Which of the following is the volume of road earthwork for the ectangular cross section having 80 m length, formation width is 10.00 m, and the average depth of the road is 1.50 m? a. 120 m3 b. 1000 m3 c. 960 m3 d. 1200 m3 Next c A Ps 3,608 FEB 28

Which of the following is the volume of road earthwork for the ectangular cross section having 80 m length, formation width is 10.00 m, and the average depth of the road is 1.50 m? a. 120 m3 b. 1000 m3 c. 960 m3 d. 1200 m3 Next c A Ps 3,608 FEB 28

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Related questions

Q: Determine the cross sectional area for a 10m wide roadway at Sta 12+198 using the given cross…

A: The given data is shown below: Width of roadway=10mStation=12+198 The cross-section notes are shown…

Q: Q1/A horizontal curve with degree of curvature of 4° and intersection angle of 55°25', the PC is…

A: A curve is given between two stations with the following observations.degree of curve, D=…

Q: II. PROBLEMS 1) Module 12 - Horizontal Curves An existing highway with bearing of N20°E is to be…

Q: 1. or the embankment by using Simpson's rule. 9. (a) What are the primary elements of geometric…

A: 9. Geometric Design of Highways(a) Primary Elements of Geometric DesignThe primary elements of…

Q: A-(57.00 m) B-(60.66m) E C-(58.66m) D-(61.66m)

A: Reduced level of the point A = 57.00m Reduced level of the point B = 60.66m Reduced level of the…

Q: It is the minimum width of two-way lane national roads for new construction.

Q: Define the effect of a building collapse ?

A: Effects of a building collapse are; The collapse of a building has a great impact on victims which…

Q: Superelevation is developed over a given length of roadway, beginning with a road to being fully…

A: This question is related to the Highway Engineering and Traffic Engineering.

Q: It is the minimum width of two-way lane national roads for new construction. O 7.40 m O 6.10 m O…

A: Minimum width of the two-way lane national roads different for the different countries. In U.S.…

Q: I want a good solution and good traffic, I would appreciate it very much (descriptive geometry -…

A: descriptive geometry problem in the Diedric system.Completing the Front View of Segment ABProject…

Q: (h) The ordinates of a 2-h unit hydrograph are given below. Time (hrs) 0 2 2-h UH ordinates 0 25 4 6…

A: Given data:- Below table is given; Time (hrs) 0 2 4 6 8 10 12 14 16 18 20 22 2-h UH ordinates…

Q: such that the station of PVC IS 5+245km, PVI of 5+295kmand PVT of 5+345km. Determine the horizontal…

Q: (a) A rural collector in rolling terrain of St Vincent is to be designed in the year 2023 to carry a…

A: Note : Since you have asked multiple questions, we will solve the first question for you. If you…

Q: Three (3) proposed highways namely; Rizal Avenue, Luna Street and Mabini Boulevard with bearings of…

Q: A vertical curve on a roadway has a BVC at station 23+00 and an elevation of 900.00'. If the EVC is…

A: Given data: BVC station=23+00 EVC station=33+00 g1=4.00% g2=-3.50% Elev at station 29+00=?

Q: : Correct the following statements: Təlford navomant danth hout 25. 35 cm in The horizontal and…

Q: 9. A simple curve having a degree of curve of 4 degrees having a superelevation of 6.5%. If the…

Q: In a road upgrading project, an existing circular curve will be replaced by a combined curve. Using…

A: From the given question it is required prepare the setting out data for a road upgrading project in…

Q: Q2- Find the required area of cut/fill (m2) and Calculate the net volumes (m3) between each two…

Q: Two parallel highway roads are to be connected by a reverse curve, each section having the same…

Q: Two tangents converge at an angle 32.0 degrees, which were connected by a reverse curve having…

Q: 1. According to its functions, the highways classified in to 2. Highway location process involves…

A: 1. According to its functions, the highways classified in to three classes. They are arterial,…

Q: need

Q: What will be the shift of the transition curve, if the length of the transition curve is 80 m and a…

