what is the bearing capacity of the beam in kips? (2 decimal places)

Q: Explain a bernullies beam with equation(s)

A: Bernoulli's beam, also known as the Euler-Bernoulli beam, is a concept in structural engineering…

Q: Using Method of Joints determine the force in member EK. Hint: What is going on at N or H? 15 kips…

A: An overhanging truss with concentrated loads are given.Point I is supported by hinged support and…

Q: 24 kips 60 kips 36 kips B C D E F kips A 9'- 9'- ° HA G 9 24 kips 12'

A:

Q: Ex. 6.48 A floor truss is loaded as shown. Determine the force in members FI, HI, and HJ. 2 kN 4 kN…

A:

Q: Determine the force in members BC & CD of the truss and indicate whether the members are in tension…

A: Given data:

Q: For the truss shown, determine the axial forces on members BD, BE, and CE. 14KN F H. 14KN 14KN 3m A.…

A:

Q: Which joint would be the best place to start your analysis of the truss shown?

A:

Q: Problem # 2: Determine the internal axial force in each member of the truss using the force method.…

A:

Q: SITUATION. A truss is loaded and supported as shown below. It is carrying a vertical point load at…

A:

Q: Find the max compressive and tensile normal stress of the beam below

A: Given Data  Determine the maximum compressive and tensile stress of the beam.

Q: 2. The yoke-and-rod connection is subjected to a tensile force of 5 kN. Determine the average shear…

A: The force applied F = 5 kN. The average normal stress in a 40mm diameter rod     = 3.98(MPa)The…

Q: Determine the bolt diameter if the shear stress is 150 MPa and the bearing stress is 337.50 MPa.

A: The values and diagram given in the question are as follows: Shear stress(t)=150 MPa Bearing…

Q: Problem 4: Calculate M, of the box beam. The bottom row of bars is 5 no. 9's and the top row is 4…

A: Given that :-For bottom row: 5 no. 9 bars For top row: 4 no. 5 bars Wall (web) thickness = 3…

Q: The Warren truss loaded as shown in the fig at C and a hinge at G. By the method of s- members BC,…

A:

Q: The reinforcement steel consists of 5 bars with each having a diameter of 13.75 mm. Take pb=0.425.…

A: diameter= 13.75 mmpb=0.425ymc =1.5yms =1.15NOTE:Since you have posted multiple questions, we will…

Unit Conversion

Standard units are also called SI units. SI units are used for measuring a physical quantity satisfying certain conditions. There are two types of units: fundamental units and derived units. Fundamental units are physical quantities that are independent, that is, they do not depend on other quantities like mass, length, or time. There are plenty of quantities in our lives which need to be measured and compared. Measuring is the comparison of a particular physical quantity with its reference value. A unit is a measure of a fixed physical quantity. A physical quantity is the product of a unit and the numerical value we need to compare with.