What will be the inductance of each conductor in a three phase, 3 wire system when they are arranged in a horizontal plane with spacing such that D31= 4m, D12 = D23 = 2m. The conductors are transposed and * .have a diameter of 2.5 cm 0.111 mH 1.11 mH 11.1 mH 0.00111 H

What will be the inductance of each conductor in a three phase, 3 wire system when they are arranged in a horizontal plane with spacing such that D31= 4m, D12 = D23 = 2m. The conductors are transposed and * .have a diameter of 2.5 cm 0.111 mH 1.11 mH 11.1 mH 0.00111 H

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Related questions

Q: 10 minute presentation on Tidal renewable energy

A: Tidal Renewable Energy PresentationSlide 1: IntroductionTitle: Harnessing the Power of Tides: An…

Q: What's the self-inductance of a solenoid with 697 loops wrapped around a cylinder. The cylinder has…

Q: Redo it again with full details..

A: Given: 3:8 Decoder To find: we have to form the truth table for 3:8 decoder.

Q: A right triangle has an angle of 32 degrees and the side opposite measures 12, what is the length of…

Q: 2 LOAD1 Sy= 75 MVA cosp=0.95 back XH = j 144,4 ohm 125 MVA LOAD2 Sy= 25 MVA cosp=0.9 back 150 MVA…

Q: 9. [(2260)/(15Z-75)]+[(1.2+j1.2)/(4.2+j2.4)]

Q: The bridge method commonly used for measuring mutual inductance is: A. wheat stone bridge B. Wien…

A: Given Bridges, A. wheat stone bridge B. Wien bridge C. De Sauty bridge D. Heaviside campbell bridge

Q: What are the differences between natural fractures and induced fractures on the core? a) Surfaces of…

Q: Four conductors meet at a junction. the current are i1= 5sinwt, i2= 3sin(wt + 90) and i3=…

A: The solution can be achieved as follows.

Q: A series RL circuit has a resistance of 6 ohms and a inductive reactance of 10 ohms. If connected…

A: It is given that: R=6 ΩXL=10 ΩV=120 V

Q: In a 10 km long three phase conductor diameter of 2.5 mm the conductors are arranged symmetrically…

Q: Practically in the field, the transmission line connected between the generating station and…

A: We need to tell about transmission line between generation and substations

Q: In a circle of radius 2 rods, the length of the arc subtended by a central angle of 150° is…

A: Given data, Radius r= 2 rods Angle is given, θ=1500

Q: admittance Y=0.06 - j0.08 mho, then conductance is

A: Given:- AdmitanceY=0.06-j0.08 mho To find:- Conductance

Q: Two impedances, Z1 = 2+j6 N and Z2 = 6-j12 N are connected in series with a 220-V 60-Hz supply. At…

Q: FIND THE VALUE OF Rab IN THE CKT. 22 222 ·30 a-M ## Rab $20 bo se 10002

Q: A non magnetic medium has an intrinsic impedance 360Z30° Q. The loss tangent is

A: Wave is function of space and time. Frequency below which attenuation occur and above which…

Q: Explain briefly why is the source (total) voltage almost the same as the voltage across the…

Q: for 下e energy FiND Tellowing Synal ン(り- loe もろ0 the -ヒ loe くo

Q: eactance of this circuit? what is the inductive 12 when a inductor and resistor are connected in…

Q: Determine the electric field intensity midway Q3 Q1 = 10C B A 4R Q2 = 5C 5R

Q: Mutual inductance between an infinite current filament placed along y -axis and rectangular coil of…

Q: For a ferromagnetic materials to become magnetic it's magnetic domains must be aligned

A: When ferromagnetic material is magnetized, some of the magnetic domains align parallel to one…

Q: Sinusoidal voltage (or emf) is generated by rotating a conductor by means of a spindle in a uniform

A: In this question we need to complete the given statement .

