Write the method with formula explanation and working steps 5. The initial voltage across the capacitor in the circuitshown is 2.5 V. The switch is closed at t = 0.5V10(A) 0.2 A(B) 0.7 A(C) 1 A(D) 3 A1 μFWhat is most nearly the current immediately after theswitch is closed?

Initial voltage across the capacitor = 2.5 V Switch is closed at t= 0.We need to find the value of…

Answered: What is most nearly the current…

Engineering

Electrical Engineering

What is most nearly the current immediately after the switch is closed?

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter23: Resistive-inductive-capacitive Series Circuits

Section: Chapter Questions

Problem 6RQ

See similar textbooks

Related questions

Q: b) Find current using nodal analysis.

A: Given circuit is shown below:

Q: Q27. Find the true power, the reactive power, and the apparent power of the circuit shown below. 10…

Q: 8 5. In a single-phase diode bridge rectifier circuit fed by a source voltage of 240 50%THD and a…

Q: 3. Find the power delivered to the 5 CK+ elements. зал 12V +3V ↓ Ix 105 + (62) Ix

Q: How can electromagnetic interference (EMI) affect the data transmission quality of unshielded…

A: Electromagnetic interference (EMI) can significantly impact the data transmission quality of…

Q: Q1: Choose the correct answer for the following: ● The terminal number eight for the op amp is…

A: It is DC coupled device with a very high voltage gain. It can perform amplification, subtraction,…

Q: 2. Find the value of source current I, in the circuit?

A: Given circuit is shown below:

Q: The upper critical frequency of an op-amp’s open-loop response is 200 Hz. If the midrange gain is…

Q: Sample Problem. Determine the output waveform for the network below and calculate the output dc…

A: D1 and D4 are silicon diodes whereas D2 and D3 are germanium diodes.

Q: Write a KCL at node A. Write a KVL of loop 1. Introduce currents and voltages as necessary to write…

Q: Find the equivalent resistance in the following circuit.

A: Given circuit is shown below:

Q: 4. Find the voltage at node P in the following figure.

A: Given circuit is shown below:

Q: compute the value of the perpendicular component and of P.

A: Given:for the given system, with parallel component of P is 300 N. To find:value of the…

Q: A system with zero initial conditions has the closed loop function as s² + 16 T(s) (s+2)(s+6) The…

A: It is given that:A system with zero initial condition has a closed loop transfer function,

Q: Question: A parabolic reflector antenna has a diameter of 2 meters and a focal length of 1 meter.…

A: It is given that:

Q: 2 i) x (t-3) & x (t+3) (3+) ii) x (S/ +) tu) x(t) x (-+) &

A: Given a signal x(t)Asked to draw the following signalsx(t−3),x(t+3)x(53t),x(35t)x(−t)

Q: Voltage across 2 ohm?

A: Given circuit is shown below:

Q: The following system given by input (t) and output y(t) is memoryless. y(t) = 2x(t) + 2 True False

A: A memoryless system is one where the output at a given time t only depends on the input at that same…

Q: Pr. 3] A 107.6MHz carrier signal is frequency modulated by a 7KHz sine wave. The resultant FM signal…

Q: Types Of Hygrometer's

A: A hygrometer is an instrument used to measure the humidity or moisture content in the air. Humidity…

Q: Calculate the active power in a 487 H inductor. a) 2482 W b) 1545 W c) 4565 W d) o W

A: Given information is shown below:

Q: se superposition to find the current Ii in the circuit + V = 100 mV/0° Ι g = 4.0 mS 6VZ0° + 20 ΚΩ •…

A: Given Data:An AC RC circuit with,Dependent and independent sources.To Find:The current by the…

Q: 6. The voltage at node B is 6V. What is the voltage at A and the resistor R? -24 V 3kQ R 1kQ <2kQ B…

Q: Why are gold-plated connectors often used in high-quality audio and video cables?

A: To explain:Why are gold-plated connectors often used in high-quality audio and video cables?

Q: A sinusoidal voltage has a peak value of 340 V. Calculate its mean and r.m.s. values, correct to 3…

A: Given information is shown below:

Q: Obtain the response i(t) for the current through the 30 ohm resistor for t>0. note: do not use…

A: An RLC circuit is excited by the following sources:two DC voltage sources of 60 V and 120 V,an…

Q: For the circuit in the figure, determine the response of i(t), valid for all t=0- and t=0 , if at…

A: A RLC circuit is excited two sources: 10 V constant voltage source and A current source.We need to…

Q: The logic circuit given in the figure below represents: D₁ A K B KH D₂ ww R y (output) 10V

Q: b=??

A: Given circuit is drawn below:

Q: The state transition diagram for the logic circuit shown is D CLK Q 10 2-1 MUX X1 XO Y Select Alo

A: Given figure is shown below,

Q: ..) A series type ohmmeter, designed to operate with a 9-V battery, the meter movement has an…

Q: (c) A transistor circuit is shown in the figure 2 below. (Assume silicon semiconductor. and…

Q: 1. Determine the zero-input response of a LTIC system with input-output differential equation ÿ+170y…

Q: Lp = 50 mH ell N₂=20 N₁ = 80 ell L k=0.8

A: To find:Find the value of Ls, for the given mutual inductance.

Q: In the past, Type-1 diabetes patients had to inject themselves with insulin three to four times a…

A: The state-space matrices are

Q: Find the differential entropy H(X) of the uniformly distributed random variable X with probability…

Q: A three Phase generator with rating 1000KVA, 33KV has its armature resistance and synchronous…

A: The base value of the generator voltage is:The base value of the generator power is given as:

Q: Find the transfer function of the Bode-plot shown in the figure below. 0 dB + -20 dB- 0° -180° 0.1 1…

A: The magnitude and phase Bode plots of a system are given. We need to determine its transfer…

Q: Determine output voltage vout (t) in terms of input voltage vin (t).

