuit. Determine the digital outputs (D2 D1…

Concept explainers

Coulomb’s Law

Coulomb's law states that the attraction or repulsion force between two charged things is proportional to the product of their charges and inversely proportional to the square of their distance. It has an effect along the line that connects the two-point charges.

Question

I need the answer as soon as possible

A common analogy used to describe the different types of power in AC circuits is a mug of
beer that also contains foam:
Mug
Foam
Beer
Explain this analogy, relating the quantities of beer and foam to the different types of power
in an AC circuit, and also why this analogy is often employed to describe the "desirability" of
each power type in a circuit.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 3 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Do we have a nonideal AC voltage source which means there is a resistance in it or only do we have a nonideal DC source?
What will happen to the value of the impedance if the resistance will be increased or decreased? Explain...
An AC circuit is shown in the diagram. The source of emf has a peak voltage of 9.00 V and a frequency of 60.0 Hz. Assume the wires contribute a negligible amount to the resistance and the AC source has negligible internal resistance. 524 2 493 2 1.56 k2 a) Find the equivalent resistance of the circuit. Redraw the circuit showing the equivalent resistor and use this simplified circuit for the rest of the problem. 315 2 Re = b) Find the rms current. 9.00 V, 60.0 Hz c) If the current is zero at time t= 0, find the first two times (after time t-0) that the current is equal to its rms value. and d) Find the average power dissipated by the circuit.
Chose the suitable choice
What are the characteristics of an excellent DC power source? Give 3 and explain.
Derive the formula and relation for voltage and current in a pure resistive- AC circuit and prove that in this type of circuit, the current and the voltage are always in phase.
Describe the general procedures to apply Thevenin’s theorem and Norton's theorem to both DC and AC circuits.
2. Give at least 3 advantages of AC to DC and 3 disadvantages of AC to DC.
A circuit consists of an AC voltage source, a 10-ohm resistor, and a capacitor, all connected in series. The magnitude of the impedance of the capacitor is also 10 ohms. Which of the following is true about the source voltage and the current through the circuit? a. Insufficient information is given. b. The source voltage will lag the current. c. The source voltage will lead the current. d. The source voltage will be in-phase with the current.
Exercise 2: Resistances connected in Series-Parallel across a Sinusoidal AC Supply Calculate the following: a) Calculate the peak to peak voltage (Vpk-pk) and peak to peak current (I pk-pk) b) Current flowing through the circuit. (Irms) c) Voltage across resistors R9, R12, R14. (Vrms) d) Current flowing through the resistors R9, R10,R14. (Irms) e) Calculate the time period of the waveform Consider V=3.535Vpk and F=1.5 kHz
There era two type of currents, a. direct current and b. alternating current. For each of these type, name as many as you can the specific application and discuss them as to their effectiveness And safety.
A dc-source has positive and negative polarities. Is it correct to say that an ac-voltage source has no polarity? Why or why not?