Q: Each conductor of a 3-0 overhead line is suspended from a cross arm of a steel to a string of 4…

Q: ()Analyze the caremnt beluwe Assune the capacitiovs are anchurged befure the sintch is clored. At…

A: “Since you have posted a question with multiple sub-parts, we will solve the first three sub-parts…

Q: 1. Assume that the circuit shown in Figure 22-2 is connected to a 60-Hz line and has a total current…

Q: The magnetic field intensity at the centre of a circular coil of diameter 1 meter and carrying a…

Q: Find the inductance in mH/km of the follo

Q: What are the branch currents, 12 and 13?

A: The Circuit Diagram is given as:

Q: capacit sphere of inner noudl 'us a buter Ex: Find and Ya dires b with dielectric Gru

Q: 2 The conductors in a single phase ine are 6m above the guünd. Each conductors are spaced 3m a pant.…

Q: 1. A load of 50 ohms resistance and 0.4 H inductance are connected in series to 100 volts, 60 hz a-c…

A: we have to calculate capacitance.

Q: What is the difference between an inductive load and a capacitive load of an alternating current…

A: The solution is given below

Q: transferred conductively f

Q: Alternating currents (AC) is current (or voltage) that take on same values as they change with time…

A: In this question we need to verify the given statement is true or false.

Q: The ACSR conductor Falcon is used in a 3-phase equidistant configuration with D = 42 feet. The per…

A: Given data, D=42 feet Standard data, For Falcon ACSR(steel) Diameter=0.5150 inch

Q: 92/for two long wires as shown in following figur I, 26A I=3 A 1. 2. 3. OThe maynitude of magnetic…

Q: . Find the zero-sequence current.

A: Types of open circuit fault- 1) Symmetrical fault- Three phase line to ground fault Three phase…

Concept explainers

KVL and KCL

KVL stands for Kirchhoff voltage law. KVL states that the total voltage drops around the loop in any closed electric circuit is equal to the sum of total voltage drop in the same closed loop.

Sign Convention

Science and technology incorporate some ideas and techniques of their own to understand a system skilfully and easily. These techniques are called conventions. For example: Sign conventions of mirrors are used to understand the phenomenon of reflection and refraction in an easier way.

Question

What will be the inductance of each
conductor in a three phase, 3 wire system
when they are arranged in a horizontal plane
with spacing such that D31= 4m, D12 = D23
= 2m. The conductors are transposed and
%3D
%3D
* .have a diameter of 2.5 cm
0.111 mH
1.11 mH
11.1 mH
0.00111 H

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Please select the right answer Electromagnetic
The diveegence Meerem is Irue for vectar frc W any aund not only for electae flux density D.
Question 5 In a capacitive load, the current angle: Between 90 and -90. In phase with the voltage angle. Leads the voltage by 90. Lag the voltage by 90.
To find: The loop currents using elimination & substitution methods
Sum of scattering angles in Laboratory coordinate system is always equal to * O 2n None of them О п/2
This is a comparison between lab and wave , please add confirmation and arrange it more orderly,
X₂=0.1 1 XL +03 Soto X₁ = 0.2 X = 0.1 X = 0.1 Above is the one-line diagram of a simple power system. Each generator is represented by an emf behind the subtransient reactance. All impedances are expressed in per unit on a common base. All resistances and shunt capacitance are neglected. The generators are operating on no load at their rated voltage with their emfs in phase. A symmetrical fault occurs at bus 1 through a fault impedance Z, =j0.08 per unit. a) Using Thevenin's Theorem, determine the impedance to the point of fault and the fault current in per unit. b) Find the bus voltages and line currents during the fault. 2 O oto
The capacitance between the two conductor is 255 Farad per meter, then the Capacitance between line to ground in farad per meter is Numerical formula
15) Kirchhoff's Voltage Law (KVL) states that A) the product of the phasor voltages around any closed path must equal zero. B) the sum of the phasor voltages around any closed path does not have to equal zero. C) the sum of the phasor voltages around any closed path must equal zero. D) the sum of the phasor voltages around a closed path cannot include "through the air."
4. A resistor and inductor are connected in parallel to a 277 volt, 60 Hz line. The resis- 12. tor has a current of 12 amperes flowing through it, and the inductor has a current flow of 8 amperes flowing through it. What is the total current flow in the circuit? m bas vlaqua
how to measure ripple factor for this circuits ?
Solve in detail to understand