Answered: What percentage of a rectangular block… | bartleby

Related questions

Question

100%

What percentage of a rectangular block of wood would be above a fluid surface, when it floats horizontally in the fluid? The wood has a density
Pwood = 770kg/m³ and the fluid has a specific gravity SG = 0.9.
Assuming a density of water: p= 1000kg/m³ and a gravity acceleration constant g = 9.81m/s², provide the percentage of unsubmerged wood:
%

Expert Solution

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Blurred answer

Similar questions

(a) A large, open at the top, upright cylindrical tank contains a brine with a density of 1.23 x 10° kg/m³. If the air pressure is 101.3 kPa, determine the absolute pressure (in Pa) in the fluid at a depth of 31.0 m. 373775.3 The absolute pressure at any point in the fluid is the sum of atmospheric pressure and the pressure due to the depth of the fluid. Did you remember to account for atmospheric pressure? Pa (b) Determine the force (in N) exerted by only the fluid on the window of an instrument probe at this depth if the window is circular and has a diameter of 3.30 cm.
Find the pressure difference required between the ends of a 2.00 m long, 1.00 mm diameter horizontal tube for 40° C water to flow through it at an average speed of 4.0 m/s. Water at 40° has a viscosity of 0.7 x 10-3 Pa s. The pressure difference is equal to ______x105 Pa. Recall the equation for volume flow rate with viscosity: Δ?Δ?=??4Δ?8??
A container of cross-sectional area 107 cm2 contains liquid of density 1.75 g/cm3 to a height of 6.80 cm above a small hole of area 1.00 cm2 in the side. (a) Find the speed of the fluid as it leaves the hole.(b) Find the flow rate through the hole.
A scale reads 85 N when a piece of aluminum is hanging from it. What does it read when it is lowered so that the aluminum is submerged in water? The density of alluminum is 2700 kg / (m ^ 3); Useg = 9.8 m/s ^ 2 Calculate answer to two decimals .
A typical pressure in a vein is 18 mm Hg. How high would you need to hang an IV bag so that the fluid enters the blood stream at this pressure? Assume the IV fluid has a density of 1000 kg/m3. A nozzle with an area of 0.3 cm2 is attached to a garden hose with an area of 1.5 cm2. The flow rate through the nozzle is 0.12 L/s.What is the speed of the water in the hose in cm/s? (1 L= 1000 cm3) What is the speed of the water in the nozzle in cm/s? (1 L= 1000 cm3)