A: In this question, we need to determine the voltage Vo in term of voltage Vin .we solve this problem…

Q: 4.17 Using the ideal op-amp assumptions, determine I, I, and I, in Fig. P4.17. 1 mA Figure P4.17 R₁…

A: It is given that:The circuit diagram is given as,

Q: Hw: If the input voltage in the circuit, determine the response i.(1). 292 www 7 1 v(t) = 3 + 2/2 (²…

Q: An optical fiber has a core refractive index n1=1.5 and a cladding refractive index n2=1.48. the…

A: Given-Core refractive index n1 = 1.5Cladding refractive index n2 = 1.48Diameter = 50 micronsLength…

Q: Aim To carry out the Polarity Test on a single-phase transformer Equipment: 3.3kVA 220/110V…

A: A polarity test is performed on 220/110 V single phase transformer and the test results are given.…

Q: Figure 2.26 shows three loads connected in parallel across a 1000-V (rms), 60-Hz single-phase…

Q: A certain cascaded amplifier arrangement has the following voltage gains: A, = 10, A2 = 15, and A3 =…

A: It is given that:

Q: 5. Assume that the signals in the following two-dimensional signal con- stellations are equally…

A: The signals in the given following two-dimensional signal constellations are equally probable.To…

Q: ssion:

A: Given information is shown below:

Q: Can you please illustrate in diagram and explain on how to do the Conductance Test of the Motor…

Q: . Use the water analogy to describe the basic electric circuit lighting up the light bulb. Use…

Q: The voltage across a C = 828 mF capacitor is v(t) = 7 sin(100t) + 2 V. Find the initial energy in…

A: Given Data:AC voltage Capacitor To Find:The initial energy stored in the capacitor in J.

Concept explainers

Winding and Constructions

Alternating Current (AC) winding is generally of the 3-phase type due to the inherent advantages of the 3-phase machine. Armature coils must be connected to the yield balance (equivalent in magnitude and 2/3 of the series phase difference of the rod) 3-phase electromotive forces (emf). The armature should be divided into step-bands to start with slots around the perimeter.In the construction of AC machines, the frame is used as an external protective shield to protect it from environmental conditions. The frame also serves as the outer perimeter, allowing the interior to be easily placed. The static state section of the devices is the stator winding attached stator.

Question

Write the method with formula explanation and working steps

5. The initial voltage across the capacitor in the circuit
shown is 2.5 V. The switch is closed at t = 0.
5V
10
(A) 0.2 A
(B) 0.7 A
(C) 1 A
(D) 3 A
1 μF
What is most nearly the current immediately after the
switch is closed?

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1: State the given data.

VIEW

Step 2: Find the value of voltage (V).

VIEW

Step 3: Find the value of current.

VIEW

Solution

VIEW

Step by step

Solved in 4 steps with 7 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Winding and Construction of the Rotor and Stator

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

An RC series circuit is connected to a 120-V, 60-Hz power source. The resistor is 25 and has a voltage drop of 65 volts. What is the capacitance of the capacitor?
You are an electrician working in an industrial plant. You discover that the problem with a certain machine is a defective capacitor. The capacitor is connected to a 240-volt AC circuit. The information on the capacitor reveals that it has a capacitance value of 10 mF and a voltage rating of 240 VAC. The only 10-mF AC capacitor in the storeroom is marked with a voltage rating of 350 WVDC. Can this capacitor be used to replace the defective capacitor? Explain your answer.
An R-L series circuit contains two resistors and two inductors. The resistors dissipate powers of 96 watts and 125 watts. The inductors have reactive powers of 100 VARs and 78 VARs. What is the power factor?
Assume the circuit in Figure 21-1 has a power factor of 68%, an apparent power of 300 VA, and a frequency of 400 Hz. The capacitor has a capacitance of 4.7125 F. Find the missing values. ET ER EC IT IR IC Z R XC VA300 P VARSC PF68 C4.7125F
A 22-k resistor and a 0.02-F capacitor are connected in series to a 5-V source. How long will it take the capacitor to charge to 3.4 V Select one: a. 0.501 ms b. 0.66 ms c. 0.44 ms d. 0.70 ms
I am having trouble with this problem it might be the dot notation for the inductors but I am not entierly sure that is the only issue I am having
Please solve fast ,Have very less time. Do correctly . What is the total inductance in the circuit in Figure 13-1? A) 2600 uH B) 2100 mH C) 602 mH D) 800 mH
An inductor of 230 milli Henry, a capacitor of 15 micro farad and a 200 ohm resistor are in series across a 36 V and 60 Hz voltage source. Find the total current a. 150 mA b. 0.164 A c. 0.2 A d. 170 mA
When the charge in this circuit discharges, why does the charge on the capacitor have to go through R2 only? Why can't it go through R1 as well?
Refer to the given circuit. C1 = 5 µF C3 = 8 µF C2 = 4 µF C4 = 6 µF C5 = 4 µF DURACELL VT = 12 V What is the voltage across the plates of capacitor #1 (C1)? Select one: a. 6.36 volts O b. 2.71 volts O C. 5.65 volts O d. 7.32 volts
Four 2H inductors are connected in parallel. What is the equivalent inductance?
The capacitor dissipation factor is the ratio of inductive reactance to its resistance resistance to its inductive reactance resistance to its capacitive reactance capacitive reactance to its resistance