coursesITNT201-Sem2-Sec3-YAAssessmentsPractical Quiz (10)Which command will configure GO/2 to be a routed port and not a switching port?O int GO/2no switchportO int G0/2shutdownO int G0/2ip switchportO int GO/2no portPractical Quiz (1

To Configure the G0/2 we use the int G0/2 .

Answered: Which command will configure G0/2 to be…

Engineering

Computer Science

Which command will configure G0/2 to be a routed port and not a switching port?

Database System Concepts

7th Edition

ISBN:9780078022159

Author:Abraham Silberschatz Professor, Henry F. Korth, S. Sudarshan

Publisher:Abraham Silberschatz Professor, Henry F. Korth, S. Sudarshan

Chapter1: Introduction

Section: Chapter Questions

Problem 1PE

See similar textbooks

Related questions

Q: In what ways do interfaces benefit the user? Instead than using class objects, why not create them…

A: Answer the above question are as follows

Q: Why do branch statements cause a delayin pipelining? What is one technique that can be used to…

A: Consider instruction executing sequentially and suddenly branch for example bne, branch if not zero…

Q: If you wanted to take a class C network ID and subnet it into 5 subnets with each subnet 20…

A: Solutions are given below :

Q: Which VLAN on a switch manages untagged frames?

A: Virtual Local Area Network managing untagged frames Virtual Local Area Network (VLAN) is a logical…

Q: What is the command used in Cisco switch to make an interface full duplex?

A: Required: What is the command used in Cisco switch to make an interface full duplex?

Q: Based on the partial output of the Router# show frame relay pvc comman the graphic, which output…

A: Based on the partial output of the Router# show frame relay pvc command shown in the graphic,

Q: if host1 send a connection request at t=1 and host2 send a connection request at t=1 in TCP…

A: if host1 send a connection request at t = 1 and host2 send a connection request at t = 11 TCP…

Q: What TCP message will be sent in response to an incoming SYN request for which no LISTENING port…

A: Answer :

Q: Refer to the below exhibit. What protocol should be configured on SW-A Port O/1if it is to send…

A: Lets see the solution.

Q: e a CISCO PT command to implement a standard or extended ACL in a Router interfac

A: Given:- Write a CISCO PT command to implement a standard or extended ACL in a Router interface?…

Q: AN technique gives physical po

A: Below VLAN technique gives physical ports addresses?

Q: cmdlet with the When executing the Test-NetConnection "-Common TCPPort" parameter, which of the…

A: The following solution is

Q: Which RG raging is used for Ticknet

A: RG-8 is used for 10base5 Ethernet networking (also called Ticknet).

Q: Which of the protocol will not buffer out of order packets?

A: 1) Network protocols are sets of rules and conventions that govern communication and data exchange…

Q: A hacker just set up a TCP connection with a web server in Chicago, Illinois, claiming he is coming…

A: TCP (Transmission Control Protocol) connection is a communication protocol that establishes a…

Q: What is the purpose of the switch keyword in React Router v4?

A: ReactJS is a javascript library used to build single-page applications. Routing is implemented in…

Q: Your Network Administrator has contacted you to assist in examining a workstation that has been…

A: Introduction: The scenario described involves a workstation that has been experiencing network…

Q: How many collision domains are created when you segment a network with a 12-port switch?

A: Dear Student, The number of collision domains created is given below - For each port one collision…

Q: bu observe that the following packets are transmitted from different egress ports of an 8-port switc…

A: A) The binding between the MAC Adress and the port number- Fwd -: MAC PORT 60 0 70…

Q: Why switch keyword used in React Router v4?

A: React is a javascript library for making single-page apps (SPA). The routing features of React are…

Q: Which statement best describes Static/Port Centric VLANs? a. Rarely used as it needs a lot of time…

A: Solution : Which statement best describes Static/Port Centric VLANs ? Answer : Correct Answer -…

Q: How many snort rules are there? Explain in details

A: There are five available default actions in Snort, alert, log, pass, activate, and dynamic. You can…

Q: Use given Figure 1 to configure a two-router network. All router configurations must be assumed and…

A: Actually, IP stands for Internet Protocol..

Q: a. Write the command to enable IPv6 unicast routing in both routers (lmark) b. Enable OSPFv3 on all…

A: According to Bartelby guidelines we are suppose to answer only 3 sub part of the question at a time.…

Q: How will you display the active TCP connections? Write the command and attach the screenshot.

A: Required: How will you display the active TCP connections? Write the command and attach the…

Q: Which one of the following mechanism can be used to prevent a sigle point of failure at the default…

A: According to the asked question, the solution is given below with a proper explanation.

Q: ou have connected 2 routers using fasthernet interfaces but cant see the routes of each others…

A: you do not need to set clocking on fastethernet interfaces. If you want this particular link to be…

Q: How will you find the full TCP/IP configuration of all network adapters (Ethernet cards) which are…

A: The problem is about finding the configuration of all the adaptors which are installed in your…

Q: Which VLAN on a switch is responsible for managing untagged frames?

