Which of the following is false?Resistance is the measure of how much a conductor resists the flow of charges.O The resistance in an open circuit is zero.O The resistance in a short circuit is infinity.More than one of the above.O None of the above.

(A) Resistance of a conductor is the measure of how much the conductor resists the flow of…

Which of the following is false? Resistance is the measure of how much a conductor resists the flow of charges The resistance in an open circuit is zero. O The resistance in a short circuit is infinity. O More than one of the above. O None of the above.

Which of the following is false? Resistance is the measure of how much a conductor resists the flow of charges The resistance in an open circuit is zero. O The resistance in a short circuit is infinity. O More than one of the above. O None of the above.

Physics for Scientists and Engineers, Technology Update (No access codes included)

9th Edition

ISBN:9781305116399

Author:Raymond A. Serway, John W. Jewett

Publisher:Raymond A. Serway, John W. Jewett

Chapter28: Direct-current Circuits

Section: Chapter Questions

Problem 28.9OQ: When resistors with different resistances are connected in parallel, which of the following must be...

See similar textbooks

Similar questions

When a straight wire is heated, its resistance changes according to the equation R = R0 [1 + (T T0)] (Eq. 17.7), where is the temperature coefficient of resistivity. (a) Show that a more precise result, which includes the length and area of a wire change when it is heated, is R=R0[1+(TT0)][1+(TT0)][1+2(TT0)] where is the coefficient of linear expansion. (See Topic 10.) (b) Compare the two results for a 2.00-m-long copper wire of radius 0.100 mm, starting at 20.0C and heated to 100.0C.
When resistors with different resistances are connected in parallel, which of the following must be the same for each resistor? Choose all correct answers, (a) potential difference (b) current (c) power delivered (d) charge entering each resistor in a given time interval (e) none of those answers
A child's electronic toy is supplied by three 1.58-V alkaline cells having internal resistances of 0.0200 inseries with a 1.53-V carbon-zinc dry cell having a 0.100- internal resistance. The load resistance is 10.0 . (a) Draw a circuit diagram of the toy and itsbatteries, (b) What current flows? (c) How much power is supplied to the load? (d) What is the internal resistance of the dry cell if it goes bad, resulting in only 0.500 W being supplied to the load?
A heart defibrillator passes 10.0 A through a patient’s torso for 5.00 ms in an attempt to restore normal beating, (a) How much charge passed? (b) What voltage was applied if 500 J of energy was dissipated? (c) What was the path’s resistance? (d) Find the temperature increase caused in the 8.00 kg of affected tissue.
2 | 3 I| I 4 III I 5 7. How much voltage is needed to produce a current of 6.0 A through a 24 V resistor? A. 4 V B. 18 V C. 30 V D. 144 V D because when you use the formula which is V-IR and you plug in the variables. V (6)(24) V = 144V and work is on paper. 8. A short copper rod has a neutral charge. Negative charges are then applied to the right end of the rod. Which of the following describes the charge on the copper rod 5 s later? A. Both ends of the rod have a positive charge. B. The negative charge is spread evenly along the rod. C. Only the right end of the rod has a negative charge. D. All of the positive charge is in the middle of the rod. 9. A simple circuit is made using a battery, a light bulb, and some wire. Based on Ohm's law, which of the following should always decrease the brightness of the light bulb? A. using less wire in the circuit C. adding a second bulb in parallel B. adding a second bulb in series D. using a battery with a greater voltage DELL
A) if a current in a wire is 5.0 A, how many coulombs of charge pass a point in the wire in 1 min? B) what is the current if 6.0x10^3 C pass a point in a circuit in 10.0 min? C) if a current in a circuit is 12 A , how many electrons pass a point in 1h?
23
In a circuit, the total resistance is smaller than the smallest resistance in the circuit. O series. O parallel. both (A) and (B). O none of the above
in the circuit below, if R3 > R₂ > R₁, R₂ then: Select one: R₁ m a. V₂ > V₂ = V₁ b. V₂ > V₂ > V₁ c. V3 V₁ R3 E
The figure shows a circuit with two batteries and three resistors. Determine the magnitude of the current through resistor R₂ if the battery emfs and resistances are: &₁ 12 V, &₂ = 15 V, R₁ = 92, R₂ = 5 2, and R3 = 80. = E₁ E₂ + R₁ ww R₂ www Q ✰ ✰ R3 II || [Tip: Start by using Kirchhoff's node and/or loop rules to write a system of three equations for the three branch currents. Then solve the system either analytically or using a solver like Matlab, etc.] :
8
When resistors are connected in series, the potential differences across the resistors is O A) V=V1 + V2 + V3 +..... O B) None of them O C) V=V1=V2=V3=... O D) V= zero O E) V=V1 x V2 x V3 x...