Answered: Which of the following factors will, if…

Related questions

Question

Which of the following factors will, if increased, make it more difficult to produce a certain amount of current in a conductor?

D. the average time between collisions for a typical moving charged particle.

C. the amount of charge on each moving particle

B. the number of moving charged particles per cubic meter

A. the mass of the moving charged particles in the conductor

Expert Solution

Step by step

Solved in 3 steps

SEE SOLUTION Check out a sample Q&A here

Similar questions

A defibrillator passes 10.5 A of current through the torso of a person for 0.011 s. How much charge moves in C? How many electrons pass through the wires connected to the patient? e- -911+²
A current of 9.00 A flows in a conductor for 4.5 s. How much charge passes a given point in the conductor during this time?
What is galvanization (galvanotherapeutics)? O a. Galvanization is a method that uses low voltage and high strength direct current action. O b. Galvanization is a method of sterilizing medical instruments based on the action of an electric current. O c. Galvanization is a physiotherapeutic method that uses an action based on a low voltage direct current (U = 30-80 V) and low power (I <50 mA). O d. Galvanization is a method of short-term exposure to the body with high voltage altemating current.
A flashlight, which uses a 3.0 V battery, is turned on for 2.0 minutes. If the current in the flashlight is 100 mA, what is the energy dissipated? A. 121 J B. 9.0 J C. 72 J D. 36 J
I_2 is the current travelling through the 2 Ohm resistor. I_4 is the current travelling through the 4 Ohm resistor I_5 is the current travelling through the 5 Ohm resistor A. What is the magnitude of I_2? B. What is the magnitude of I_4? C. What is the magnitude of I_5?
Which of the following is an installation requirement for the grounding electrode conductor in a communications system? A. It must be run as straight as practicable. B. It must be, at minimum, 4 AWG. C. It must be solid or stranded aluminum. D. It must be isolated and covered.