Why they do not affect the circuit in the high frequency and how the circuit pi model will be at low frequency?

Q: P3.A. Reduce the block in canonical form. R th

A: As per our guidelines we are supposed to answer only first question. Kindly repost the other…

Q: a) In an ac transistor amplifier, the circuit includes capacitors as well as resistors. What is the…

A: Brief description: In the above given question we need to explain importance of coupling capacitors…

Q: using a LM358 design a circuit with a 5V unipolar power supply, which has a 2V peak-to-peak…

A: According to the question, by using a LM358 design a circuit with a 5V unipolar power supply, which…

Q: A) The circuit in Figure 3A have Izan=20µA. The Resistance Rc=100k2, and Vcc=VEE=5V. The transistors…

A: Given the circuit: Given: ITAIL=20 μA, RC=100 kΩ, VCC=VEE=5 V The transistors are matched with…

Q: Why there is a need to construct multistage amplifiers

A: To explain: Need to construct multistage amplifiers.

Q: ideally, what should the reactance of a bypass capacitor be in order to eliminate a 10 kHz AC…

A: Given: What should the reactance of a bypass capacitor be in order to eliminate a 10 kHz AC voltage…

Q: Perform an ac analysis. Represent the amplifier by its ac equivalent circuit and discuss the input…

A:

Q: What is the common element represented in A-mode, B-mode or M-Mode? Considering the answer for…

A: Modulation, convert optical carrier signal into radio waves. Modulation techniques are divided into…

Q: For the circuit of Figure 2. Carry out the analysis in DC and small signal with Vt=0.7 V, Kn(W/L) =…

A:

Q: Example 7 For the circuit shown, use R1=R2=47k02, RE=5.7k 2, RC=3.3k 2, RL=10k 2 and Vcc=12V,…

A:

Q: What does increased signal to noise ratio mean?

A: Signal to noise ratio : Signal to noise ratio is denoted by S/N ratio it is present in both analog…

Q: What is the function of coupling capacitors? Assuming that they are performing their intended…

A: In amplifiers, it is sometimes required to have only an AC signal at the output for an example audio…

Q: Vec= 15VT 2ook Cer lok Ces Vo {look Ni Rin

A: Part (a): In the DC equivalent model, all the capacitors act as an open-circuit. The DC equivalent…

Q: +Vcc (+12 V) Ic 20 µF C2 10 µF Rs 50 Ως RB 220 k2 RE 2.2 kQ RL Vo 4.7 kQ Ż. -VEE (-12 V)

A: In DC analysis we have to open circuit all the capacitors .   After getting all the capacitor in…

Q: Show how using p-n-p transistor connected in common-emitter configuration it can be used as an…

A: The Common-Emitter transistor configuration is used as a amplifier in applications like Audio…

Q: Identify the given statement. The phase deviation sensitivity and the peak modulating-signal voltage…

A:

Q: a- Draw the cct Q1/(A) For the waveforms of s phase angle control Ac-Ac converter: - diagram and…

A: Part (a): Circuit Diagram and Waveforms1. Circuit Diagram:The AC-AC converter typically consists of…

Q: Consider the following common emitter amplifier: Discuss the LIMITATIONS of this circuit in terms…

A: We need to discuss the limitation of this circuit in terms of linearity and in terms of impedance…

Q: Draw a real-life MOSFET circuit(Ac model) and derive the circuit in that circuit to find operating…

A:

Q: E MOSFET SGD Rs 5k Vo 10 kQ Rd 2 RL 2 kQ Vi sine +\ Vd 10 V Vs 10 V zi

A:

Q: a) Draw the small signal model of the circuit at high frequencies. b) Find the high-frequency poles…

A:

Q: Draw the hybrid equivalent circuit for common base configuration and also write down the h-parameter…

A: Here, we have asked to draw the hybrid equivalent for the common-base configuration. So, we will…

Q: Q3/: Complete design as required for the following, sketch the output waveform (Vo), circuit. Vin 12…

A:

Q: How to Sketch the AC equivalent of a given BJT circuit

A: Need to brief the procedure to get the AC equivalent of the BJT circuit.

Q: Give the expression for the Voltage Gain (Vout/Vin) for the circuit below. Ignore Channel Length…

A: Given, The circuit diagram,

Q: Explain what is meant by the term, modulation, and produce a diagram of an Amplitude Modulated…

A:

Q: find the system Noise factor and Noise Figure for Te = 30,50,75,150, and 300 K measured at To of…

A: Given: The effective noise temperature measured at reference temperature 290K is: Te=30, 50, 75,…

Q: Outline the circuit condition for using the supernode technique.

A: Suppose any of the branches in the network has only voltage source, then it is slightly difficult to…

Q: Given the figure below, discuss how the circuit recovers the original information from the input AM…

A:

Q: 7) Suppose we have a power amplifier with an RF output power (POUT) of 50 watts and a DC input power…

A: We know that efficiency = output power/ input power,now put the given values as, output power Pout=…

Q: Discuss the process on how n-p-n BJT works?

A:

Q: b) Complete design to perform signal as shown Vo -6 -12

A:

Q: This problem is AC analysis problem. DC analysis is not needed to answer the question. A) If we…

A: We need to find out the resistance value and output voltage for given condition

Q: Define Small signal Stability. Why is it important to study in a power system network? How Ts and Td…

A: Small signal rotor angle stability is concerned with the ability of the power system to maintain…

Q: otal harmonic distortion (THD) index is used to determine the distortion levels of the voltage as…

A: Although total harmonic distortion is defined as the ratio of sum of power of all harmonics  to the…

Q: Current and impedance levels of push-pull RF amplifier. Solid-state RF power amplifiers that provide…

A: According to the question, for push-pull RF amplifier(a) If each of the two devices in the push-pull…

Q: d) A regulator as shown in Figure 4 has an input voltage, Vs = 12 V. The duty cycle, k = 0.35 and…

A: Since there are multiple sub-parts uploaded within the same question, therefore solving first three…

Q: Explain the difference between AC small signal amplifiers. from power amplifiers.

A: to explain the difference between AC small signal amplifiers from power amplifiers.

Q: +v R, Rz ovo Rf2 1.+ Redrawthe circuit-equivalentwhenoperatingat-a-DCvoltage(OHz).1…

A:

Q: A Phase Modulator has a phase deviation constant, Kp = 35°/V. The carrier signal is ec = 8…

A: