Write a KCL at node A. Write a KVL of loop 1. Introduce currents and voltages as necessary to write these KCL and KVL. Remember to show the directions of the currents and terminals of the voltages on the circuit. 5A At ww 25 V 40 ohm loop 1 20 ohm ww 100 ohm 50 ohm

Q: Calculated Total Resistance: 894.93 2 Measured Total Resistance: 894.88 Q Measured Power (using…

A:

Q: Suppose the voltage across the resistor is ΔvR = ΔVmax= RVmax sin wt Find the current through this…

A: The given data's are, The voltage across a resistor is, ∆vR=∆Vmax=RVmax sin ωt Here resistor…

Q: Solve by Method of Branch Current by using figure 1. R1=5 R3=15 R5=25 R6=30 Loop1 cw R2=103 Loop 2…

A: The given figure is

Q: Determine the current in each branch by the use of Kirchoff's laws.

A:

Q: 1. Using Kirchhoff's law, solve for the branch currents. Label the currents. 230 V A 35 Ohm 35 Ohm B…

A:

Q: What the voltage falling on the coil in the circuit shown in the figure

A: What is the voltage falling on the capacitor in the circuit shown in the figure?  This problem is…

Q: For the circuit below, a. Label the voltage on each resistor and the loop current b. Write a KVL…

A:

Q: Two resistors Rx and Ry are connected across a 100 V. supply. Ry takes twice as much power as Rx.…

A: In this question, Two resistors Rx and Ry are connected across a 100 V. supply. Given power PY = 2Px…

Q: please find the currents and voltages of all resistors in the circuit by using KCL & KVL…

A: Given circuit,

Q: Three resistors are connected in delta configuration which are 2 ohms, 4 ohms and an unknown…

A: The objective of this question is to find the value of the unknown resistance in a delta…

Q: Calculate the current through the 80-ohm load resistor RL.  The source voltage is 80 volts.  The…

A:

Q: 02: Determine the currents Iı, h and I3 in the circuits shown in the figure. 1mA 2mA I2 4mA I3 10

A:

Q: A 50-ohm, a 90-ohm and an unknown value resistor are in series across a 60-V generator with 1/3A…

A: given circuit

Q: 4. Determine: Branch currents and power in each resistor using Kirchhoff's Laws R1 = 10 0 R3 = 30 Q…

A: Kirchhoff's Voltage Law The sum of Voltage difference around any closed loop in a circuit is equal…

Q: a. The load RL in the circuit below is varied between 25 and 100 ohms in steps of 25 c Determine the…

A:

Q: Piease explain how to pply KCL/KVL f Voltoge soure is in parallel with sort-circuit. 12 し1 is +) 2V…

A:

Q: In the circuit in the figure, the switch was left open for a long time and was closed at t=0. When…

A: R1= 8 OhmsR2= 8 OhmsR3 = 9 OhmsL = 10 henryV= 26VAsked to find current in inductor at t=0.16 second

Q: SOLVE THE FOLLOWING PROBLEMS COMPLETELY The series combination of a 4-ohm resistor and a variable…

A:

Q: Find the Vrms of 5 ohm resistor 2/30° A 352 502 j4Q -j2Q * 6Q

A:

Q: 1)Determine the three currents in the circuit 2) Determine the potential difference between the two…

A: The required parameters can be calculated by using the kirchhoff's current law and ohms law.

Q: Determine the currents (IR1) for the network in the figure below if R1=6. D. Si E 201 D, Si R 5.6AO

A:

Q: 3. Three loads A, B and C are connected in series to a 110-volt source. Load B takes 1100W, load C…

A:

Q: In the given figure, find the current V2 in volts. 8 S2 3 2 V1 + v, V2 I2 3552 36 V 342 $42

A: We will use krichoff's current law to calculate unknown voltage .

Q: 15 Ww w 3602 बाई ww म 4100 www w V या Ww Ww AAR AC

A:

Q: by kirchhoff find i1,i1,i3 and voltage at any resistance 1002 R. 5V

A:

Q: PART A e power Oour uc and dc circuit. True/F A2 The use of very high resistance ammeter minimizes…

A: The solution is given below    The given statement is false . because in order to minimize loading,…

Q: Write the Kirchhoff's voltage equations for the circuit shown in he Figure below and hence find…

A:

Q: Two resistors are arranged as shown with a 12V DC power supply. The two resistors are: R₁ = 220 ohms…

A: Given circuit: V=12 VoltR1=220 ΩR2=330 Ω

Q: Three resistors are connected in delta configuration which are 2 ohms, 4 ohms and an unknown…

A: The objective of the question is to find the unknown resistance in a delta configuration of…

Q: 3. Determine the power dissipated across each resistor. Use the given branch current directions for…

A: now, Applying KVL in loop 1,3I1+5I1+25+0.5I1-25+0.5(I1+I3)+4(I1+I3) = 013I1+4.5I3=0…

Q: 230 V A 35 Ohm 35 Ohm B I21 I5 (b) I3 I4t 210 V 25 Ohm) _210V 210 V 15 Ohm 25 Ohm 15 Ohm C

A: Given

Q: How do i use source trasnformation to find the current? Using KCL I got -.25mA and thats not right.

A:

Q: For the circuit shown in below figure, find v and the power absorbed by the resistor? 15 mA 3 kn

A: Given data, Current source i=15 mA Resistance R=3 kΩ

Q: What is the value of the current I in the circuit shown in the figure?

A: Here we have used the short circuit method to find the diode current first of all we also the diode…

Compensation Techniques

The compensation techniques are the methods that are employed in the electrical control systems to enhance the performance of the system. The performance are generally affected by the factors like lag in the compensating devices, slow response of the system of the components like sensors used in the control system. The basic compensation technique involves lag compensation, lead compensation or the combination of the both.