Which of the following statements are TRUE, when the cavitation parameter o = 0?1. The local pressure is reduced to vapor pressure.2. Cavitation starts3. Boiling of liquid starts4. Cavitation stops 5m deep vertical cylindrical tank, water is filled up to a level of 3m from the bottom andthe remaining space is filled with oil of specific gravity 0.88. Assume density of water as1000 kg/m3, Atmospheric pressure = 100 kPa and acceleration due to gravity to be10 m/s?. The absolute pressure (in kN/m², rounded off to the first decimal place) at adepth of 2.5 m from the top of the tank will be(up to one decimal place)

There is missing information in the first question because three options are correct for this…

Which of the following statements are TRUE, when the cavitation parameter o = 0? 1. The local pressure is reduced to vapor pressure. 2. Cavitation starts 3. Boiling of liquid starts 4. Cavitation stops

Which of the following statements are TRUE, when the cavitation parameter o = 0? 1. The local pressure is reduced to vapor pressure. 2. Cavitation starts 3. Boiling of liquid starts 4. Cavitation stops

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Related questions

Q: For the pressure vessel containing glycerin, with piezometer attached as shown, what is the…

A: Note:- Hi! Thank you for the question, As per the honor code, we are allowed to answer three…

Q: Two gage marks are placed exactly 250 mm apart on a 12-mm diameter aluminum rod. Knowing that, with…

Q: A Y-shaped tube is inserted upside down so that the left foot and right foot are immersed in two…

A: Given- density of first liquid ρ1=0.80 g/cm3density of second liquid ρ2=0.75 g/cm3height of the…

Q: The pressure exerted on a liquid increases from o kpa. The volume decreases by 1%. Determine the…

A: The bulk modulus is a measure of the ability of a substance to withstand changes in volume under…

Q: The diameter of a horizontal tube is 4 in., in which tetrabromoethane (SG = 3.0) is flowing at the…

Q: A = 1000 mm a = 40 mm² h, = 500mm h, = 300mm 1000x 20 500 log 10 300 K = 2.303- 40 x180 K = 1.42…

A: Given- cross-section area of the soil mass A=1000 mm2area of stand pipe a=40 mm2Length of the soil…

Q: 21. The dynamic viscosity of a water in the SI is in "Pascal second". It is equivalent to * 0.10…

Q: Consider the thermal system shown below. The temperature of the inflow liquid is kept constant, and…

A: Thermal system The term "thermal system" refers to a system that stores and transfers heat. A…

Q: Taking the coefficient of compressibility of water to be 2200 MPa, determine the pressure increase…

Q: A rigid, insulated vessel is divided into two compartments connected by a valve. Initially, one…

Q: Calculate the location of the center of pressure, Lp, to in m to the nearest 1000th. Fluid: Orange…

A: Concept: Center of Pressure The total pressure force acting on a fully submerged body is called the…

Q: Consider the opening exposed to the atmosphere at 1 atm, find the pressure at point A. Refer to the…

Q: f the pressure in the tank of oil (sp gr 0.80) is 60 psi, what is the equivalent head in feet of oil

Q: An open cylindical tank contains 18925 Liters benzene ( Sa= 0.876). The diameter of the tank is 2 m.…

A: Volume of tank (V)=18925 litre Diameter of tank(d)=2m

Q: 2. In the figure shown, if the atmosphere pressure is 101.3 kPa and the absolute Pressure at the…

Q: 2. Determine the height of the water from the right leg if the liquid added in the left leg has a…

Q: Which of the following statement is correct? The viscosity of liquid decreases with increase in…

Q: 2) Assuming we have a fluid with SG-0.6, and height of fluid in the piezometer tube equal to h=10m,…

A: To Determine Pressure at point M, P & S

Q: The viscosity of the liquid is 0.002 Pa.s and its density is 0.8. Get systematic fluid viscosity.

A: Given data, Dynamic viscosity = 0.002 Pa.s Relative Density = 0.8 Density = 800 kg/m^3 Systematic…

Q: Due to rise in temperature, the viscosity and unit weight of percolating fluid are reduced to 70%…

A: The given data is: The reduction in viscosity=70 % The reduction in unit weight of percolating…

Q: Two lbs of water vapor in a piston-cylinder assembly expands at a constant pressure of 300 lb/in²…

Q: Based on the expression dp/dz = -pg, at what elevation is the absolute pressure 70% of the pressure…

Q: specific gr poured into the tank. By spinbu

A: To find : Percentage change in pressure at base of tank. Given: tank of height 3 m is completely…

Q: Determine the number of fins and overall fin efficiency using Figure 2.7. (c) Determine the total…

Q: a liquid of density

A: To find : Pressure at base of beaker now.