A: INTRODUCTION: It is possible to create a virtual local area network (VLAN) to link devices that are…

Q: Which one of the following mechanism can be used to prevent a sigle point of failure at the default…

A: given... question is Which one of the following mechanism can be used to prevent at point of failure…

Q: Which of the following statements is NOT true about TCP SYN/ACK host scanning attacks? Question…

A: Option a) is true as Attacker sends a TCP SYN/ACK segment to a target host repeatedly to all ports…

Q: Which protocol is used the majority of the time when bonding ports between a busy server and a…

A: Link Aggregation Control Protocol is an IEEE standard defined in IEEE 802.3ad. LACP allows devices…

Q: Question p 1. What TCP port did the old AOL IM program run on and was referenced in the PCAP…

A: What TCP Port Did AOL IM Use?: AOL Instant Messenger (AIM) used a specific "door" on the internet to…

Q: On a 2960 switch interface, the command is used to configure a trunk port?

A: Introduction: A trunk port is a form of switch connection that is used to connect a VLAN-aware guest…

Concept explainers

VLAN

VLAN stands for Virtual Local Area Network, and it is created from one or more local area networks. A Virtual Local Area Network (VLAN) is a customized network made up of one or more LANs. It allows a set of devices from different networks to be converted into a single logical network. As a result, a virtual LAN that is managed similarly to a physical LAN emerges.

Question

courses
ITNT201-Sem2-Sec3-YA
Assessments
Practical Quiz (10)
Which command will configure GO/2 to be a routed port and not a switching port?
O int GO/2
no switchport
O int G0/2
shutdown
O int G0/2
ip switchport
O int GO/2
no port
Practical Quiz (1

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, computer-science and related others by exploring similar questions and additional content below.

Similar questions

Which of the following congestion control mechanisms is based on "probing for bandwidth" , i.e., it increases the transmission rate on the receipt of ACK, until eventually loss occurs; then it decreases the transmission rate? a. Traffic Throttling b. Traffic-Aware Routing c. TCP Congestion Control d. Admission Control
Does a VLAN need a separate IP address on different switches? For example if I have a VLAN 10 name user10 would I need a separate IP address for each switch?
Used as OSPF Router ID walk through the items in the hello packet how they need to unique id?
NEED URGENT HELP! PLEASE DUE AT MIDNIGHT HELP TCP's protocol includes eight 1-bit control flags. Select each of the flags that are set at some point during the connection establishment process. ANSWER CHOICES (SELECT ALL THAT APPLY): CWR ECE URG ACK PSHRSTSYN FIN TCP's protocol includes eight 1-bit control flags. Select each of the flags that are set at some point during the connection teardown process. ANSWER CHOICES (SELECT ALL THAT APPLY): CWR ECE URG ACK PSHRSTSYN FIN THANK YOU
Which protocol is most frequently used to connect ports on a switch to a busy server?
A device on your network has an Ethernet NIC and is configured with a static IPv4 address. Which two of the following IPv4 parameters will be included in the setup of the computer's IPv4 address? Traceroute server's hostname was entered. DHCP Server address PC's private IP address DNS server address?
Which of these is used to trigger retransmissions in TCP protocol ? POP timeout Pipelining ACK
Which one of the following is an advantage of PVST+? O PVST+ requires fewer CPU cycles for all the switches in the network. O PVST+ reduces bandwidth consumption compared to traditional implementations of STP that use CST. O PVST+ optimizes performance on the network through load sharing. O PVST+ optimizes performance on the network through auto selection of the root bridge. Based on the following configuration: switch(vlan)# vtp version 2 switch(vlan)# vtp mode server switch(vlan)# vtp domain Cisco switch(vlan)# vtp password mypassword Which of the following statements is correct? O This switch can create, modify, and delete all VLANS within the Cisco domain O This switch maintains a full list of all VLANS and can create VLANS, but cannot delete or modify existing VLANS. O The password will prevent unauthorized routers from participating in the Cisco domain. O This switch can advertise its VLAN configuration to other switches in the Cisco domain only, but can receive advertisements…
Question 5: You are working as a network engineer at Shell Into, The organization uses Cisco's 1OS on all of its workstations. The network administrator has asked you to use the route utility to delete some static routes used by the router Which of the following commands will you use in this scenario? O show ip route show rurning-config route print route
A network administrator is determining untagged, port logic for a frame addressed to a port in the same vlan on the same switch, what would happen? A. Forwarded to trunk. B. No tag is Added C. Tag is stripped D. The packet is dropped
Which protocol is used the majority of the time when bonding ports between a busy server and a switch?
What TCP message will be sent in response to an incoming SYN request for which no LISTENING port exists? What kind of error will the program that requested the connection receive?