Answered: When the current in an R-L circuit is… | bartleby

Related questions

Question

When the current in an R-L circuit is decaying, what fraction of the original energy stored in the inductor has been dissipated after 2.3 time constants?

Expert Solution

Trending now

This is a popular solution!

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Blurred answer

Similar questions

A loop of wire has a self-inductance of 5.5 mH. You pass a current of 9.0 Amps though the loop, and then drop the current to 0 at a contastant rate over 3.5 seconds. What is the EMF generated?
What is the relationship between a sinusoidal current and a sinusoidal voltage in an inductor?
If the inductance in the circuit shown below is 250mH and the current in the circuit reaches half its maximum value 1.5ms after the switch is closed, (a) what is the time constant of the circuit? (b) what is the resistance of the circuit? Int
A V = 86-V source is connected in series with an R = 1.8-kΩ resistor and an L = 26-H inductor and the current is allowed to reach maximum. At time t = 0 a switch is thrown that disconnects the voltage source but leaves the resistor and the inductor connected in their own circuit. 1) How much time, in milliseconds, is needed for the current in the circuit to drop to 12 % of its value at t = 0? 2) How much energy, in millijoules, does the circuit dissipate during that time?
Suppose you have a supply of inductors ranging from 1.00 nH to 10.0 H, and resistors ranging from 0.100 Ω to 1.00 MΩ. What is the range of characteristic RL time constants you can produce by connecting a single resistor to a single inductor?
A constant voltage of 11.00 V has been observed over a certain time interval across a 2.30 H inductor. The current through the inductor, measured as 1.00 A at the beginning of the time interval, was observed to increase at a constant rate to a value of 8.00 A at the end of the time interval. How long was this time interval?
A 17.0 μF capacitor is charged by a 130.0 V power supply, then disconnected from the power and connected in series with a 0.280 mH inductor. Calculate the energy stored in the inductor at t = 1.30 ms .