- What function do Demultiplexers or DEMUX perform?- According to the implementation of automation circuits with ARDUINO boards, what would they be, Conceptually, the main components of any system of automation? Draw a representative schematic or block diagram.

a.it a Moore machine or Mealy? Why? b. Create the next-state table. Show your work. Label your columns. c. Question b's table and question c is attached from the picture below

we are interested in an automatic garage gate system for a building. This system includes a gate that goes up or down, a motor to actuate the gate (pull, push) and sensors to collect information (gate open contact, gate closed contact). The sensors are all similar, each signaling to its controller that a contact has taken place. The user has a remote control to control with just two buttons: open, close. The operating principle of the system is as follows. Suppose the gate is closed. The user opens the gate by pressing the Open button on his remote control. He can stop opening by pressing the Open button again, the motor stops. Otherwise, the gate opens completely and triggers a Gate Open sensor which causes the motor to stop. Pressing the Close button causes the gate to close if it is open (partially or fully). The closing can be stopped by pressing the Close button again, the motor stops. Otherwise, the gate closes completely and triggers a Gate Closed sensor which causes the engine…

Q1/ Design a circuit using an arduino board to control the direction and the speed of rotation of DC motor using remote control.

MECT361 Mechatronics Components and Instrumentation PLEASE GIVE ME THE short answer and wite it by keyword thanks

Given the moore machine find the moore machine diagram.

5. A single phase full wave ac voltage controller working on ON-OFF control technique has supply voltage of 230V r.m.s, at 50Hz, and a load R = 5002. The controller is ON for 30 cycles and off for 40 cycles. Calculate (a) ON & OFF time intervals. (b) the output R.M.S. voltage. (c) the power factor of the controller.

Stop ducking the question and just answer it. Number 14 letter a.

What is the purpose of sequence control

D.a. Which one of the following PM programs is usually the largest for a typical manufacturing facility?A. LubricationB. ElectronicC. ElectricalD. MechanicalD.b. The true purpose of uptime inspection PM is toA. keep the PM staff working during low maintenance periods.B. locate problems that occur on a random basis.C. supplement the lubrication PMs in looking for dry bearings and other lubrication problems.D. look for common recurring problems in equipment. D.c. When machines fail shortly after they’ve been built and installed, the failures are termedA. singularity failures.B. independent component failures.C. short-term failures.D. infant mortality failures.