Please ASAP. Thank you. Why can we treat ionic gradients as batteries in an RC circuit diagram?Because it provides a means of maintaining ion selectivity.Because batteries happen to have very low resistanceBecause ionic gradients provide an electrical force for excitable cells

Answered: Why can we treat ionic gradients as…

Science

Physics

Why can we treat ionic gradients as batteries in an RC circuit diagram?

Physics for Scientists and Engineers, Technology Update (No access codes included)

9th Edition

ISBN:9781305116399

Author:Raymond A. Serway, John W. Jewett

Publisher:Raymond A. Serway, John W. Jewett

Chapter27: Current And Resistance

Section: Chapter Questions

Problem 27.9OQ: The current-versus-voltage behavior of a certain electrical device is shown in Figure OQ27.9. When...

See similar textbooks

Related questions

Q: 41. Lisa rushes down onto a subway platform to find her train already departing. She stops and…

Q: What is the units for 0.0298, 101.74 and 19.264.

A: According to the given problemgiven equation of wave

Q: How much does it cost to run a refrigerator all day for 6 months (30 days/month) if it requires 3.5…

A: Power is defined as the rate at which the work is done per unit of time. Higher power means having a…

Q: It seems like a incorrect answer

Q: Determine the number of branches and nodes in the circuit in Fig. 2.71.

Q: An electric water heater consumes 6.63 kW for 2.35 h per day. What is the cost (in dollars per year)…

Q: The resistance of electric heater is 44 Ohm when connectedto 120 V. What is the power consumption of…

A: Given data: Resistance (R) = 44 ohm Potential difference (V) = 120 V Required: Power (P)

Q: 1. What is the velocity of a car that traveled a total of 65 km east in 2.3 hours

Q: An electric water heater consumes 5.63 kW for 2.85 h per day. What is the cost (in dollars per year)…

A: Given: The heater consumption of electricity is 5.63 kW for 2.85 h per day. The cost of electricity…

Q: Is the answer 161.91W?

A: From the solution of previous problem, R1 = 23.314 Ω Using, R2=R1[1+α(Tf−Ti)]…

Q: rceO 2.

A: Moving currents produce magnetic fields. Due to these fields parallel currents will repel each other…

Q: The resistance of a doped germanium crystal obeys the equation log R' = 4.697 – 3.917 log T. %3| -…

A: We know that the resistance of a doped germanium crystal obeys the equation is given as logR'=…

Q: 46. Given the equation F- m/R, what relationship exists between each of the following? (1.3) a. Fand…

A: The relations is shown as,F=mv2R Part(a):There is inverse relationship between force and…

Q: &= 25 V & = 36V R-140 R-40 R-70 R-40 I=7A &= 20V F A)" T

Q: remains in the block, and after the impact the block lands d = 2.00 m from the bottom of the table.…

A: Given that ; Mass of bullet, m1=8 g Mass of block, m2=250 g Height of the table, h=1 m The…

Q: 21. A 0.600-kg particle has a speed of 2.00 m/s at point and V kinetic energy of 7.50 J at point ®.…

Question

Please ASAP. Thank you.

Why can we treat ionic gradients as batteries in an RC circuit diagram?
Because it provides a means of maintaining ion selectivity.
Because batteries happen to have very low resistance
Because ionic gradients provide an electrical force for excitable cells