Q: If the Patm = is 101.3KPa and the Pabs at the bottom of the tank is 231.3 kPa. y of H28 = 9.79kN/M^3…

Q: A tank initially contains 100 gallons of brine in which there is dissolved 20 lb of salt. Starting…

Q: In the figure shown, given that the absolute pressure at B is 290 kPa. Therefore, the value of "h"…

Q: When the pressure inside a vessel is 22.75 psig. then the absolute pressure equal to:

A: given - pressure inside a vessel Pgage = 22.75 Psi to find - absolute pressure (Pabs)

Q: Q.11 A liquid compressed in a cylinder has a volume of 0.0113 m³ at 6.87 x 106 N/ 3 m² pressure.…

A: Initial volume =0.0113 m3, Initial pressure = 6.87×106 N/m2, Final volume=0.0112 m3, Final pressure…

Q: In the Figure below, a pool of liquid sodium is sitting in open atmosphere (and somehow not…

A: (a) Pressure Gradient: Pressure at surface of the liquid sodium, p1=0 Pressure at the depth L from…

Q: HAVA 1 SU 20 сm Hava 2 20 cm Mavi Mavi Su Su Mavi Su ХҮст

A: relative density =1.75 xy distance =42 cm Effective pressure at A=ρbgh where g=9.81 m/s2 and…

Q: A tank contains the following liquids: • water with h= 2.5 m • sea oil (s=0.89) with h=2.6 m •…

Q: Let P and T be the pressure and temperature of the super-heated vapor and Psat be the saturation…

Q: Consider the following conditions: Condition I Condition 2 A wooden cube of size 2 m and the 20% of…

A: Given data, Condition - 1 Wooden cube size = 2 m Relative density = 0.5 Condition - 2 20% of the…

Q: If the work done 10000 cal, and the initial pressure 100 atm, when the ideal gas | expand…

A: Introduction : The general gas equation, commonly known as the ideal gas law, is the state equation…

Concept explainers

Pressure and Stress

Question

Which of the following statements are TRUE, when the cavitation parameter o = 0?
1. The local pressure is reduced to vapor pressure.
2. Cavitation starts
3. Boiling of liquid starts
4. Cavitation stops

5m deep vertical cylindrical tank, water is filled up to a level of 3m from the bottom and
the remaining space is filled with oil of specific gravity 0.88. Assume density of water as
1000 kg/m3, Atmospheric pressure = 100 kPa and acceleration due to gravity to be
10 m/s?. The absolute pressure (in kN/m², rounded off to the first decimal place) at a
depth of 2.5 m from the top of the tank will be
(up to one decimal place)

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 3 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

Determine the difference in pressure (kPa) between A and B. a= 4.06 meters b= 2.96 meters b oil mercury b a
If the fluid is contained in a long, narrow vessel so it can expand in essentially one direction only, show that the effective coefficient linear expansion a is approximately equal to the coefficient of volume expansion b?
Q2: A drop of liguid foluen is kept al uniform temperkure t 299 K and is suspended in air by a fine wire. The initid radius at r= 2mm. The vapor pressure of foluene 299K is f=384 Kfe and the density of liguid toluene is 366 ky Im 3. Derive equation for the time tp for the drop b evupurete Completely in a large volume of still air Calculate the tine in seconds for Complete evaporahion.
I need the answer as soon as possible
Problem A gas weighs 16 N/m³ at 25°C and at an absolute pressure of 0.25 N/mm². Deter- mine the gas constant and density of the gas.
Which of the following statements are TRUE, when the cavitation parameter o = 0? 1. The local pressure is reduced to vapor pressure. 2. Cavitation starts 3. Boiling of liquid starts 4. Cavitation stops
Problem 3. (15pts) Complete the following questions by analyzing the Water Phase Diagram. a) Water is heated from its initial condition (7=60°C, P=0.8atm) under constant pressure to the water vapor equilibrium curve. Specify the temperature and pressure at that equilibrium point. b) Water is depressurized from its initial condition (7=60°C, P=0.8atm) under constant temperature to the water vapor equilibrium curve. Specify the temperature and pressure at that equilibrium point. c) You are boiling water near the top of Longs Peak (P=0.6atm). At what temperature of the liquid water will the water begin to boil? d) While boiling water on Longs Peak, is it possible to heat the liquid water to a temperature above your answer in part c)? Explain.
Solve the following problem.
Referring to the figure shown below, water contained in a piston-cylinder assembly, initially at 1.5 bar and a quality of 40%, is heated at constant pressure until the piston hits the stops. Heating then continues until the water is saturated vapor. The initial height, L1, is 0.05 m and the change in height, L2, is 0.03 m. Patm-1 bar Piston Water P₁ = 1.5 bar L₁ For the overall process of the water, evaluate the work and heat transfer, each in kJ/kg. Kinetic and potential effects are negligible.
3 pts Determine the specific volume of a certain gas if the gage pressure is 5 kPa at 25°C and the gas constant is 287 J/kg-K