Answered: wo workstations. a) Find the number of…

wo workstations. a) Find the number of transmitted bits for synchronous transmission. >) Find the number of transmitted bits for asynchronous transmission.

Database System Concepts

7th Edition

ISBN:9780078022159

Author:Abraham Silberschatz Professor, Henry F. Korth, S. Sudarshan

Publisher:Abraham Silberschatz Professor, Henry F. Korth, S. Sudarshan

Chapter1: Introduction

Section: Chapter Questions

Problem 1PE

See similar textbooks

Related questions

Q: 5. Suppose, you have 6 voice channels, each of 60MBps. You have to use synchronous TDM to multiplex…

Q: In MIPS, all operation codes (op-codes) use ______ only. A- 5 bits B- 8 bits C- 6 bits D -32 bits

A: In MIPS, all operation codes (op-codes) use ______ only. A- 5 bits B- 8 bits C- 6 bits D -32 bits…

Q: Eight sources, each with a bit rate of 1000 kbps are to be combined using synchronous TDM. Each…

A: a. The size of an output frame in bits is as follows : Size of an output frame = Number of sources +…

Q: What causes variations in the time interval between bytes during asynchronous transmission?

A: Introduction: The time between bytes is "changeable" in Transmission because of its asynchronous…

Q: please answer with proper explanation and step by step solution with final answer conclusion.…

A: To calculate the transmission rate in bits/sec, we need to know the size of the picture frame in…

Q: 2. How many characters per second can be transmitted over a 9600-baud line in each of the following…

A: Start bit and end bit are necessary bits for proper transmission in each asynchronous serial…

Q: Bit or symbol transmission time: Based on the maximum gross bit rate (the transmission rate) R in…

A: Bit rate is the transmission of a number of bits per second. The Baud rate is defined as the number…

Q: With higher bit transmission speed, the duration of each bit in the signal, referred to as the…

A: Dear learner , hope you are doing well , I will try my best to answer this question. Thank You!!

Q: The Asynchronous Transfer Mode (ATM) uses an 8-bit CRC for error detection. The 8 bit CRC uses the…

A: Asynchronous transfer mode (ATM) is defined as the method of switching used by telecommunication…

Q: A channel has a frequency range between 3 KHz and 14 KHz. The SNR in this channel is 25 dB. Find the…

A: ANSWER:-

Q: a. Assume your university library has a million books. Calculate the number of bytes of data if all…

A: a. With regards to the aforementioned issue, it has previously been stated that the campus library…

Q: 4- Serial 1/O, a) Suppose that in a serial communication channel, the receiver receives the…

A: As you have posted multiple questions, we will solve the first question for you. a) Consider the 2…

Q: Assume a 5 bit code is used for each symbol transmitted. If the bit rate is 50 MHz, what is the…

A: The relationship between the bitrate and baud is shown below. Bit rate = boud * number of bits per…

Q: For information bit sequence 1101011101001001. Determine ) ) bit sequence of DPSK. )( , bit…

A: The solution for the above-given question is given below:

Q: When working with 1024K words, how many address bits are required

A: Dear Student, The answer to your question is given below -

Q: The Asynchronous Transfer Mode (ATM) uses an 8-bit CRC for error detection. The 8 bit CRC uses the…

A: Asynchronous transfer mode (ATM) is a transfer mode for switching and transmission that can…

Q: Assume that 150 characters with each character encoded as 8 bits will be sent out between two…

A: The answer is given below step.

Q: SAMPLE DATA HELLO CODE

A: A)in below figure shows how to transit message are multiplexed into frames.

Q: Beginning with one start bit followed by 21 data bits, 2 parity bits and 1 stop bit: a) What are the…

A: Given: One start bit followed by 21 data bits, 2 parity bits, 1 stop bit.…

Q: Match the given baud rate and the number of bits carried by each signal unit (baud rate, bits) with…

A: 1) bit rate=baud rate x no of bits per signal =1200*3 =3600 (Answer 1) 2)…

Q: Bit or symbol transmission time: Based on the maximum gross bit rate (the transmission rate) R in…

A: Answer : Maximum gross bit rate or transmission rate is different for different devices or medium .…

Q: c) If an (15, 1) channel enc ding system is use to ect the probable errors that may occur during…

A: the channel coding parameter c would be the decision of the RS code rate. On the off chance that we…

Q: How many characters per second can be transmitted over a 9600-baud line in each of the following…

A: Baud rate is the rate at which information is transferred over a communication channel. In the case…

Q: Ten 10-kHz signal channels are sampled and and multiplexed at a rate of 25 k samples/s per channel.…

A: I have given the handwritten answer of the above problem. See below steps.

Q: (approx) does it ne 1Mb = 220)

Q: Ture False: With serial transmissions, each bit of data is sent individually.

