Which of the following statement is NOT applicable to series circuit? a. Different resistors have their individual voltage drops. b. Conductances are additive. C. Total resistance is always greater than the individual resistance. d. Same current flows through all parts of the circuit.

Which of the following statement is NOT applicable to series circuit? a. Different resistors have their individual voltage drops. b. Conductances are additive. C. Total resistance is always greater than the individual resistance. d. Same current flows through all parts of the circuit.

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Related questions

Q: A voltage divider consists of a 3000 – ohm, a 5000 – ohm, and 10000 – ohm resistor in series and the…

A: Given Voltage divider with series current Is=15 mA The resistors 3000 Ω,5000 Ω and 10000 Ω are…

Q: Briefly describe the effect of putting an infinite number of resistors in parallel

Q: ple Problems wo resistors vhen connected in series has a total resistance of 24

Q: e Definition of electrical series circuits and Definition of electrical parallel circuits ?

A: Electrical circuits are generally divided in two catagories series circuit consists of the all the…

Q: What is the corrosion current when the circuit resistance is 0.25ohms and the potential difference…

A: In this questionWe need to determine the current in the corrosion if voltage across the circuit is…

Q: We want to make a resistivity measurement. How should we connect the probes of the multimeter? Drag…

A: a multimeter is a portable device that can be used to take various electrical measurements like,…

Q: Which of the following statement is NOT applicable to series circuit? O a. Same current flows…

A: b) in series connection , voltage drop depends on there resistance. as resistance increase , then…

Q: For each set of measured voltages at the points (1, 2, and 3) indicated in Figure, determine if they…

A: The given circuit is a bridge rectifier with a filter and regulator. The circuit can be easily…

Q: Refer to Figure D. Determine the total current of the entire circuit. a. 1.0 A b. 0.5 A c. 0.2…

A: In this question we will find total current....

Q: Three resistors, 1902.50 and 14 0 are connected in parallel in a circuit. What is the equivalent…

A: Given data, Resistances are given R1=19 Ω, R2=5 Ω, R3=14 Ω.

Q: solve the actual value of each resistor using kirchhoff's law

Q: Draw the voltage tripler circuit and explain its operation. Explain the difference between voltage…

A: The detailed answer is solved below according to the given parameters and instructions in the…

Q: what can be observed in series wherein resistors with the same ohmic value

Q: A 12-V DC automobile head lamp is to be used on a fishing boat with a 24-V power system. The head…

A: Headlamp voltage=12 V Fishing boat power system voltage=24 V Headlamp rating=50W The power across…

Q: In cross circuits, how do i know the resistances are in parallel or in series connection?

A: The solution is given below

Q: The positive sequence current is Times the current in neutral wire

A: A balanced three-phase system with the same phase sequence as the original sequence is called as the…

Q: For the following circuit find VL, IL, Iz and IR if RL = 180 , repeat for R₁ = 470 R$ 20 V 220 2 Vz=…

A: Given: Circuit diagram,

Q: Determine the values of the currents for max current and min curent in the voltage regulator Zener…

A: Zener Diode Basics:Zener diodes are used for voltage regulation. They maintain a practically…

Q: Which of the following statements is true of a shorted component in a series circuit? a. The…

A: Which of the following statements is true of a shorted component in a series circuit...

Q: what us the resistance of teb 240- resistors connected in series? in parallel?

Q: Voltage sources in series Select one: a. When two or more voltage sources are connected in parallel,…

Q: State Kirchoff's current Law. O None of these sum of all powers in a circuit O sum of all emfs in a…

A: Kirchhoff's Laws: Kirchhoff's current law, Kirchhoff's voltage law Kirchhoff's current law:…

Q: A secondary cell having an end of 2v and internal resistance of 1amp is connected on series with a…

A: Resistors, inductors and capacitors form an integral part of any electrical circuit. A source,…

Q: 4) For circuit shown in Figure (4): Determine the voltage drop across 90. a) 17V 20 90 b) 15V c) 19V…

A: Given circuit is:

Q: Ohm and 6 Ohm Resistor is in parallel with each other then in series with a parallel connected 10…

Q: A 12-V DC automobile head lamp is to be used on a fishing boat with a 24-V power system. The head…

A: Given Rating of lamp ,P = 50W Voltage rating of lamp ,VL= 12V Available Voltage, V= 24 V

Q: What is the greatest voltage that can be applied across a -W, 2.7-MN resistor without causing it to…

Q: In this lab, you will be using resistors of various nominal values. What are the 5-band colour codes…

A: Given resistor values are: 100 Ohm220 Ohm 390 Ohm 560 Ohm 1000 Ohm

Q: The circuits terminal voltage is 16.7V and then resistors A&B are in parallel. The resistance of…

A: Basic electrical circuit problem is solved as shown below.

