Which of the following would be the result of packing too much sample into a melting point tube? A) The melting point range will be too high and too broad B) The melting point range will be too low and too narrow C) The melting point range will be too high and too narrow D) The melting point range will be too low and too broad

Which of the following would be the result of packing too much sample into a melting point tube? A) The melting point range will be too high and too broad B) The melting point range will be too low and too narrow C) The melting point range will be too high and too narrow D) The melting point range will be too low and too broad

Chemistry

10th Edition

ISBN:9781305957404

Author:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Publisher:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Chapter1: Chemical Foundations

Section: Chapter Questions

Problem 1RQ: Define and explain the differences between the following terms. a. law and theory b. theory and...

See similar textbooks

Similar questions

Predict all the chemical compounds in the table below from the given chemical formula and other physical properties Chemical Name Chemical Formula M (g/mol) Boiling Point Melting Point Refractive Index (power of n to D) (nD) C6H14 86.18 69 1.375 SiO2 60.1 1600-1725 C13H10 166.22 295 C13H8O 180.19 342 1.6309 C3H6O 58.08 57 1.35900
Why are impurities added to silicon dioxide in the glass making process? To increase mechanical strength To add color D To improve transperency To make it easier to shape To increase thickness
Which would be the best way to determine the melting point of a compound? Why? Slowly run two very precise melting points. Run a very precise melting point and then run a fast one to double check your work. Run a quick melting point for an approximate melting range, then a slow precise one.
4. When performing a melting point on a solid compound using a melting point apparatus, two melting point determinations were made. One sample, which was 1 mm in height in the capillary, possessed a melting point of 200.0-200.5°C. The other sample was 25 mm in height. What would you expect the approximate melting point to be for this sample, assuming identical heating rates of 1°/min? (Hint: heat is applied from the bottom of the sample) (Give an actual numerical approximation!) 5. For the same solid compound as the question above, if the 1 mm sample was heated at 60° per minute on a melting point apparatus, what would you expect for an approximate melting point? (note that at this heating rate, the sample will melt rather quickly, but again give an actual numerical approximation)
Graph the data for the last time point at 75 minutes, and label each lines with the type of crystal
If you want to make a polymer for plastic wrap, should youstrive to make a polymer that has a high or low degree ofcrystallinity?
O Is it easier to fit a interstitial atom above or below the dislocation line shown below?
Chemistry Find the maximum draw ratio of the given flexible linear polyethylene samples given in the table below When the chains are crystallized from a solution where the solution concentration is just above the critical overlap concentration | Mw (g/mol) 200000 Polydispersity 1.0 800000 1.0 2000000 1.0 4000000 1.0
Chemistry
Which of the following factors can result in the broadening of the melting point of a sample? I. The sample is wet. II. The ramp rate is too slow. III. The sample contains a small amount of an impurity. IV. The compound decomposes during heating. Answers: I, III, and IV II and IV II and III III only II only I and III
7 8 9
How does the solvent move up the stationary phase. A. Polarity b. Capillary action c. All of the above d. None of the above