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1 Given statement

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

The current-versus-voltage behavior of a certain electrical device is shown in Figure OQ27.9. When the potential difference across the device is 2 V, what is its resistance? (a) 1 (b) 34 (c) (d) undefined (e) none of those answers
A child's electronic toy is supplied by three 1.58-V alkaline cells having internal resistances of 0.0200 inseries with a 1.53-V carbon-zinc dry cell having a 0.100- internal resistance. The load resistance is 10.0 . (a) Draw a circuit diagram of the toy and itsbatteries, (b) What current flows? (c) How much power is supplied to the load? (d) What is the internal resistance of the dry cell if it goes bad, resulting in only 0.500 W being supplied to the load?
Figure P18.19 shows a Wheatstone bridge, a circuit used to precisely measure an unknown resistance R by varying Rvar until the ammeter reads zero current and the bridge is said to be balanced. If the bridge is balanced with Rvar = 9.00 , find (a) the value of the unknown resistance Rand (b) the current in the 1.00 resistor. (Hint: With the bridge balanced, the wire through the ammeter can effectively be removed from the circuit, leaving two pairs of resistors in parallel.) Figure Pl8.19
(a) A defibrillator sends a 6.00-A current through the chest of a patient by applying a 10,000-V potential as in the figure below. What is the resistance of the path? (b) The defibrillator paddles make contact with the patient through a conducting gel that greatly reduces the path resistance. Discuss the difficulties that would ensue if a larger voltage were used to produce the same current through the patient, but with the path having perhaps 50 times the resistance. (Hint: The current must be about the same, so a higher voltage would imply greater power. Use this equation for power: P=I2 RP = .)
Figure P18.26 shows a voltage divider, a circuit used to obtain a desired voltage Vout from a source voltage . Determine the required value of R2 if = 5.00 V, Vout = 1.50 V and R1 = 1.00 103 (Hint: Use Kirchhoff's loop rule, substituting Vout = IR2, to find the current. Then solve Ohms law for R2. Figure P18.26
When resistors with different resistances are connected in parallel, which of the following must be the same for each resistor? Choose all correct answers, (a) potential difference (b) current (c) power delivered (d) charge entering each resistor in a given time interval (e) none of those answers
The terminals of a battery are connected across two resistors in series. The resistances of the resistors are not the same. Which of the following statements are correct? Choose all that are correct. (a) The resistor with the smaller resistance carries more current than the other resistor. (b) The resistor with the larger resistance carries less current than the other resistor. (c) The current in each resistor is the same. (d) The potential difference across each resistor is the same. (e) The potential difference is greatest across the resistor closest to the positive terminal.
When resistors with different resistances are connected in series, which of the following must be the same for each resistor? Choose all correct answers. (a) potential difference (b) current (c) power delivered (d) charge entering each resistor in a given time interval (e) none of those answers
A battery with an internal resistance of 10.0 produces an open circuit voltage of 12.0 V. A variable load resistance with a range from 0 to 30.0 is connected across the battery. (Note: A battery has a resistance that depends on the condition of its chemicals and that increases as the battery ages. This internal resistance can be represented in a simple circuit diagram as a resistor in series with the battery.) (a) Graph the power dissipated in the load resistor as a function of the load resistance. (b) With your graph, demonstrate the following important theorem: The power delivered to a load is a maximum if the load resistance equals the internal resistance of the source.
Three 60.0-W, 120-V lightbulbs are connected across a 120-V power source, as shown in Figure P18.50. Find (a) the total power delivered to the three bulbs and (b) the potential difference across each. Assume the resistance of each bulb is constant (even though, in reality, the resistance increases markedly with current). Figure P18.50
The terminals of a battery are connected across two resistors in parallel. The resistances of the resistors are not the same. Which of the following statements is correct? Choose all that are correct. (a) The resistor with the larger resistance carries more current than the other resistor. (b) The resistor with the larger resistance carries less current than the other resistor. (c) The potential difference across each resistor is the same. (d) The potential difference across the larger resistor is greater than the potential difference across the smaller resistor. (e) The potential difference is greater across the resistor closer to the battery.
(a) Digital medical thermometers determine temperature by measuring the resistance of a semiconductor device called a thermistor (which has a= - 0.0600/°C ) when it is at the same temperature as the patient. What is a patient's temperature if the thermistor’s resistance at that temperature is 82.0% of its value at 37.0°C (normal body temperature)? (b) The negative value for a may not be maintained for very low temperatures. Discuss why and whether this is the case here. (Hint: Resistance can’t become negative.)