Q: for part c what is the actual calculation?

Q: Fill in the blanks: (a) Connect the 5.6 kohms, 4.7 kohms and 1.2 Mohms in series. The measured total…

A: Given: Three resistors are 5.6kΩ, 4.7kΩ and 1.2MΩ. Need to calculate equivalent resistance if…

Q: Write down the steps on how to Parallel Resistors Current Division

Q: Why do we use Voltage Dividers in aan electric circuit?

A: Voltage divider are passive circuiits which produces output voltage which is in fraction to the…

Q: Two resistors have resistances of 1.76 2 and 0.540 2. Determine the equivalent resistance if they…

A: Given: The two resistors are R1=1.76 ΩR2=0.540 Ω

Q: What happens to the terminal voltage of the 12.0-V emf with an internal resistance of 0.150 ohm that…

A: The emf is maximum voltage delivered by cell when no current flow through the circuit. Terminal…

Q: 1. A 5-ohm resistance is connected in parallel with a 10-ohm resistance. Another set, a 6-ohm and an…

A: Concept: When two resistances are connected in series then equivalent resistance Req= R1+R2When two…

Q: Calculate the minimum main protection for 6 A/C air conditioners, their main conductors and the…

A: Step 1:

Q: Three resistances are connected in parallel and their equivalent is in series with the same value of…

A: As given, the three resistances are connected in parallel and their equivalent is connected in…

Q: 1 20 O 30. O 40. O 50. O 60. O 70. C:

A: We need to find out equivalent resistance for given circuit

Q: Which of the following statement is true for purely resistive circuit? O a. Voltage lags the current…

Q: O) Shunt PMMC was designed by using indirect method to provide an ammeter with current range 5A,…

A: In this question, We need to calculate the value of resistance Rb.? We know shunt resistance R=…

Q: You have Unknown resistance in the laboratory. Suggest with explaining a suitable connection of…

Q: The emfs in the figure below are ₁ = 5.00 V and ₂ = 18.0 V. The resistances are R₁ = 17.00, R₂ =…

A: In this question, we need to determine the currents in the resistances.

Concept explainers

KVL and KCL

KVL stands for Kirchhoff voltage law. KVL states that the total voltage drops around the loop in any closed electric circuit is equal to the sum of total voltage drop in the same closed loop.

Sign Convention

Science and technology incorporate some ideas and techniques of their own to understand a system skilfully and easily. These techniques are called conventions. For example: Sign conventions of mirrors are used to understand the phenomenon of reflection and refraction in an easier way.

Question

Which of the following statement is NOT
applicable to series circuit?
a. Different resistors have their
individual voltage drops.
b.
Conductances are additive.
C. Total resistance is always greater
than the individual resistance.
d.
Same current flows through all parts
of the circuit.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1 Introduction

VIEW

Step 2 Explanation

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

WHEN COMBINING RESISTORS IN SERIES, THE TOTAL COMBINED RESISTANCE WILL BE EQUAL TO O A. THE SUM OF ALL THE RECIPROCALS OF EACH INDIVIDUAL RESISTANCE IN SERIES. O B. THE SUM OF ALL THE RESISTANCES IN SERIES. O C. THE PRODUCT OF ALL THE RESISTANCES IN SERIES. O D. THE RECIPROCAL OF THE SUM OF RECIPROCALS OF EACH INDIVIDUAL RESISTANCE IN SERIES.
a 12 volt source with an internal resistance of 1.2 ohm is connected across a wire wire wound resistor. maximum power will be disipated in the resistor when its resistance is equal to.
Qqqq
For a certain power shpply, the no load and full load voltage are 22 V and 18 V respectively. What will be the load regulation?
Show me how to approach this problem with steps please
3. Source transformation
True or False The resistor R characterizes alternating current circuits.
What is the theory and things to observe in voltage dividers e.g the purpose and how to do it
State the conclusion based on the series circuit experiment (lab report about ELECTRIC POWER IN PARALLEL AND SERIES CIRCUIT)
2. A parallel circuit has 3 resistors each on different paths connected to a 120 V potential difference. The resistors have resistances of 5.0 0. 7.5 Q. and 9.8 Q. Draw a schematic diagram of the circuit. Create a table for this circuit. INCLUDE DIAGRAMS AND TABLE ON THE SOLUTION. THANK YOU
What resistance must be connected in series with a 100-N resistor for the 100-0 resistor to produce heat at the rate of 30 W when the combination is connected to a 120-V source?