What should be the different in elevation between the upper and lower levels

Q: Nizwa service station raises 6.6 kN  car of 3.4 m above the ground floor level,As shown in the below…

A:

Q: Two piezometers (manometers) are placed 1.5m apart in a horizontal plastic pipe as shown in figure.…

A:

Q: Water flows into a tank and out through another pipe, as shown in the figure below. The water in the…

A: h0=2.4 mρ=1000 kg/m3Qi=0.24 m3/sQo=0.01 m3/st=100 sA=5 m2

Q: 26 Ps Water Water Oil Manometric fluid Manometric fluid Find the pressure difference at two points A…

A:

Q: (ii) (a) The 500 kg component is located on the cylindrical hydraulic lift shown in Figure 4.1. The…

A: Pascal's law states that on a given horizontal plane of static fluid, a fluid particle experiences…

Q: PI/ U tube manometer is conected across two pipes A and B carring fluids as Shown Ba in figuve.…

A: Answer: The pressure difference (PA - PB) is 10.3986 kPa.

Q: Consider the tank shown in (Figure 1). Take p. = 900 kg/m³, p = 1000 kg/m³, and pHg = 13 550 kg/m³.…

A: According to give data  ρo=900kg/m3 ρw=1000kg/m3 ρHg=13550kg/m3 We need to find  h'

Q: Imagine that you are recently bought a 2-floor house and want to improve the water installation at…

A: Given that, Height of top flor from water meter, z2=15 m,Pressure inside the pipe, P=200…

Q: an airplane is flying at a 4000 m elevation where the temperature is -11C and the density of air is…

A:

Q: A sealed water tank is 40 cm in diameter and 4.5 m tall. The water level in the tank is at 4m and…

A: Given,Diameter of tank = 40 cm = 0.4mHeight of tank = 4.5mWater level in the tank = 4mPressure of…

Q: An orifice meter having an inside diameter of 2.5 cm is located in a 8 cm pipe. Water is flowing…

A: Calculated flow rate of water in (m3/minute).

Q: Figure 3 shows a large drinking water bottle equipped with a hose and a valve. One end of a 7 mm…

A:

Q: A garden hose is positioned as shown in the figure with its open end (#2) is h=2.8 above the faucet…

A: Consider the faucet end as end 1 and open end as end 2. Use continuity equation between ends 1 and…

Work and Heat Transfer

It is generally related to thermal engineering which tells about the use, creation, conversion and transfer of heat energy between the systems. It is also considered that to transfer heat from one source to another, transfer of masses is also required. There are various mechanisms by which, transfer of heat takes place i.e. thermal conduction, convection, radiation or by change of phase. All these mechanisms have their own specific features which sometimes occur simultaneously within the same system.