What is the next step after the well has been drilled and commercial quantity of natural gas have been verified? O Natural and Artificial Lifting O Natural Gas Processing O Gycol Dehydration O Sour Gas Treatment

Q: Research and investigate the various technologies employed and membrane systems  for various modes…

A: Describe about Membrane separation-Various technologies employed and membrane systems for various…

Q: i mal

A:

Q: A number of polymers, including polyvinylchloride, polystyrene, and polymethylmethacrylate, are made…

A: The reason for rotary dryers, fluidized-bed dryers and sprouted dryers are good choices for polymer…

Q: Cite some important  discussion analysis based on the graph and data which involves the concept of…

A: Distillation is a separation unit operation in which the light key components are separated from the…

Q: The resulting soap has different characteristics. This depends on the ingredients used in making…

A: 1.To remove oil and dirt from clothes Soaps are the commonly used cleansing agents.  2. Soaps could…

Q: Determine the number of enriching section operating lines when a distillation process is constructed…

A: Introduction: The process where the separation is carried out using distillation has 3 parts 1.…

Q: Match the type of calculation that must be used in determining the operating pressures of the…

A: The bubble point is the factor at which the first drop of a liquid combination starts to vaporize.…

Q: Flash distillation is normally carried out in which mode?   a Batch   b Continuous

A: This question is based on distillation. We will analyse each option and find out the correct option.

Q: Why do longer liquid flow paths across a tray give higher stage efficiencies?

A: The reason for stage efficiencies on higher side for a longer liquid flow paths across a tray is to…

Q: What are the Safety inspections. [Important exams, checklist, and inspections] for diaphragm pump?

A: The safety inspections for the diaphragm pump are to be mentioned.

Q: Test Tube 1 2 4 Saline (ml) Patient 0.1 0.1 of 1:4 0.1 0.1 of 1:8 0.1 0.1 of 1:16 0.1 0.1 0.1 0.1 of…

A: Dilution is the process of decreasing the concentration of a solution by adding a diluent.…

Q: Explain Process of extraction cooking oil about description and conditions process

A: Extraction is a process in which one or more components are separated selectively from a liquid or…

Q: The 20 kg of food sample at a moisture content of 250% dry basis is dried to 30% wet basis.…

A: Drying is defined as a mass transfer process of removing water or another solvent by evaporation…

Q: Explain Process of extraction oil of cooking by Solvent extraction?? With more details

A: Solvent extraction is a chemical oil extraction method that uses a solvent to extract oil from…

Q: calculate the PH of the 2M NaOH solution?

A:

Q: It has been determined that the key quality attribute affecting the shelf life is browning in a…

A:

Q: Calculate the critical pressure and critical temperature of the below gas natural. Calculate the…

A:

Q: Discuss the different products obtained from the r

A: Crude oil, the raw material in petroleum refining, is processed at refineries to yield various…

Q: In oil industries, the separation of crude oil into gasoline, kerosene, fuel oil etc., are typical…

A: The answer and explanation are given below.

Q: Explain Flue gas desulfurization.

A: The flue gas desulfurization is to be explained.

Q: In the distillation column analytical calculations, how can the procedure be improved to achieve…

A: Improvements on the analytical methods for the calculation in distillation column is asked.

Q: Pane Accuracy check Accuracy check the following labels for extemporaneously prepared mixtures.…

A:

Q: Glasses may be shaped by a variety of processes which include pressing, blowing, drawing, casting,…

A: HI, thank you for posting the question. As there are two questions asked in a single submission, our…

Q: The equipment shown in the picture is a moisture meter used for the measurement of moisture in soil…

A: The logic behind using a moisture meter in a compost is to be discussed.

Q: In the laboratory experiment "SEDIMENTATION" Describe the sedimentation characteristics. Describe…

A: Sedimentation is the process in which suspended particles settles out of the fluid in which they are…

Q: Provide an equipment description of Slurry Settler in FCC with reference:

A: To provide an equipment description of Slurry Settler in FCC (Fluid Catalytic Cracking) Dear…

Q: Explain Process of extraction oil lubricant about description and conditions process

A: A lubricant is a substance that helps to reduce friction between surfaces in mutual contact, which…

Q: QUESTION 7 Tube vibration analysis is not done in calculations.

A: Type of calculation in which tube analysis is not performed is asked.

Q: An experimental drier is being used to reduce the moisture content of bagasse to be used for…

A: It is given that wet bagasse is having 50% moisture initially. Initial weight of bagasse = 5.75Kg…

Q: When using an aspirator as a source of vacuum in a vacuum distillation, do you turn off the…

A: It is to be mentioned if the aspirator is turned off before venting the system or not.

Q: Do research about the processes which are used to remove phenol from industrial wastewaters.

A: Phenol present in the wastewater contaminates the water with high toxicity even at a very low…

Q: Classify each of the following materials whether it is metal, ceramic, or plastics. (Copper,…

A: Metals ----> copper, Magnesium Oxide, MgO

Q: Calculate the O2 mole flow rate in 10 kg/min flow of air.

A: Assuming molar composition of air is O2=21% and N2= 79% Molecular weight of O2 = 32 g/mole Molecular…

Q: Question 3 What is the impact on the distillation operation if more trays are added to the column?…

A: Option D is correct . For a detailed solution, please see the attached file.

Q: 5.3 The laboratory test data for a standard Proctor test are given below. Find the maximum dry unit…

A: Determine the moist unit weight  of the soil using the formula. Here, W is the weight of the…

Q: Plate filter press is commonly used in industry due to its high strength, long service life and good…

A: tbatch = 60 min = 1 hr tdischarge + tcleaning = 10 min tfilteration = tcleaning = 10 min…

Q: explain why diesel and gasoline are used for floating roof tanks. give two points?

A: Reason for storage of diesel and gasoline in Floating roof tanks is asked.