When its 75-kW (100-hp) engine is generating full power, a small single engine airplane with mass 700 kg gains altitude at a rate of 2.5 m/s (150 m/min, or 500 ft/min). What fraction of the engine power is being used to make the airplane climb (the rest is used to overcome drag and friction)?

When its 75-kW (100-hp) engine is generating full power, a small single engine airplane with mass 700 kg gains altitude at a rate of 2.5 m/s (150 m/min, or 500 ft/min). What fraction of the engine power is being used to make the airplane climb (the rest is used to overcome drag and friction)?

College Physics

11th Edition

ISBN:9781305952300

Author:Raymond A. Serway, Chris Vuille

Publisher:Raymond A. Serway, Chris Vuille

Chapter1: Units, Trigonometry. And Vectors

Section: Chapter Questions

Problem 1CQ: Estimate the order of magnitude of the length, in meters, of each of the following; (a) a mouse, (b)...

See similar textbooks

Similar questions

A skier of mass 71 kg is pulled up a slope by a motor-driven cable. (a) How much work is required to pull him 40 m up a 30° slope (assumed frictionless) at a constant speed of 1.8 m/s? kJ(b) What power (expressed in hp) must a motor have to perform this task? hp
A 64.0 kg cheetah accelerates from rest to its top speed of 32.5 m/s. (a) How much net work (in J) is required for the cheetah to reach its top speed? (b) One food Calorie equals 4186 J. How many Calories of net work are required for the cheetah to reach its top speed? Note: Due to inefficiencies in converting chemical energy to mechanical energy, the amount calculated here is only a fraction of the energy that must be produced by the cheetah's body.
You are out on a nice bike ride in the mountains. You and the bicycle together have a mass of 83 kg. Up ahead, there is a huge hill to climb. You stop and drink some water and start to climb. The climb is very hard work. You entertain yourself with your nifty bike computer, which is reporting a power output of 400.0 W! At the end, you've climbed 128 m vertically in 4 minutes and 32 seconds! a) Assuming your power output was constant, how much work did you do during your climb? b) What is the energy transfer equation during this climb? c) Assuming your power output was constant, and no energy was lost, what was your final kinetic energy (remember you started off at rest?
A 55-kg marathon runner runs up the stairs to the top of Taguig’s 318-m Grand Hyatt Manila, the tallest building in the Philippines (as of 2017). To lift herself to the top in 20 minutes, what must be her average power output? Express your answer in watts, kilowatts, and horsepower.
The aircraft carrier USS George Washington has mass 1.0 ×108kg. When its engines are developing their full power of 260,000 hp, the George Washington travels at its top speed of 35 knots ( 65 km/h). If 68 % of the power output of the engines is applied to pushing the ship through the water, what is the magnitude of the force of water resistance that opposes the carrier’s motion at this speed?
A 3 kg block is sliding across a horizontal surface. The initial speed of the block is 4 m/s, but because of friction the block’s speed will decrease at a constant rate (i.e., constant acceleration) until the block finally comes to a stop after sliding 8 m. What is the average power (in W) supplied by friction as the block slows to a stop?
When an automobile moves with constant speed down a highway, most of the power developed by the engine is used to compensate for the mechanical energy loss due to frictional forces exerted on the car by the air and the road. If the power developed by the engine is 195 hp, estimate the total friction force acting on the car when it is moving at a speed of 30 m/s. One horsepower equals 746 W.
What average mechanical power (in W) must a 60.0 kg mountain climber generate to climb to the summit of a hill of height 365 m in 49.0 min? Note: Due to inefficiencies in converting chemical energy to mechanical energy, the amount calculated here is only a fraction of the power that must be produced by the climber's body. HINT
A motorcyclist drives up a 3.1-meter tall ramp and leaves the ramp with a speed of 42.5 m/s. If his speed is 37.8 m/s when he reaches the peak of his path, what is the maximum height (in m) above ground that he reaches? (Use energy, not kinematic equations.)
A skier of mass 61 kg is pulled up a slope by a motor-driven cable. (a) How much work is required to pull him 80 m up a 30° slope (assumed frictionless) at a constant speed of 2.9 m/s? KJ (b) What power (expressed in hp) must a motor have to perform this task? hp
A car of mass 800.0 kg accelerates away from an intersection on a horizontal road. When the car speed is 39.6 km/hr (11.0 m/s), the net power which the engine supplies is 3900.0 W (in addition to the extra power required to make up for air resistance and friction). Calculate the acceleration of the car at that time.
A skier of mass 77 kg is pulled up a slope by a motor-driven cable. (a) How much work is required to pull hìm 45 m up a 30° slope (assumed frictionless) at a constant speed of 1.9 m/s? kJ (b) What power (expressed in hp) must a motor have to perform this task? hp