What is the approximately temperature of arc needed for arc welding? O 600-1000°C O 6000-8000°C O 5000-6000°C O 2000-4000°C

3.) How many different types of welds  are specified on the print and what are they? (Hint: look at the symbol on the reference line) 4.)For the weld between parts TP1 and TP2, what does the 3 mean? 5.)What standard should be used to interpret the weld symbols on this print? (Hint look at the notes given at the top of the print.) 6.) As indicated by the welding symbols, the welds to be made on ______________________?* a. the near side b. the far side c. both sides d. all around   7.)What note is found in the tail of the welding symbol?   8.)What is the name of this part?   9.)Who drew this print?   10.)What company was this print written for?

1/8 2015 Cengage Learning Refer to the drawing Bracket below. 1. Explain fully the meaning of each of the welding symbols used on the drawing. 2. How far apart (in degrees) are the equally spaced drilled holes? 3. Define the dimension 3" XS BI Pipe. 4. How many parts does this bracket consist of? 5. What plate size is used? 6. What type of section is represented by section A-A? 0.250 DRILLTHRU SIX HOLES EQUALLY SPACED 23° CYLINDRICAL PLATE 1" STD 8 PIPE E. A 3" XS BI PIPE 01013" 3" 8. $12! B 3. 32 25" 337 5" 2" HH !..6 D. BRACKET

I need answers to parts 1, 2, and 3, pertaining to the print provided.

What is the name of the organization that sponsors a series of welding skill competitions for welding students?

The name of the edge preparation for welding shown in the following figure is O a. Double bevel O b. Single ) Oc single v 0d Single bevel

Briefly explain the heat-affected zone (HAZ) in welding showing the microstructural changes with a suitable sketch/diagram.

What four welding processes are covered in the SENSE program?

What is the smallest V-groove angle that can be welded using the FCA welding process?

Copyright Cengage Learning Copyright © Cengage Learning Copyright ©2015 Cengage Learning b. Copyright © Cengage Leaming Copyright © Cengage Learning T Copyright 2015 Cengage Learning Weldment Fabrications w 143 UNIT 12 Fillet Welds 157 LINN UNIT 12: REVIEW A Graph paper is provided at the end of this review for your use. 1. Apply the appropriate welding symbol(s) to each of the orthographic views to indicate the welds shown in the pictorial representations (a) through (d). a. b. b. M. 16 SIGNIFICANCE TOP VIEW SIGNIFICANCE FRONT VIEW C. d. SIGNIFICANCE FRONT VIEW SIGNIFICANCE FRONT VIEW 2. When is the size of fillet welds not included in SEE DETAIL "A" the welding symbol? 3. Sketch a symbol that indicates the following weld. 6. Why are fillet welds with unequal legs detailed? -FILLET WELD- 7. Refer to the orthographic drawings (a) through (d). Sketch and dimension the welds required on the pictorial drawings shown with each. ALL-AROUND 4. Give two situations when the length is not…