A: given- Radius of curve R=300 mLength L=80 m

Q: A 1800-kg truck travels at 85kph around a banked curve with a radius elevation so that the tire…

A: V=85kmph R=250m

Q: Q3. In a road upgrading project, an existing circular curve will be replaced by a combined curve.…

Q: The extra-widening required for off tracking due to rigidity of wheel base for a vehicle moving on…

A: Given - Speed of vehicle = 50 kmph Radius of curve, R = 360 m Length of vehicle, l = 6 m Number of…

Q: the radius of a horizontal curve on an existing highway is 250m.if the superelevation at the curve…

Q: Imagine a two lane highway segment with crown slopes of -1.5% and the start of the tangent runout at…

A: The radius of the curve = 408 m The design speed = 71 km/hr = 19.72 m/sThe start of the tangent…

Q: Specify the desirable values of the under listed cross sectional elements for an urban surface…

A: The desirable values of the under listed cross sectional elements for an urban surface dressed…

Q: Determine the radius and length of curve. Express your answer in decimal form.

A: Objective: To determine the radius and length of the simple curve. Given: Deflection angle (∆) =…

Q: While designing a rural road for the Safe Stopping sight Distance (SSD) for the designvehicle with…

A: The objective of the question is to calculate the Safe Stopping Sight Distance (SSD) for a rural…

Q: 1. On a divided highway with project speed of 90 kph, slopes of two red lines gi= %3,4 and g2=…

A: Solution: Given Data: Design spee V=90 kmphSlope of two red…

Q: The azimuth of the tangents of the simple curve is 514 degrees and 749 degrees respectively. The…

A: Since on a curve the road is constructed along the curve so Length of the road is equal to the…

Q: For a proposed road alignment, visibility is restricted to 257 m only. The values of various design…

A: Solution: Given: Reaction Time (RT)=2.0sec Design Speed (V)=93km/h Grade (a)=-1.9% We know that…

Q: he stabilization of roads is not done in Subgrade Base Subbase Surface Layer

A: The stabilization of roads is not done in surface layer.

Q: 2) You are the designer of a normal gage track designed to haul coal along a mountainous range. The…

A: Given:- Wheel Diameter =1000 mm Wheel Conicity = 1:30 Lateral…

Q: Station 123+00 124+00 125+00 Left/Gauche C5.25 16.50 C3.50 13.00 C0.50 7.00 Centre C5.75 C9.50 C0.50…

A: form the data given:b= 12m1) Side slope of the section;b= 12m,half width= 12/2= 6m.for 123.00…

Q: 3.Anexisting 6.0 m wide single carriageway road with 0.5m wide verges (see Fig. 1.1) has a layout as…

A: The width of the single carriageway = 6 m The verge width = 0.5 mThe length of the section of…

Q: Given a two-dimensional blunt wedge immersed in a water stream, velocity profiles are measured both…

A: Solution:-

Q: the three numbers calculate: i. the chainage points of the setting out pegs along the curve; ii .…

A: The chainage of A = 71.249 mThe deviation angle Chainage length, l = 50mThe radius of the circular…

Q: 8.Transitional flow occurs 2700<Re<4000 true O False

A: The flow is called as : Laminar flow , when Re < 2300 Transitional flow, when 2300 < Re <…

Q: Level ‘A’ = 95 m AHD Chainages ‘A’ = 850 m; ‘B’ = 940 m; ‘C’ = 913 m Horizontal distance ‘AB’ = 90 m…

A: Level A =95 m AHD Chainage, A=850 m AHD Chainage, B=940 m AHD Chainage, C=913 m AHD Chainage, D=1010…

Q: graph, and box your final answer. SIT. 1 Two tangents intersect at statio A compound curve laid on…

Q: As shown in the figure below, a horizontal alignment consists of two tangent lines smoothened by a…

A: Given:Station PC is at 20+30.00Station PT is at 24+00.00Super elevation = 210 ft

Q: Given a divided, 6-lane highway, what is the total lateral clearance (ft) if there is 8 ft of…

