What is the current through the load

Q: Discuss the different methods of measuring high d.c. voltages.What are the limitations in each…

A: Voltage When charged electrons (current) are forced through a conducting loop by the pressure of an…

Q: A circuit is shown in the figure. C = 8x104 F, L = 4×102 H, and R = 9 Q2. The AC source has a…

A: The circuit diagram is shown below,

Q: RL IL b 1.5 kN R3 6.8 kN R21.2 kN E+ 8 V R3 1.0 kN figure d

A:

Q: + Vy- 3V 2V + Vx - Vx - ? 2V

A:

Q: How does the load power vary with the load resistance

A:

Q: Why is it important to know you measure current through a component and voltage across?

A: Please find your answer below in step 2

Q: 12.1.8 An analysis of antenna radiation patterns for a system with a circular aperture involves the…

A:

Q: 17.5 Find the Fourier transform of each of the following functions. In all of the functions, a is a…

A:

Q: A,

A: Usually wire connected between bulb and battery to flow the current and make bulb on. the wire must…

Q: What is the effect of cross section on resistance?

A: Resistance :- It is the opposition offered by the elements to flow of current. Mathematical written…

Q: What is Ohm’s Law, and why is voltage so important.

A:

Q: Alternating Current System A series connection of a 30-ohm resistor and a 100-mH inductor is…

A:

Q: 2mA 3k2 12mA 2kQ2 Solve for the current through the 2-k2 resistor using: A. Mesh Analysis B. Nodal…

A:

Q: 5. A resistor and an inductor are connected in parallel to a 120-V 60-Hz source. The total current…

A: Given parameters are: Source voltage, Vac=120V, Frequency of the source, f=60Hz, Total current,…

Q: Problem 5. Find the range of parameters g and r in which the circuits below are stable: a) о b) gVc…

A:

Q: 1. What are the two necessary conditions for a thyristor to begin conduction? 2. Once a thyristor…

A: The condition for a thyristor to begin conduction is,  The conduction happens when the anode…

Q: TRUE or FALSE: During open-circuit test, the current in the high-voltage winding is equal to zero.

A:

Q: What is the meaning of Ohm's law

A: Law is a scientific statement that is made so that the phenomenon stated by it can be accepted…

Q: Find the equavilant resistance?

A: The given circuit is

Q: find current I

A:

Q: What is factor of a cable at 5 degrees celcius when calculating resistance

A: The solution is provided in the following section.

Q: BJT Circuits Under DC Conditions +10 V WWII 5 ΚΩ LOVC 2 ΚΩ The BJT in the circuit to the left has ß…

A:

Q: What does a compatible charge mean? What if the load is not compatible?

A: to explain the compatible charge

Q: 2) A current source in a linear circuit has i(t) = 15 cos(25at + 25º) A. a) What is the amplitude of…

A:

Q: A particle on a ring has the following wave function: Y=1/(2n) e-7i¢ What is the smallest value of…

A: SOLUTION  GIVEN               Ψ = 1/(2π)1/2  e-7iΦ         Calculate…

Q: 4) For circuit shown in Figure (4): Determine the voltage drop across 90. a) 17V 20 90 b) 15V c) 19V…

A: Given circuit is:

Q: 1.2 8. DC DC 7. DB 16 ACY 20 10 426 MODEL Oo DC- 2 DC- OHMS COM 1200 6000 300 1200 6000 -300 605 -12…

A: A resistant reading may be a reading of a text which moves beyond the dominant cultural…

Q: 00 S dfM(f) ej²nft ∞ m(t): = M(f) = m(t)e-j²nft dt 8

A: Fourier transform This transform helps us to analyze the time domain and frequency domain systems.…

Q: How much is the eurrent, I, at each of the following points? a. Point A b. Point B c. Point C d.…

A: Since there is no other way...The current will flow through the given loop According to law of…

Q: Two coils connected in series have resistances of 600 N and 300 Q with temperature coefficient of…

A:

Q: 7. a) For the given circuit, use the mesh-current method to write a complete set of independent…

A: Given the circuit, as shown below: a) For the circuit above we need to use the mesh-current method…

Q: Find i in the network using superposition. 5Ω 10 Ω 2 A 5Ω 4Ω 20 V

A: This theorem is used to find current in any particular branch. To apply this minimum 2 sources are…

Q: (2) Use The current used for a No-Load condition is Partial Load. The current for used for a Full…

A: Current drawn by the machine during no load condition is minimum (nearer to zero). Hence, the…

Q: How to solve KCL and KVL?

A:

Q: 4 μF 252 9) An RC Circuit is shown above. The switch has been in position a for a very long time. a)…

A:

Q: What is the current drawn from the source

A: What is the current drawn from the source?

Q: What are the symbols for loads in electricity

A: As we  have to find the symbols for loads in electricity As load means it is passive element which…

Q: Answer if it's true or false. It is a electrical subject.

A:

Q: What will be different if there is no "Ce"? Can you make a solution based on the absence of "Ce"?…

A: given, β=120VBE=0.7VVA=100VCμ=1pFfT=600MHz

Q: If the power source in the circuit below is 60 V, what is the total current in the circuit?…

A: In this question we need to find the total current of the given circuit

Types of Thyristors

With four layers of alternating P- and N- materials, a thyristor is a solid-state semiconductor device. It acts as a type of bi-stable switch and it conducts when the gate receives a current trigger and continues to conduct until the voltage is reverse biased across the device or by some means until the voltage is removed. The silicon-controlled rectifier is considered synonymous with thyristors by some sources. Thyristors are defined as more complex by other sources as it contains at least four-layer of alternating N-type and P-type substrate. They find large applications in the control of electrical power supplies, electric motor speed control, and ranging of light dimmers because thyristors can control large amounts of power supplies and voltage with a small device. The circuit symbol of the thyristor is given below.