While winching a Jeep straight out of the mud, a winch uses 4800Watts of electrical power to pull the 1500-kg Jeep 12meters as it accelerates at 0.15. This takes a the winch 20 seconds to accomplish. Calculate... a.) the force of tension in the cable for the winch to pull the jeep. b.) the work done by the winch to pull the jeep. c.) the power done by the winch to pull the jeep. d.) the efficiency of the winch in this scenario

While winching a Jeep straight out of the mud, a winch uses 4800Watts of electrical power to pull the 1500-kg Jeep 12meters as it accelerates at 0.15. This takes a the winch 20 seconds to accomplish. Calculate... a.) the force of tension in the cable for the winch to pull the jeep. b.) the work done by the winch to pull the jeep. c.) the power done by the winch to pull the jeep. d.) the efficiency of the winch in this scenario

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Related questions

Q: 2n

A: Assume reactions at support A and B At A VA - Vertical ReactionHA - Horizontal Reaction At B VB -…

Q: An arborist is cutting down a tree a 28 m high tree by starting his cut 1.8 m above the ground. The…

A: Given dataHeight of the tree H = 28mMass of the tree m = 3750kgCutting is done at 1.8m above the…

Q: A block weighing 1900 lb slides on a flat surface with an initial velocity of 80 ft/s. The…

Q: 4. A 100 lb cabinet is placed on a smooth surface. If a force of a 100 lb is applied for 2 s,…

Q: Starting from a standstill, Abi (mass = 55.00 kg) performs a vertical jump. c.) If the duration of…

Q: A belt conveyor is required to deliver crushed limestone having a bulk density of 50 lb/ft3 at the…

Q: 1- A block of mass 4 kg is released from rest at the top of an inclined plane whose angle is 35°…

Q: Q1) A 5 kg block initially at rest is pulled to the right along a horizontal surface by a constant…

Q: A projectile object reaches a height of 303 m, if it is fired straight up using a spring-loaded gun.…

A: Write the maximum height reaches by a projectile during fired straight up. h1,max=303 m Write…

Q: FIGURE BELOW shows the car having a mass of 1.40 Mg and a center of mass at Gc pulls a loaded…

Q: Can tutor explain clearly on each questions and provide the solution and calculation 1)Calculate…

A: 1)Calculate the velocity of the arm, observed by a stationary person on the ground.2)Draw the FBD of…

Q: P11. A cable is used to vertically lower an initially stationary fruits packet of mass 500 kg at a…

A: This question is on the topic of mechanics and spring compression. Here following unknowns need to…

Q: machine with a mass of 500 kg is being lifted from the ground up a building using a set of pulleys…

A: Given, A machine with a mass of 500 kg is being lifted from the ground up a building using a set of…

Q: Glider A weighs MA = 8kg. a) Find the acceleration of A relative to a completely smooth rod. b) Find…

A: Since in the 1st case of the question, it is given that the rod is smooth, there will be no friction…

Q: • A steel cable whose cross-sectional area is 2.5 cm² supports a 1000-kg elevator. The elastic limit…

Q: Q4. A block is connected to a spring of length s that is initially unstretched. Then the block is…

Q: Required information NOTE: This is a multi-part question. Once an answer is submitted, you will be…

A: The weight of the elevator is E=6600 lb=29358.26256 N The counterweight is W=2800 lb=12455.02 N. The…

Q: The rotation axis of the uniform cylinder is constrained by a frictionless slot. The cylinder is at…

A: Given data: Belt translational velocity V = 20 ft/s Coefficient of friction μ=0.4 Find: a) Calculate…

Q: 4. A 100 lb cabinet is placed on a smooth surface. If a force of a 100 lb is applied for determine…

A: Given :-Weight of cabinet (W) =100 Ib Force (F)= 100 lbTime (t) =2sTo find:-The net impulse on the…

Q: The vehicle shown starts from rest at the bottom of the hill and accelerates up the hill due to the…

A: Given data mass of car = 1600 kgFR = 7300 Nvtop = 9.7 m/sh = 50 m

Q: 20. How much force must be applied to push a 1.35 kg book across the desk at constant speed if the…

Concept explainers

Conservation of Energy

In physics, the rule of the conservation of energy states that energy doesn’t disappear from the atmosphere; instead, it changes its form from one type to another. Energy is one of the most important physical quantities in nature, and it cannot be created or destroyed — only transformed.

Question

While winching a Jeep straight out of the mud, a winch uses 4800Watts of electrical power to pull the 1500-kg Jeep 12meters as it accelerates at 0.15. This takes a the winch 20 seconds to
accomplish. Calculate... a.) the force of tension in the cable for the winch to pull the jeep. b.) the work done by the winch to pull the jeep. c.) the power done by the winch to pull the jeep. d.) the
efficiency of the winch in this scenario.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 3 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, mechanical-engineering and related others by exploring similar questions and additional content below.

Similar questions

B4
Part a) Determine the force exerted by his seat on a 170-lb rider at B and D Part b) Determine the minimum value of the radius of curvature at E if the roller coaster is not to leave the track at that point.
1. Hydraulic jacks are one of the many tools humans use to develop a so-called "mechanical advantage". The basic idea is that a relatively small force applied to the smaller-area piston can counteract a relatively large force applied to the larger-area piston. F₂ a) Ignoring the weight of the fluid (i.e., ignoring changes in hydrostatic pressure due to the density of the fluid) and any friction between the piston and the sidewalls, show that F2 = F₁ AR A₁ in static equilibrium. b) The mechanical advantage of the hydraulic jack can be defined as the ratio of the force applied to piston 2 to the force applied to piston 1 in order to keep the system in static equilibrium. For circular pistons, use the relationship in part a) to plot the mechanical advantage as a function of the diameter ratio of the pistons. Explain the significance of this mechanical advantage. c) Consider a hydraulic jack in static equilibrium with both pistons at the same elevation. If you do not consider the weight of…
A projectile object reaches a height of 430 m, if it is fired straight up using a spring-loaded gun. Using the same gun, what is the maximum height (m) that can be reached by the projectile if it fired at an angle of 31 ° from the vertical?