Which of the following part designs would be preferred because it would result in lower production costs: a part with 10 drilled holes of the same diameter on three sides of the part a part with 10 drilled holes of five different diameters on one side of the part a part with 10 drilled holes of the same diameter on one side of the part a part with 10 drilled holes of five different diameters on two sides of the part 000 0

Which of the following part designs would be preferred because it would result in lower production costs: a part with 10 drilled holes of the same diameter on three sides of the part a part with 10 drilled holes of five different diameters on one side of the part a part with 10 drilled holes of the same diameter on one side of the part a part with 10 drilled holes of five different diameters on two sides of the part 000 0

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

Which order arranges the following manufacturing processes from the least precise to the most precise tolerance limits?POSSIBLE ANSWERS1 . Turning, grinding, casting2 . Casting, turning, grinding3 . Casting. grinding, turning4 . Turning, casting, grinding
Need questions 13, 14, 15 explained and answered please.
Draw a product structure tree for a rolling cart using thelow-level coding scheme.Item ComponentsRolling Cart Top, leg assembly, frameTop Sheet Steel Sheet Steel Leg Assembly Legs legs (4), casters(4) Casters Wheel Wheel, ball bearing, axle, casterframe Ball bearing axle caster frameFrame Bars Bars (4)
1.How many assemblies are described by this one assembly drawing? 2. Each assembly described by this drawing uses this one part. What is its part number? 3.Which BODY is used for ASSEMBLY PRV9433T-E? 4. How many BODY options are there on this drawing? 5. How will the date code be applied to the assembly? 6. What paper size is the original version of the print? 7. Who checked the drawing? Exactly how it is on the print. 8. What is the scale of the original drawing? 9.Are there any reference measurements on the drawing? 10. Are there any cutting planes on this drawing? Thank you, please help.
You have the following information: (IMAGE) Taking into account the above, answer the following questions: 1) Calculate the safety stock that allows for 5 stockouts in a year. 2) Calculate the reorder point that will allow for these 5 stockouts in a year. 3) Calculate the number of stockouts in a year, corresponding to a safety factor of 0.84. 4) Calculate the reorder point that allows the number of stockouts corresponding to a safety factor of 0.84.
Analyse, using the results, how each component failed and justify how each component’s design could be improved. Figure 1 The 220mm-long bolt was used to fasten one of the engine mount to a supporting structure. In an effort to prevent the bolt from coming loose, the torque-prevailing nut and split pin were utilized to tighten the bolt. The bolt held through an aluminum housing. Due to the reduced stiffness of the fastened parts, the bolt supported a greater proportion of the applied force. The bolt's size necessitated a high tightening torque of 660 Nm (487 Lbft). Since this level of torque could not be achieved with the tools at the time, this torque was not specified. The aluminum's maximum bearing pressure was far exceeded by the bearing stress under the nut's head and face. As a result, there was excessive preload loss due to creep. fan shaft First of all, the fan shaft was required to be made of cold-drawn 1040 or 1045 steel with a yield strength of 586 MPa and the expected…