Answered: Write the advantages and disadvantages… | bartleby

Related questions

Question

Write the advantages and disadvantages of each casting process:

1. Sand casting

2. shell molding

3. Investment casting

4. permanent casting

5. die casting

explain each point i.e. why it is occurring like this or the reason/s behind it either advantages or disadvantages

Expert Solution

Trending now

This is a popular solution!

Step by step

Solved in 4 steps

SEE SOLUTION Check out a sample Q&A here

Blurred answer

Similar questions

1 kg of boiling water at a temperature of 109.3 degrees Celsius. The pressure is then doubled and the water evaporates at this new pressure to a degree of drought 0.9. By using a steam table. Determine: A. Pressure where evaporation B. The amount of heat that must be added before evaporation starts at a new temperature C. Wet steam enthalpy D. Wet steam entropy E. Wet vapor volume Note : picture 1 is pressure table, picture 2 is temperature table.
Water in an ice cube tray is put into the freezer section of a refrigerator.As it freezes, the water will A. Increase in entropy B. Lose all entropy C. Decrease in entropy D. Have constant entropy
23
What causes thermal energy transfer? A. The difference in mass of substances. B. The size in substances. C.yet not known. D. Vibration of substances when heated?
8.A car engine with engine efficiency 40% burns gasoline and does 500 Joule work to drive the car. How much heat (in Joule) is produced from gasoline burning (hot source)? 9.The specific heat of water is 1.0 cal/gram oC. 100 gram hot water at 100 oC is mixed with 300 gram cold water at 20 oC. What is the final equilibrium temperature (in oC) of the mixed water? answer both question han raing helpful oher vise un helpful
36: NEED HELP
6. Thermal energy storage is a proposed method to store solar energy in between use. This technology works by focusing solar arrays to heat up a molten salt (usually a mix of Na+/K+/Li+/NO, ). Then the energy from the molten salt can be used later to run a steam generator and produce work. a) Suppose 10,000 tons of molten salt have been heated up to 800K (1 ton 907 kg). This molten salt has a heat capacity of 1.5 J/g/K. How much heat is released from the salt when it is cooled to 550 K? b) Now suppose all of this heat is used to heat up water. What volume of water can be heated from room temperature to 100°C using the heat released from the salt? 6:37 1/29/ Home End Insert
4. a) Describe the Bio heat transfer Process in general b) Describe Conduction Process c) Describe Thermal Resistance experienced in Conduction d) Describe Thermal Radiation process and Stefan-Boltzmann law