A: Serial Transmission : In telecommunication and data transmission, serial communication is the…

Q: ith a bit rate of 250 kbps and four with a bit rate of 500 kbps are to be combined using…

A: a) we can allocate eight 250kbps sources into 4 500 kbps sources . Therefore 8 total 500 kbps…

Q: Transmission speeds of character devices are often higher than those of block devices. To what…

A: Defining OSHA: According to OSHA, which stands for the Occupational Safety and Health Act of 1970,…

Q: For the 12C transmission below by the Master, determine the Slave address and whether or not it is a…

A: Answer: 0xEA, Write , ACK

Q: Digital image processing (CSE) A common measure of transmission for digital data is the baud rate,…

A: The Answer is

Q: What varies the duration between bytes in asynchronous transmission?

A: Asynchronous transmission is the process of transmitting data without the use of an external clock…

Q: Why does asynchronous transmission have a non-constant delay between bytes?

A: The time between bytes is "changeable" in Transmission because of its asynchronous nature. Data sent…

Q: What causes the difference in the amount of time that passes between each byte during asynchronous…

A: Introduction: Because Transmission is an asynchronous protocol, the amount of time that elapses…

Q: 13. What limits the number of bits per symbol and what limits the symbol rate?

A: Answer. In essence, the speed of information transmission to the receiver determines the maximum…

Q: II A digitized TV picture is to be transmitted from a source that uses a matrix of 1280 X 720…

A: Answer: 184.32 Mbps

Q: How many characters per second can be transmitted over a 1400 -baud line in each of the following…

A: Answer Option B = > Asynchronous serial transmission with two stop bits and no parity

Q: an odd number Parity

A: Given :- In the above given question, an odd number parity check is mention in the above given…

Q: 280. In asynchronous transmission, we send one start bit that is a. 0 b. 1 c. 10 d. 11

A: 1) Asynchronous Transmission is also known as start/stop transmission, sends data from the sender to…

Q: For single bit parity, after adding the redundancy the number of 1s Select one: O a. should be equal…

A: For single bit parity, after adding the redundancy the number of 1s Select one: O a. should be…

Q: The Fig 4.1 shows a demultiplexer of a TDM. If the frame size is 16 bits long (no synchronous /…

A: Show as demultiplexer of TDM .If the frame size is 16 bits long(no Synchronous/frame bits). What is…

Concept explainers

Types Of Protocols

A network protocol is a collection of rules that governs the exchange of data between devices connected to the same network. In other words, network protocols are rules that specify how devices communicate or transfer data over a network. The sender and receiver systems must obey the standards to facilitate communication between them.

Question

1.
Assume that 150 characters with each character encoded as 8 bits will be sent out between
two workstations.
a) Find the number of transmitted bits for synchronous transmission.
b) Find the number of transmitted bits for asynchronous transmission.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, computer-science and related others by exploring similar questions and additional content below.

Similar questions

14. The signal to noise ratio on your phone line is 1000:1 and your modem attempts 7000 symbols per second, with each symbol representing 6 bits. a) What is the data rate that your modem is attempting? b) If the bandwidth on the line is 3000 Hz, what is the maximum theoretical data rate? c) Check all three limits, show your work. exceeded? Which of the three limits were
. How many check bits? Suppose you want to send 3500 characters of data. a) How many check bits will you need using asynchronous transmission? b) How many check bits will you need using synchronous transmission? Assume that all 3500 characters will fit within one synchronous transmission frame. Explain and show all your work (Definitions, calculations, units). Answer a) Asynchronous: b) Synchronous:
5) How many characters per second can be transmitted over a 1200-baud line in each of the following modes? (Assume a character code of eight bits.) a. Synchronous serial transmission. b. Asynchronous serial transmission with two stop bits. c. Asynchronous serial transmission with one stop bit.
Calculate the total number of bits used in downloading a 50 MB video file. Also calculate the time (in minutes) it takes to download the same video file, if the download link is a telephone line with 9600 baud rate. Assume 8 - bits of data per character, 1 start bit, 1 - stop bit, and 1 parity bit.
1. (c) Eight sources, six with a bit rate of 100kbps and two with a bit rate of 200kbps are to be combined using multilevel TDM with no synchronizing bits. Answer the following questions about the final stage of multiplexing: i) How many channels we have now? ii) What is the size of a frame in bits? iii) What is frame rate? iv) What is the duration of a frame? v) What is the data rate?
O Calculate the total number of bits used in downloading a 50 MB video file. Also calculate the time (in minutes) it takes to download the same video file, if the download link is a telephone line with 9600 baud rate. Assume 8 - bits of data per character, 1 – start bit, 1 - stop bit, and 1 parity bit. -
Because synchronous transmission always uses the same block size, the receiver always knows when one block finishes and another starts. a. true b. false
1. Figure depicts a UART serial data transmission from a keyboard to a computer.The character input from the keyboard is “Best”. By refering to the ASCII code table,draw the serial data transmission waveform diagram for the characters and label the bit.Ignore the parity bit.(Note: The transmitted data bits start with LSB and ends with MSB)
3- Which is the last bit transmitted in a serial communication? a) Least significant bit b) All the bits simultaneously c) Most significant -