When an antenna is transmitting an unmodulated carrier, then the current is 10 amps and when the antenna is transmitting amplitude modulated signal, then the current is 15 amps. Estimate the modulation index. Round the answer to the nearest tenth.

Q: Figure (1) shows the block diagram of a wideband frequency modulator using the indirect method. This…

A: As per our company guidelines we are supposed to answer only first question kindly repost other…

Q: Figure 1 shows a signal obtained after amplitude modulation by a sinusoidal message. The carrier…

A: Step 1: Step 2: Step 3: Step 4:

Q: Calculate the modulation index for an FM wave where the maximum frequency deviation is 50 kHz and…

A: Given: In FM wave, The maximum frequency deviation, ∆f=50 kHz The modulating frequency, fm=5 kHz

Q: What is the dominant mode of an EM wave in a parallel-plate waveguide?

A: What is the dominant mode of an EM wave in a parallel-plate waveguide? The dominant mode of an EM…

Q: Figure (1) shows the block diagram of a wideband frequency modulator using the indirect method. This…

A:

Q: Determine n and the percentage of the total power carried by the sidebands of the AM wave for tone…

A: It is given that:

Q: FM modulator is used to transmit a cosine message signal with 4V amplitude and 20Hz frequency. The…

A: Given, A frequency modulator has, Message signal amplitude (Am)= 4  Message signal frequency (fm)=…

Q: 1. An FM signal has a maximum frequency deviation of 25kHz and is modulated by a sine wave with a…

A:

Q: A superheterodyne receiver tunes at the frequency range from 25 MHz to 50 MHz. The intermediate…

A:

Q: Calculate the modulation index (in kHz/V) in an

A: Given - Modulating amplitude = 9.3V frequency deviation = 75.1 kHz

Q: a) A 1V 5 kHz signal is put into a low pass filter with a cut-off frequency of 2 kHz. What will the…

A: In this question We need to determine the output signal of the filter.  We know,  LPF passes only…

Q: A 100MHZ carrier is frequency modulated by 1 KHz wave. For a frequency deviation of 50 KHz,…

A: The solution can be achieved as follows.

Q: 7- In FM modulation, what is the value of the frequency deviation, if the amplitude of the…

A: The solution is given below

Q: Using MATLAB. Generate a square wave signal whose peak amplitude is 1 V, frequency of 1000 Hz, and…

A: Given an electrical signal with following information, Type: Square wave Amplitude = 1 Signal…

Q: When an antenna is transmitting an unmodulated carrier, then the current is 10 amps and when the…

A: It is given that: It=total or modulated current=15 AIc=carrier or unmodulated current=10 A

Q: Question: The maximum deviation allowed in an FM broadcast system is 75 kHz, If the modulating…

A: FM is a type of modulation where variations in the carrier wave frequency immediately translate into…

Q: The figure below shows a satellite receiver uses two hytrodyne operations. It is used to receive…

A: For the given figure. all possible image frequencies are determined as shown below

Q: Answer the following questions about oscillating electrical signals (alternating current or…

A:

Q: thank you

A: Step 1:Step 2:Step 3:

Q: signal using DSB-AM. Determine the bandwidth needed to transmit 99% of a 4 Hz square wave

A: We need to find out bandwidth for given signal for given modulation .

Q: A FM signal has a carrier swing of 100 kHz when the modulating signal has a frequency of 8 kHz. The…

A: Modulation is process by which some properties of carrier signal is varied according to modulating…

Q: a) What is this circuit? b) Is there an RF signal across R2? c) Draw the expected signal waveform…

A: Given the circuit, as shown below: a) We need to explain what is the circuit. b) We need to explain…

Q: The AM modulation of a single frequency sinusoid (single tone information single) result in A single…

A: The AM modulated signal of single frequency sinusoidal (single tone information signal) is expressed…

Q: | DSBSC signal generation using square wave information sign İnformation: 4 Vp-p 2 kHz square wave…

A: According to question we have to find how many sinc wave does the DSBSC signal consist of and what…

Q: 1. The phase shift between fi(t) and f:(1) in QAM is a. 90° b. 180° c. 270 d. 360

A: Since we only answer one question at a time. we’ll answer the first question only.Please resubmit…

Q: di len Volt/div = 65 V for red signal, Volt/div = 24 V for blue signal and Time/div = 64 s. What is…

A: Two signals waveform are shown in the figured.  Find the phase difference between both signals.

Q: Information: (2 Vp-p 50 Hz + 2 Vp-p 100 Hz) sine wave Carrier: 4 Vp-p 1000 Hz sine wave What…

A: information: 2Vp-p 50Hz+2Vp-p 100Hz sine wave carrier: 4Vp-p 1000Hz sine wave properties of…

Q: signal if the maximum voltage is 90 V and the minimum voltage is

A:

Q: 3. What is the best value for the modulation index, k. What will happen if B> A?

A: The best value for the modulation index, k, depends on the specific modulation scheme and…

Q: single side spe ctrum for Home worlc: s ketch the function. the same 6 - 16

A:

Q: 7-11 A90-MHz carrier is to be frequency modulaled by a 2-kHz tone. The maximum frequency deviation…

A: Brief description : Modulation technique is one of the major advantage which is exist in the…

Q: When an antenna is transmitting an unmodulated carrier, then the current is 10 amps and when the…

A: Given: Current while transmitting an unmodulated carrier I0=10 A Current while transmitting…

Q: Please explain the waveforms, what are the reason why does the 3rd waveform (Recovered signal) is…

A: A waveform is usually a graphical representation of the shape of a wave representing its…

Q: It's simply the proportion of the actual frequency deviation to the maximum frequency deviation.

A: Percent modulation is the proportion of the actual frequency deviation to the maximum frequency…

Q: A desired signal at 26.2 MHz is mixed with a local oscillator of 42.0 MHz. What is the image…

A: Given: Desired signal frequency, ftrx=26.2 MHz Local oscillator frequency, f0=42.0 MHz

Q: You are given a dual-mixer AM demodulator as designed below: x(t) z(t) LPF ()' cos(mt) Σ y(t) AM…

A: (e)  Given, ∅AM(t)=Ac+m(t)cos(ωct+θ) In the given design, there is two product modulator that is…

Q: Plz  solve within 30 min I vill upvote Choose answer from  A. 12.25 B 15 C 6.25 D 7.5

A: Given,  Frequency deviation, ∆f = 50 KHz Modulating frequency, fm = 8 KHz

Q: Question 9 The AM modulation of a single frequency sinusoid (single tone information single) result…

A:

Q: Make an essay about "how filter circuits for AC and DC power supply works"

A: A filter circuit is a circuit used for filtering out AC voltage variations in a rectifier circuit.

Antenna Characteristics

The antenna is an important concept in the domain of electronics and communication engineering. An antenna forms an integral part of many commonly used devices such as wireless modems, routers, game controllers, mobile phones, bluetooth devices, and so on. In simple terms, any wireless communication makes use of antennas to serve the purpose. An antenna, also known by the term 'arial', is an electrical device that converts electrical signals into electromagnetic waves or electromagnetic waves into electrical signals. An antenna contains a transmission line usually made up of co-axial cable, it then receives the signals and converts them into electromagnetic waves, which are then transmitted via space into their required destination. A communication system essentially makes use of two antennas, a transmission antenna, which converts electrical signals into electromagnetic waves, and a receiving antenna, which receives the electromagnetic waves and converts them back into electrical signals.