e What is the volume, in mL, of the dry oxygen gas at STP conditions?PV-nRTlatm (V)=(3)(.08214 2. A student thermally decomposed a 0.810 gram sample of impure potassium chlorate. Manganesedioxide was used as a catalyst in the reaction. The student collected 43.60 mL of oxygen gas overwater in a eudiometer. Potassium chloride was the other product of the reaction. The temperatureand pressure at collection time were 20.00°C and 762.10 Torr respectively. The water level in theeudiometer was 4.22 cm above the outside water level in the beaker.

Answered: Image /qna-images/answer/58fc2946-3714-4ba0-854c-c2150a58ac02.jpg

Answered: What is the volume, in mL, of the dry…

Science

Chemistry

What is the volume, in mL, of the dry oxygen gas at STP

Chemistry

10th Edition

ISBN:9781305957404

Author:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Publisher:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Chapter5: Gases

Section: Chapter Questions

Problem 101E: At elevated temperatures, sodium chlorate decomposes to produce sodium chloride and oxygen gas. A...

See similar textbooks

Similar questions

At elevated temperatures, sodium chlorate decomposes to produce sodium chloride and oxygen gas. A 0.8765-g sample of impure sodium chlorate was heated until the production of oxygen gas ceased. The oxygen gas collected over water occupied 57.2 mL at a temperature of 22C and a pressure of 734 torr. Calculate the mass percent of NaClO3 in the original sample. (At 22C the vapor pressure of water is 19.8 torr.)
perform stoichiometric ca1cu1uions for reactions involving gases as reactants or products.
How does hydraulic fracturing differ from previously used techniques for the recovery of natural gas from the earth?
How would the use of a volatile liquid affect the measurement of a gas using open-ended manometers vs. closed-end manometers?
A sample of a smoke stack emission was collected into a 1.25-L tank at 752 mm Hg and analyzed. The analysis showed 92% CO2, 3.6% NO, 1.2% SO2, and 4.1% H2O by mass. What is the partial pressure exerted by each gas?
A mixture of chromium and zinc weighing 0.362 g was reacted with an excess of hydrochloric acid. After all the metals in the mixture reacted, 225 mL dry of hydrogen gas was collected at 27C and 750. torr. Determine the mass percent of Zn in the metal sample. [Zinc reacts with hydrochloric acid to produce zinc chloride and hydrogen gas; chromium reacts with hydrochloric acid to produce chromium(III) chloride and hydrogen gas.]
Carbon dioxide, CO2, was shown lo effuse through a porous plate at the rate of 0.033 mol/min. The same quantity of an unknown gas, 0.033 moles, is found to effuse through the same porous barrier in 104 seconds. Calculate the molar mass of the unknown gas.
105 The decomposition of mercury(II) thiocyanate produces an odd brown snake-like mass that is so unusual the process was once used in fireworks displays. There are actually several reactions that take place when the solid Hg(SCN)2 is ignited: 2Hg(SCN)2(s)2HgS(s)+CS2(s)+C3N4(s)CS2(s)+3O2(g)CO2(g)+2SO2(g)2C3N4(s)3(CN)2(g)+N2(g)HgS(s)+O2(g)Hg(l)+SO2(g) A 42.4-g sample of Hg(SCN)2 is placed into a 2.4-L vessel at 21°C. The vessel also contains air at a pressure of 758 torr. The container is sealed and the mixture is ignited, causing the reaction sequence above to occur. Once the reaction is complete, the container is cooled back to the original temperature of 21°C. (a) Without doing numerical calculations, predict whether the final pressure in the vessel will be greater than, less than, or equal to the initial pressure. Explain your answer. (b) Calculate the final pressure and compare your result with your prediction. (Assume that the mole fraction of O2 in air is 0.21.)
Xenon and fluorine will react to form binary compounds when a mixture of these two gases is heated to 400C in a nickel reaction vessel. A 100.0-mL nickel container is filled with xenon and fluorine, giving partial pressures of 1.24 atm and 10.10 atm, respectively, at a temperature of 25C. The reaction vessel is heated to 400C to cause a reaction to occur and then cooled to a temperature at which F2 is a gas and the xenon fluoride compound produced is a nonvolatile solid. The remaining F2 gas is transferred to another 100.0-mL nickel container, where the pressure of F2 at 25C is 7.62 atm. Assuming all of the xenon has reacted, what is the formula of the product?
5-107 If 60.0 g of NH3 occupies 35.1 L under a pressure of 77.2 in. Hg, what is the temperature of the gas, in °C?
5-56 The three main components of dry air and the percentage of each are nitrogen (78.08%), oxygen (20.95%), and argon (0.93%). (a) Calculate the partial pressure of each gas in a sample of dry air at 760 mm Hg. (b) Calculate the total pressure exerted by these three gases combined.
One of the chemical controversies of the nineteenth century concerned the element beryllium (Be). Berzelius originally claimed that beryllium was a trivalent element (forming Be3+ ions) and that it gave an oxide with the formula Be2O3. This resulted in a calculated atomic mass of 13.5 for beryllium. In formulating his periodic table, Mendeleev proposed that beryllium was divalent (forming Be2+ ions) and that it gave an oxide with the formula Be2O3. This assumption gives an atomic mass of 9.0. In 1894, A. Combes (Comptes Rendus 1894, p. 1221) reacted beryllium with the anion C5H7O2and measured the density of the gaseous product. Combess data for two different experiments are as follows: I II Mass 0.2022 g 0.2224 g Volume 22.6 cm3 26.0 cm3 Temperature 13C 17C Pressure 765.2 mm Hg 764.6 mm If beryllium is a divalent metal, the molecular formula of the product will be Be(C5H7O2)2; if it is trivalent, the formula will be Be(C5H7O2)3. Show how Combess data help to confirm that beryllium is a divalent metal.