Answered: What is the advantage of placing the… | bartleby

Related questions

Question

What is the advantage of placing the two insulated electric wires carrying ac close together or even twisting about each other?

Expert Solution

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Blurred answer

Similar questions

What is the relationship between a sinusoidal current and a sinusoidal voltage in an inductor?
What is the common frequency of ac in homes in the United States?
Consider the ac adapter that bisects the power cord to your laptop computer, cell phone charger, or another electronic device. (a) What dc output voltage V and current I are listed on your device? (b) What power P is listed on your device? Does P = IV? (c) Your ac adapter is most likely not a simple transformer; however, it is instructive to analyze the device as if it were: Assume your device is a transformer with a 120 V rms voltage on its primary coil and a full-wave rectifier following its secondary coil. If an R-C circuit with a sufficient time constant followed, the ultimate output would maintain the dc value of the voltage amplitude on the rectified secondary coil. If the primary coil has 200 turns, how many turns are needed on the secondary coil to produce the stated dc output according to this scheme? (Give the closest integer value.) (d) Estimate the current amplitude in the primary coil. (e) Based on the size of your device and assuming the transformer geometry shown in Fig.…
Think about the rms current through a person if they touch a 120 Vrms AC source in the following conditions: 1. Standing on a rubber mat which offers a total resistance of 275 kÖ in mA. 2. Standing barefoot on wet grass and has a resistance of only 3800 2 in mA. Neither is a good option but which would be the worst option? meaning which would have the Largest rms current? Both have the same rms current Standing on a rubber mat which offers a total resistance of 275 k in mA. Standing barefoot on wet grass and has a resistance of only 3800 Q in mA.
I need a proper solution for this question ( well explained and understandable writing) In a hydroelectric dam, how is energy produced that is then transferred out by electrical transmission? That is, how is the energy of motion of the water converted to energy that is transmitted by AC electricity?