winding is 0.25 ohm at 25oC. When operating at full load, the temperature of the winding is 75oC. The temperature coefficient of resistance for copper at 0oC  is 0.00427 per oC. What is the winding resistance at full load? a. 0.512 ohm b.

Q: Q.1: The following data refer to a single-phase trans former: Turn ratio (2:1). R1=2.4n, X-5.5 n.…

A:

Q: A IcA B The voltage ratio in the following transformer equals to, Inc VAN/N1 Van/N2 Van/N1 Vab/N2

A: In this question, choose the correct option  What is the voltage ratio of the given transformer.

Q: Whether a transformer shifts an ac waveform by 0° or 180° depends on the phasing of the waveform…

A: Shifts of ac waveform by 0 to 180 degree is depending on

Q: Question 5 An ideal transformer is one which has Not yet answered No losses and magnetic leakage…

A:

Q: For the given circuit below, a step down transformer gives an RMS voltage of 230 V/ 11.6-0-11.6 V…

A: Given data:

Q: The Primary and Secondary induced voltages respectively are: 220.4 volts and 23.96 volts 239.6 volts…

A:

Q: The transformation ratio based on the induced voltages is: 919.8 91.98 9.198 10

A:

Q: With a turns ratio of 12 to 1 and an input voltage of 240V and output 12V, propose a system of…

A: The solution is given below

Q: If the turn ratio of a step-up transformer is 1:15 and the full-load secondary current is 300 A, the…

A:

Q: During short-circuit test, iron losses are negligible because the voltage applied on primary side is…

A: let us arrive at the right answers in each case by analyzing the given statement as shown below.

Q: The eddy current loss in a 2300 V, 60-Hz transformer is 280 W. What will be the eddy current loss if…

A:

Q: What is the purpose of lighting arrester in the transformer

A: A lightning arrester, also known as a surge arrester or lightning rod, is a protective device used…

Q: A 5 kV/ 112 V, 50 Hz, single-phase transformer is to have an approximate E.m.f. per turn of 27 V and…

A: 5KV/112 V, 50Hz single phase transform have per turn emf= 27V. Flux density B =1.55T Flux = B.A  A…

Q: A 200-MVA 15/200-kV single-phase power transformer has a resistance of 0.01352 and a reactance of…

A: Given, In single phase transformer the parameters are S=200 MVAV1/V2=15/200 kVR=0.0135 ΩX=0.0563 Ω

Q: Certain transformer has full-load copper losses of 500 W. What is value of copper loss at half load:…

A: Given data: Pc1=500 W

Q: What are advantages of transfering parameter from 1 side of transformer to other side? Subject…

A: The advantages of transferring parameter from 1 side of the transformer to the other side are  1.…

Q: What is the benefit of the electrical transformer in the case of load and in the case no load?

A: Discuss the benefit of the electrical transformer in the case of load and in the case no load?NoteA…

Q: The primary voltage of a 2300/230 volts transformer has a frequency of 60 cycles. What is the…

A: It is given that: V1V2=2300230 Vf=60 cycles

Q: If the ripple voltage of this circuit is to be no more than 4V, determine analytically what…

A:

Q: the circuit shown in the figure, a voltage with a peak value of 212.16 V is applied to the input of…

A:

Q: In transformer, the eddy current loss can be minimized by using thin size copper conductors using…

A: Transformer have 2 types losses  In the question the eddy current losses can be minimised by???

Q: The primary of a current transformer takes 1 A at a power factor of 0.4 when it is connected across…

A: Given: N1=2N2Io=1 Acosϕo=0.4I2=50 Acosϕ2=0.8 lag

Q: In transformer, the eddy current loss depends on both frequency and flux density load current only…

A: The circulating current produced in the body of the magnetic material when it is subjected to an…

Q: The eddy-current loss in a 6.9 kV, 50 Hz transformer is 220 W. What will be the eddy-current loss of…

A:

Q: 11) Which phenomenon is used in transformer to change the values of alternating voltages and…

A: Given that Which phenomenon is used in transformer to change the values of alternating voltages and…

Q: The transformer shown in figure 3 has a ratio of 120rms:24rms CT. RL = 2K and the diodes are ideal.…

A: The transformer ratio is 120rms:24rms CT. RL = 2K and the diodes are ideal. F=60Hz What would be the…

Q: 2,99 A 200/100 V, 50 Hz transformer is to be excited at 40 Hz from the 100 V side. For the exciting…

A: According to the question we have to find the value of applied voltage.

Q: For the transformer shown in Figure Q3 (a), Determine the following. i. The turn ratio ii. The…

A: We know the current and voltage ratio for transformer , we will use that ratio to calculate the…

Q: For problem 1-3, consider Figure 1. 2:1 120 Vrms ooooo rellle D. 84.9 V 2. The dc voltage at the…

A: We need to analyse the given half wave rectifier circuit

Q: (d) Assuming zero core reluctance, calculate the magneto-motive force (mmf) produced by the primary…

A:

Q: The short circuit test of a transformer gives information of

A: In this question , we will write about short circuit test of a transformer....

Q: The open-circuit voltage of 246 V and the full load secondary voltage of 230 V, then the %…

A: In this question we will find percent voltage regulation of transformer....

Q: The main difference between transformer and dc motor is O The transformer has a core O The…

A:

Q: Determine the sources of harmonics produce in a provided power system circuit shown in Figure 6.…

A: Given Data:A transformer-fed, single phase, full wave, diode bridge rectifier with,A filter…

Q: 2. The resistance of a transformer windings is 0.25 ohms at 25 degrees Celsius. When operating at…

A: Given that  α0=4.27×10-3 /°Ct1=25°Ct2=75°CR1=0.25 ohmR2=? It is known that…

Q: A single-phase transformer is required to step down the voltage from 1100 V to 230 V at 50 Hz. The…

A: Given:…