Which of the following variables isnot needed to calculate for thesurface tension of a liquid withoutthe use of a calibrating liquid? *Gravitational accelerationO Height of the capillary tube usedInner radius of the capillary usedO Density of the liquid

Answered: Image /qna-images/answer/60bd621c-936e-49c3-8f81-45c5513405bc.jpg

Which of the following variables is not needed to calculate for the surface tension of a liquid without the use of a calibrating liquid? * O Gravitational acceleration O Height of the capillary tube used O Inner radius of the capillary used Density of the liquid

Which of the following variables is not needed to calculate for the surface tension of a liquid without the use of a calibrating liquid? * O Gravitational acceleration O Height of the capillary tube used O Inner radius of the capillary used Density of the liquid

College Physics

11th Edition

ISBN:9781305952300

Author:Raymond A. Serway, Chris Vuille

Publisher:Raymond A. Serway, Chris Vuille

Chapter1: Units, Trigonometry. And Vectors

Section: Chapter Questions

Problem 1CQ: Estimate the order of magnitude of the length, in meters, of each of the following; (a) a mouse, (b)...

See similar textbooks

Related questions

Q: An experiment is done where a pressure sensor is lowered into an unknown fluid and the pressure as…

A: The pressure at depth h of a liquid is given by:- P= Po + ρgh Where; ρ= Density of the liquid. g=…

Q: The figure below shows a fluid inside a cubical container of side 1 m. If th- pressures inside and…

Q: Find the value of the fluid density if you know that the value of the slope is (20 g/cm) and the…

A: Value of slope is 20 g/cm=2.0 kg/m Diameter of the tube is 0.035 m So, radius of the tube is 0.0352…

Q: The figure below shows a fluid inside a cubical container of side 1 m. If the pressures inside and…

A: Given, Pressure outside, Pout=1 atm Pressure inside, Pin=4 atm Length of the cube, l=1 m We know,…

Q: Determine the thickness of a hollow aluminum sphere with a mass of o.35g and has an outer radius of…

Q: Where the speed of a fluid increases, its pressure will O stay the same O increase O depend on what…

A: When the speed of a fluid increases, its pressure will

Q: B) Is it possible for a fluid to flow in a direction from low pressure to high pressure? If so, give…

A: Fluid basically flows from "higher energy level" to a "lower energy level". And yes, fluid can flow…

Q: The surface tension of a fluid at 25 degrees Cis equal to 0.083 N/m. Find the capillary rise of the…

Q: Which is the correct order of liquids to be used in washing the capillary tube prior to the start of…

A: Cleaning of the capillary tube is essential before starting an experiment in order to avoid any…

Q: The figure below shows a fluid inside a cubical container of side 1 m. If the pressures inside and…

A: Side= 1 m

Q: Q3) Mercury has a contact angle equal to (1400) with glass. A narrow (4mm) capillary tube made of…

A: Solution:-Given thatcontact angle (θ)=140°diameter of capillary tube (d)=4 mm=0.004 msurface tension…

Q: What fluid is in the device if the force is 3.16×10−3 N and the length of the wire is 2.50 cm?…

A: Given, F= 3.16×10−3 N Length=2.50 cm=2.5x10-2m

Q: The figure below shows a fluid inside a cubical container of side 1 m. If the pressures inside and…

A: Answer option (a) 3.039*105 N

Q: The figure below shows a fluid inside a cubical container of side 1 m. If the pressures inside and…

Q: (numbers 2-3) An ideal fluid flows through a vertically oriented cylindrical tube of varying radius…

Q: Water flows at a constant speed of 15 m/s through narrow section of the pipe. What is the speed of…

Q: QUESTION 21 When honey is poured from a container to another, it flows slowly when compares with…

A: Answer 21) The viscosity of a fluid is a measure of its resistance to deformation at a given rate.…

Q: A hot-air balloon has a total weight (balloon, ropes, & basket) of 1.96 x104 N. The density of the…

A: Given:Total Weight, bolloon,Force,F=1.96 x104 Ndensity of the hot air ,ρhot=0.85 kg/m3density of the…

Q: - 10 kg floating piston 4.0 cm- 100 cm 20 cm A Oil 60 cm B

A: Given: Height of left cylinder (h) = 100 cm = 1 m. Diameter of left cylinder (d) = 4.0 cm = 0.04 m.…

Q: What is the pressure inside the container given the following?

