What height in meters of a column of a special gage liquid having a specific gravity of 2.90 would exert the same pressure as a column of oil 9 m high having a sp.gr. Of 0.60. O a. 1.24 m b. 2.48 m c. 1.66 m O d. 1.86 m

What height in meters of a column of a special gage liquid having a specific gravity of 2.90 would exert the same pressure as a column of oil 9 m high having a sp.gr. Of 0.60. O a. 1.24 m b. 2.48 m c. 1.66 m O d. 1.86 m

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

The tank in figure shown, contains oil of specific gravity of 0.82. Determine the reading of gage A in KPa. If the tank is compressed with a gage pressure reading of 61.7 kg/sq.m., what will be the final reading in gage A (reading in absolute pressure), assuming no change in reading at gage B.
Oil (relative density or specific gravity of 0.8) flows through a pipe. the diameter is 50 cm. The length is 20 m, z1 is 1m and z2 is 2m. the speed is 4 m/second. the difference in heights in caliber is 1 cm. the caliber contains mercury and its density is 13600 kg/m3. Find the friction factor and determine whether the flow is laminar or turbulent. la viscocity of the oil is 0,319 Mt seg/m2
just answer quickly
a pipe has a pressure of 4000 pascal and is connected to a 36 degree inclined single column manometer. the level of mercury in the reservoir is at a height 20 cm below the center of the pipe. The length of the inclined column which is at the same level from the mercury inside the reservoir up to the end of the column at the reight limb is 25 cm. Find the specific gravity of the fluid inside the pipe. The area of the reservoir is 125 times the area of the right limb of the manometer
If x = 40cm and the specific gravity of Glycerin is 1.3, what height of mercury (SG 13.6) will produce the same gage pressure at A. A Oil 70 cm SG=0.90 Water 90 cm Glycerin 20 cm 15 cm O 9.4147mmHg O 8.8235mmHg O 8.4732mmHg O 9.7059mmHg
A pressure gauge at elevation 7.8 meters at the side of a tank containing a liquidreads 73 kpa. Another gauge at elevation 4.5 meters reads 125 kpa. Compute thespecific gravity of the liquid. draw the figure
civil engineering.
-8.33 -0.12 8.33 (1) 0.12 -L Darcy Experiment A set-up of Darcy Experiment involves measuring the pressure head at two piezometers separated a distance, L. Given the set-up shown, determine the hydraulic gradient if the hydraulic head at (1) is 66 cm, hydraulic head at (2) is 54 cm, and the travel distance is 100 cm. h (2) e - - - -
Determine a. Velocity at the pipe with 8 in. diameter in ft/s. b. Pressure at point D in psi c. Flow rate in cfs d. Velocity at the pipe with 18 in. diameter in ft/s
Fluid
15. If the pressure in pipe A is 6 kPa, the SG = 0.85 pressure in pipe B =. ........... psig. Water 90 mm 30% a. 1.27 70 mm b. 8.73 40 mm C. 60.17 SG = 13.6 Mercury d. None of all these
Heavy fuel oil flows at Q = 10 gallons per minute (gpm) in a horizontal steel pipe that connects two storage tanks. The diameter of the pipe is D = 1.5 inches. The length of the pipe is L = 100 feet. The depth of oil in the supply tank is 30 feet above the pipe entrance. The temperature of the oil is 60°F, the specific gravity of the oil is s.g.oin = 0.90, the specific weight of the oil is 56.13 lb/ft', and the kinematic viscosity of the oil is 0.00175 ft2/s. The pipe discharges into the bottom of the receiving tank. Neglect minor losses. a) Determine the pressure p at the pipe entrance in pounds per square foot (psf). b) Determine the velocity v in feet per second (fps). c) Determine the Reynolds number Re. d) Classify the flow based on the Reynolds number Re. e) Determine the Darcy-Weisbach friction factor f. f) Determine the friction head loss hfac in feet in the pipe between the two storage tanks. 8) Determine the depth of oil in feet above the exit from the pipe into the second…