Why is the following situation impossible? In a large city with an air-pollution problem, a bus has no combustion engine. It runs over its citywide route on energy drawn from a large, rapidly rotating flywheel under the floor of the bus. The flywheel is spun up to its maximum rotation rate of 3 000 rev/min by an electric motor at the bus terminal. Every time the bus speeds up, the flywheel slows down slightly. The bus is equipped with regenerative braking so that the flywheel can speed up when the bus slows down. The flywheel is a uniform solid cylinder with mass 1 200 kg and radius 0.500 m. The bus body does work against air resistance and rolling resistance at the average rate of 25.0 hp as it travels its route with an average speed of 35.0 km/h.

Why is the following situation impossible? In a large city with an air-pollution problem, a bus has no combustion engine. It runs over its citywide route on energy drawn from a large, rapidly rotating flywheel under the floor of the bus. The flywheel is spun up to its maximum rotation rate of 3 000 rev/min by an electric motor at the bus terminal. Every time the bus speeds up, the flywheel slows down slightly. The bus is equipped with regenerative braking so that the flywheel can speed up when the bus slows down. The flywheel is a uniform solid cylinder with mass 1 200 kg and radius 0.500 m. The bus body does work against air resistance and rolling resistance at the average rate of 25.0 hp as it travels its route with an average speed of 35.0 km/h.

Similar questions

One end of a cord is fixed and a small 0.400-kg object is attached to the other end, where it swings in a section of a vertical circle of radius 1.50 m, as shown in the figure below. When θ = 23.0°, the speed of the object is 5.50 m/s. An object is swinging to the right and upward from the end of a cord attached to a horizontal surface. The cord makes an angle θ with the vertical. An arrow labeled vector v points in the direction of motion. (a) At this instant, find the magnitude of the tension in the string.Your response is within 10% of the correct value. This may be due to roundoff error, or you could have a mistake in your calculation. Carry out all intermediate results to at least four-digit accuracy to minimize roundoff error. N(b) At this instant, find the tangential and radial components of acceleration. at = Your response differs from the correct answer by more than 100%. m/s2 downward tangent to the circle ac = Your response differs from the correct answer by more…
A wheel with a radius of 0.23 m and a mass of 7.31 kg spins about its axis at 6.53 radians per second. What is the kinetic energy of the wheel in J? Treat the wheel as a cylinder of constant density.
A plane with a wingspan of d = 16 m loses control in flight and begins to spiral in a circle around the cockpit while in a vertical dive. It completes one rotation every t = 3.1 s.
A hollow sphere rolls without slipping down a ramp that is 3.5 m long. the ramp is inclined at an angle of 20˚ with the horizontal. Use the conservation of energy to find the speed of the sphere at the bottom of the slope if it starts from rest. ( I= 2/3 m R2 )
An electric motor is used to drive the shaft of a small water pump. During a performance test, the torque on the motor shaft is found to be 7.642 Nm when the motor is drawing 631.33 W of electrical power. What is the rotational speed of the shaft in rpm?
A string is wrapped around a disk of mass m = 2.2 kg and radius R = 0.08 m. Starting from rest, you pull the string with a constant force F = 9 N along a nearly frictionless surface. At the instant when the center of the disk has moved a distance x = 0.12 m, your hand has moved a distance of d = 0.27 m. m d (a) At this instant, what is the speed of the center of mass of the disk? Vcm = m/s (b) At this instant, how much rotational kinetic energy does the disk have relative to its center of mass? Krot = Additional Materials M eBook
In the figure, a wheel of radius 0.234 m is mounted on a frictionless horizontal axis. The rotational inertia of the wheel about the axis is 0.586 kg-m2. A massless cord wrapped around the wheel's circumference is attached to a 4.00 kg box. The system is released from rest.When the box has a kinetic energy of 4.00 J, what are (a) the wheel's rotational kinetic energy and (b) the distance the box has fallen? Assume free-fall acceleration to be equal to 9.81 m/s2. M (a) Number Units (b) Number Units
A flywheel is a solid disk that rotates about an axis that is perpendicular to the disk at its center. Rotating flywheels provide a means for storing energy in the form of rotational kinetic energy and are being considered as a possible alternative to batteries in electric cars. The gasoline burned in a 144-mile trip in a typical midsize car produces about 1.05 x 109 J of energy. How fast would a 18.7-kg flywheel with a radius of 0.247 m have to rotate to store this much energy? Give your answer in rev/min.
An electric motor is used to drive the shaft of a small water pump. During a performance test, the torque on the motor shaft is found to be 6.624 N•m when the motor is drawing 583.61 W of electrical power. What is the rotational speed of the shaft in rpm?
In the figure, a solid 0.1 kg ball rolls smoothly from rest (starting at height H = 5.6 m) until it leaves the horizontal section at the end of the track, at height h = 1.6 m. How far horizontally from point A does the ball hit the floor? Number i Units eTextbook and Media GO Tutorial Save for Later Attempts: 0 of 8 used Submit Answer tv DD 80 88 12 E10 11 F9 FB F6 FS esc F3 F4 F2 @ #3 $ %3D 4 6 7 8. 1 2 3 Y U Q W E R ンビ

A uniform horizontal disk of radius 5.50 m turns without friction at w = 2.30 rev/s on a vertical axis through its center, as in the figure below. A feedback mechanism senses the angular speed of the disk, and a drive motor at A ensures that the angular speed remain constant while a m = 1.20 kg block on top of the disk slides outward in a radial slot. The block starts at the center of the disk at time t = 0 and moves outward with constant speed v = 1.25 cm/s relative to the disk until it reaches the edge at t = 465 s. The sliding block experiences no friction. Its motion is constrained to have constant radial speed by a brake at B, producing tension in a light string tied to the block. (a) Find the torque as a function of time that the drive motor must provide while the block is sliding. Hint: The torque is given by = 2mrvw. t N-m (b) Find the value of this torque at t= 465 s, just before the sliding block finishes its motion. N.m 2.52 (c) Find the power which the drive motor must…
A flywheel is a solid disk that rotates about an axis that is perpendicular to the disk at its center. Rotating flywheels provide a means for storing energy in the form of rotational kinetic energy and are being considered as a possible alternative to batteries in electric cars. The gasoline burned in a 187-mile trip in a typical midsize car produces about 2.84 x 109 J of energy. How fast would a 9.42-kg flywheel with a radius of 0.237 m have to rotate to store this much energy? Give your answer in rev/min.