A: Reference : Highway Engineering, Divided highway lane Code : HCM Highway Capacity Manual 2000 To…

Question

100%

Which of the following is the volume of road earthwork for theectangular cross section having
80 m length, formation width is 10.00 m, and the average depth of the road is 1.50 m?
a. 120 m3
b. 1000 m3
C. 960 m3
d. 1200 m3
Next page
3,608
FEB
28
M A Ps V
(30

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Solution

VIEW

Explanation

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

Plz answer
None
12. For a 3-hr unit hydrograph, determine a 3-hr S-Curve? 18 24 Time (hours) 0 Q(cfs/inch) 0 6 12 30 100 40 0
The vertical alignment of a highway is shown in the figure below. Determine the elevatios of stetion -00 00 s the curve 91=-2.0% 9: +6.0% BVC EVC Stat 91+00.00 Stat 82+00.00 PVI ELEV 100.00 109.11 O 110.11 100.11 O 102.11
A temporary, 2 lane road is to be built connecting the 2 westbound lanes of Highway 1 near Tompkins, Saskatchewan with the parallel 2 eastbound lanes, 600 metres to the south (centreline to centreline). This temporary road is comprised of two equal circular, horizontal curves connected by a tangent section, which has a bearing of 045°. For the following data: radius of curvature=500m; maximum superelevation=0.04m/m; maximum side friction=0.12; lane width=3.70m. Find: i) the design speed of the curved sections and ii) the total length of the new pavement required
If any charts or graphs where use please Imsert below and explain how it’s used
I. Favorite. Solve the following. No Solution No Credit. Express your answer in the nearest 3 Decimal Numbers A. Reversed curve with diverging tangents is to pass through three lines to form a center line of a proposed road. the first line AB has a bearing of N 88° E. and a distance of 125 m., BC has a bearing of N 60° E and a distance of 350 m., while on that of CD has a bearing of S 40° E and a distance of 305 m. If the first tangent has a distance of only % of the common tangent measured from the point of intersection of the first curve determine the radius of the curves and station of PT if PC is 12 + 350
Baras Highway is a Class III Two-lane highway that is considered a level terrain. Based on the data, 983 passenger cars travel on average per hour for both directions with a directional split of 80/20. The traffic stream contains 6% large trucks, 5% buses, and 3% recreational vehicles. Assume PHF = 1.0. Determine the analysis direction flow rate in pc/hr. Answer in two decimal places. 795.05 818.6424 margin of error +/- 0.5
While designing a rural road for the Safe Stopping sight Distance (SSD) for the designvehicle with an operating speed of 85 km/h, the design team (comprising Team leader,Design Engineer, Technician, Traffic Engineer, Surveyor and other team members) needsto consider the road segment to be an unsealed up-grade road with longitudinal slope 3%and reaction time is 2.5 s. How much safe stopping sight distance is required for that roadsection?
BT- PC /-- PI LC T 100 Da R R PI T E T PC MO PT LC R 0 R PT FT Given: PI Station 107+67.90 A = 11° 00' 00" Da = 2° 30' 00" Compute the Radius (R), the Tangent (T), Length of Curve (L), Long Chord (LC), External (E), Middle Ordinate (MO), the station for the Point of Curvature (PC) and the Station for the Point of Tangency (PT). Compute in tabular form the deflection angles, the short chords and long chords to layout the curve at half stations (50 ft. interval
Question 2- the corner of a building next to a horizontal curve with a radius 40 m on a rural highway. The inside lane is 3 m wide and the edge of the road shoulder is 2 m from the corner of the building. The shoulder width is 1.2 m. Determine what speed limit should be imposed on this section of the highway. (63+2.53) (36 +847) + (83+3-33)/ (120 +08) Sight Distance (5) 94 100 (100-00)-(63+2.53) (36 +97.47 Highway Centerline- Line of Sight HSO -Centerline of Inside Lane 20 Shoulder Sight Obstruction 550 HS0 =3m+ 2m +12m 35km/ (footoo)-(63+2-53)