Q: a- Determine the magnitude of the force Fin that the small piston exerts on the fluid in the small…

Q: The equation of continuity for fluid flow can be derived from the conservation of: energy mass O…

Q: What would be the effect of an increase in the value of the inner radius of the capillary tube to…

A: We want to see the effect of an increase in the value of the inner radius of the capillary tube to…

Q: Using data from the diagram below, calculate the ratio of the height to which water at 0°C and…

Q: A bird moving in air or a fish moving in water experiences a force opposite to its direction of…

Q: How do you determine the density of media necessary to reduce the energy associated with…

A: To determine the density of media necessary to reduce the energy associated with fluidization by…

Q: In a pipe line the pressure of oil is measured with a mercury manometer containing fluid at pressure…

A: Given: The pressure of oil is measured with a mercury manometer containing fluid at pressure P. The…

Q: as far an capillary action concern the Liquid of high density has curved surface. O True False оо

A: as for an capilary action concer the liquid of high density has curved surfaces. FALSE

Q: A box has the shape of a cube with 2.00 cm on each side and is immersed in a mystery fluid.…

Q: Generally, if you are asked to find any physical quantity (e.g. pressure, temperature, flow rate),…

Q: The figure below shows a fluid inside a cubical container of side 1 m. If the pressures inside and…

A: Given : Pressure inside, Pins = 7 atm Pressure outside, Pout = 1 atm Side of the cube, a = 1 m

Q: How much increase will F2 have based on F1 if the diameter of A2 is twice that of A1? * input…

Q: A gasoline line is connected to a pressure gauge through a double U-tube manometer as shown in the…

Q: What is the specific gravity of fluid X? 100 mL 100 g 125 g O 125 O 1.25 O 0.8 1.0

A: mass of 100 ml of water = 100 g mass of 100 ml of fluid X = 125 g

Q: does atmospheric pressure add to the gas pressure in a rigid rank? Why does atmospheric pressure…

A: Part-A In a rigid tank atmospheric pressure doesn’t add to the gas pressure, because the rigid tank…

Q: Which is true about the volume flow rate and speed of the fluid flowing in the tube on the right?…

A: Given : In a tube fluid is flowing. To find : Which is true about volume flow rate and…

Q: The method of capillary rise is based on the height to which the liquid in the capillary will rise…

A: It is force due to gravity F= mg m = mass g = gravitational constant

Q: The pressure drop in a pipeline changes by a factor of when the velocity of the flowing fluid is…

Q: A plastic sphere floats in water with 54% of its volume submerged. This same sphere floats in…

Q: A material "X" appears to weigh 200 N in air and 150 N when immersed in a liquid of specific gravity…

Question

Which of the following variables is
not needed to calculate for the
surface tension of a liquid without
the use of a calibrating liquid? *
Gravitational acceleration
O Height of the capillary tube used
Inner radius of the capillary used
O Density of the liquid

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Formula

VIEW

Answer

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

A group of students performed two separate experiments using the same liquid to determine the surface tension of the liquid by the capillary rise method. All conditions, reagents, and apparatus used were the same except for the capillary tube, which was replaced with one having a smaller inner radius. In this experiment, a calibrating liquid was not used as the inner radius of the capillary tubes were already determined. How would this affect the data collected by the students on the two experiments? * The density of the liquid in the first experiment would be less than the second. The density of the liquid in the first experiment would be greater than the second. The displacement, h, of the liquid inside the capillary tubes for both experiments will be of the same value. The displacement, h, of the liquid inside the capillary tubes for both experiments will be of different values.
can you check if the first 3 are correct and also help me figure out what the last one is?
pressure exerted anywhere in a confined compressible fluid is transmitted equally in all the directions throughout the fluid
What is true about the volume of displaced fluid for an object that is completely submerged? (1 Point) The volume of displaced fluid is equal to the object's volume. The volume of displaced fluid is less than the object's volume. The volume of displaced fluid is greater than the object's volume. The volume of displaced fluid is not related to the object's volume.ption 4
To what height should a cylindrical vessel be filled with a homogenous liquid to make the force with which the liquid presses on the sides of the vessel equal to the force exerted by the liquid on the bottom of the vessel?
Q1 (a) A body immersed in a fluid will sink, float or remain at rest at any point in the fluid, depending on its average density relative to the density of the fluid. Discuss the relation between density of the body and density of the fluid for floating body, suspended body and sinking body.
What would be the behavior of an object that was immersed in a fluid if the object and the fluid had the same density? Explain.
Calculate the Reynolds number for an object moving through a fluid.
Q) A small air bubble with a diameter of 0.45 mm was found in a sample of blood plasma in a capillary tube as illustrated in the figure. Calculate the pressure inside the bubble when:- 1) It lies directly below the surface of the blood plasma sample. 2) The blood plasma lies at a depth of (3.6 cm) in the sample. Note that the density of the plasma (g/ml is 1.025), the surface tension of the plasma (N/m 0.073) and the atmospheric pressure (P = 1,013 x 105 Pa) 1
If you were to break the 64 mm capillary in half and repeat the flow rate measurement with water, how would your measured values change?
Two identical containers are open at the top and are connected at the bottom via a tube of negligible volume and a valve that is closed. Both containers are filled initially to the same height of 1.00 m, one with water, the other with mercury, as the drawing indicates. The valve is then opened. Water and mercury are immiscible. Determine the fluid level in the left container when equilibrium is reestablished. Number Units Water Valve Mercury 100 m 4
9.8