What must be the minimum power rating for the external pass transistor used with a 7815 reguiator in a circuit such as that shown in Figure below? The input voltage is 30 V and the load resistance is 10 N. The maximum internal current is to be 700 mA Assume that there is no heat sink for this calculation. Keep in mind that the use of a heat sink increases the effective power rating of the transistor and you can use a lower rated transistor. VIN est VoUT 7815 RL

What must be the minimum power rating for the external pass transistor used with a 7815 reguiator in a circuit such as that shown in Figure below? The input voltage is 30 V and the load resistance is 10 N. The maximum internal current is to be 700 mA Assume that there is no heat sink for this calculation. Keep in mind that the use of a heat sink increases the effective power rating of the transistor and you can use a lower rated transistor. VIN est VoUT 7815 RL

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

In the common emitter configuration the base emitter junction and collector emitter junction are a. forward bias and forward bias b. reverse bias and reverse bias c. reverse bias and forward bias d. forward bias and reverse bias
Resistance must never be measured in an active circuit (i.e in a circuit carrying current). Why?
(c) Figure Q3(c) shows an E-MOSFET biasing circuit. R₁ R₂ tur VDD Ro Figure 03(c) Explain briefly the operation of the circuit for the condition when R₁ is opened and when R₂ is opened.
3. Is it possible to construct rectifier circuits by MOSFET? Justify.
Conclusion: Questions: [1] How to check transistor with help of multimeter? [2] How to check type of transistor (NPN or PNP) with help of multimeter? [3] Define current gain of the transistor in CE configuration. What is the DC current gain you obtain in this practical?
For the circuit shown in Figure B23, a- 0.97, calculate the following: i. Collector current (Ic) ii. Collector-Base voltage (Ven) i. Emitter Current (I) iv. Base Current (In) Ic 2.5 kl Ouput 2.8V IB 10V Vec
Example 8:-
Required information Consider the figure given below with VCC= VEE= 3.3 V, n= 8, and R= 3.6 kQ. +Vcc ЗА A Q3 Q2 A nA R -VEE What are the collector currents in the four transistors in the given figure for if BE= 120 and VA = 50o V? (Round off the solution to one decimal place.) IC1 = 67.2 HA I2= 21 IC3 = 3.3 HA IC4 = 21 НА
For the circuit shown in Figure B23, a = 0.96, calculate the following: i. Collector current (Ic) ii. Collector-Base voltage (VcB) ii. Emitter Current (IE) iv. Base Current (Is) Ic 2.5 kN Ouput 4V IB 14V Vc Figure B23
ELECTRONICS LAB COURSE
What are the properties of a circle E-mosfet in the subject of field effect transistor
Design the transistor shunt regulator to maintain the Vo at a constant value of 12 V. The maximum permissible load current is 460 mA. IC = 12 mA and hFE = 65. The input voltage varies as 20 ± 10%. VBE of the transistor is 0.7 V.