In which state heat is added to the system as shown in the PV diagram below?40kPa30kPa20KP a10kPa31m32m3m4mstate 4 1state 2 3state 1 2O state 3 4

In which state, heat is added to the system

Answered: which state heat is added to the system…

Science

Physics

which state heat is added to the system as shown in the PV diagram below? TP 40kPa 30kPa 20kPa 10kPa- 1m2 2m 3m* 4m

College Physics

11th Edition

ISBN:9781305952300

Author:Raymond A. Serway, Chris Vuille

Publisher:Raymond A. Serway, Chris Vuille

Chapter1: Units, Trigonometry. And Vectors

Section: Chapter Questions

Problem 1CQ: Estimate the order of magnitude of the length, in meters, of each of the following; (a) a mouse, (b)...

See similar textbooks

Similar questions

The figure belows shows three components of an air-conditioning system, where T3 = 95°F and m3 = 1.5 lb/s. Refrigerant 134a flows through a throttling valve and a heat exchanger while air flows through a fan and the same heat exchanger. Data for steady-state operation are given on the figure. There is no significant heat transfer between any of the components and the surroundings. Kinetic and potential energy effects are negligible. Saturated liquid R-134a T3, m3 m₁ = i Throttling valve lb/s 4 P4= 60 lbf/in.² Air T₁ = 535°R Cp=0.240 Btu/lb-ºR Fan wwwwww T₂=528°R +2 5 Wey = -0.2 hp Saturated vapor Ps= P4 Modeling air as an ideal gas with constant cp = 0.240 Btu/lb. °R, determine the mass flow rate of the air, in lb/s. -Heat exchanger
0.0035 mol of gas undergoes the process shown in . (B) What is the initial temperature? (C) What is the final temperature?
Q3 The gases in the cylinder of an internal combustion engine have a specific internal energy of 800 kl/kg and specific volume of 0.06 m:/kg at the beginning of expansion. The expansion of the gases may be assumed to take place according to a reversible law, pv"= constant, from 55 bar to 1.4 bar. The specific internal energy after expansion is 230 kJ/kg. Calculate the heat rejected to the cylinder cooling water per kilogram or gases during the expansion stroke. The worke done by the system is 465.96 kj/kg
The specific heat of one mole of a two- dimensional solids at high temperatures is: О а. 3R O b. 3R/2 O C. R O d. 2R
A 58-kg cross-country skier glides over snow as in the figure below. The coefficient of friction between skis and snow is 0.18. Assume all the snow beneath her skis is at 0°C and that all the internal energy generated by friction is added to snow, which sticks to her skis until it melts. How far would she have to ski to melt 1.5 kg of snow?
Consider the following two-step process. Heat is allowed to flow out of an ideal gas at constant volume so that its pressure drops from P₁ = 2.7 atm to P2 = 1.7 atm. Then the gas expands at constant pressure, from a volume of V₁ = 5.9 L to V₂ = 9.6 L, where the temperature reaches its original value. See the figure ( Figure 1). Figure P P₁ P2 σ P D HÅ AU = Value Units Submit Request Answer Part C 1 of 1 wwwww ? Calculate the total heat flow into or out of the gas. Express your answer to two significant figures and include the appropriate units. ☐ με Value Units Submit Request Answer
An ideal gas undergoes the process a→b→c→a shown in the pV diagram. In the figure, Pa = Pc = 240 kPa, Vb = Vc = 40 L, Va = 15 L, and Pb = 400 kPa. How much heat is gained by the gas in this a→b→c→a process?
A jet of steam at 100°C is applied to a 2.00 kg block of ice at 0°C. How many grams of steam would be required to completely melt the ice assuming a complete transfer of thermal energy? nA d bloow olle boutaig erd 15000 lo yolla an ai e W lobin bna 1900 lo yolla ns e losbinom 4
What is the maximum theoretical efficiency possible for an engine operating between 100°C and 400°C?
A 1.0-kilogram cube of ice made from distilled water initially at 0 degree Celsius is placed in an adiabatic vessel containing 2.0 liters of distilled water initially at a temperature of 25 degrees Celsius. Using the information given below, answer the questions that follow: a. How many grams of the ice melts at the equilibrium condition b. How many grams of the ice will remain unmelted (if there's still any) at the equilibrium condition? c. What is the absolute temperature (in Kelvins) at the equilibrium condition? Water liquid form ice form density (g/mL) 1.00 0.997 Cp (J/ K*mole) 75.35 37.71 ΔHfusion (KJ/mole) 6.02 ΔHvaporization (KJ/mole) 40.657
If I bring a small object at temperature 200C in thermal contact with a large object at the same temperature, a) thermal energy will flow from the large to the small object because the large object has more internal energy. b) thermal energy will flow from the small to the large object because that will increase entropy. c) thermal energy will not flow.
A diatomic gas is heated at constant pressure. The fraction of heat energy used to increase the internal energy is 5/7 5/9 3/5 3/7