What did we need to do to solve a problem like this? : released or 201°c and "absorbed when EVOH @ What is total heat I atm is converted to lig EtOH @ 25°C What do I need to know? 201 25 10g

Q: Q.9A heat exchanger is used to cool a hot hydrocarbon liquid flowing at rate of 200 Kg/hr from 150°…

A:

Q: A refrigeration system with a capacity of 10 tons of refrigeration operates at 210 kPa in the…

A: Given data: Capacity of refrigeration = 10 ton Temperature in evaporator = 210 kPa Temperature in…

Q: 10kg of water at 20C converted to ice at -10C and constant atmospheric pressure . The specific heat…

A: Given Mass of water=10kg Converted from 20C to(-10)C  P=Constant Specific heat capacities of…

Q: 4. A heat exchanger is to be designed to raise the temperature of 10 kmol/hr of ammonia from 300K to…

A: Given, molar flow rate , n=10 kmol/hr=10×1000 mol3600 s=2.78 mols  Initial Temperature, T1=300 K…

Q: b) Due to hydraulic shock, the pipe ruptured resulting in release of liquid ammonia into the…

A: Given: The Ambient temperature, The atmospheric pressure, fluid pressure inside the pipe, The…

Q: What does the process considering metal and water implies? Since ASuniverse>0, the process is…

A:

Q: Calculate the amount of heat necessary to raise 92.7 g of water from 26.3 °C to 174.3 °C. the molar…

A: Given:  T1 = 26.3 C = (26.3 + 273) K = 299.3 K T2 = 174.3 C = (174.3 + 273) K = 447.3 K  Cp = 18 cal…

Q: Sol. Since AU = 0, then the heat on segment ab is QH = TH In | The heat on segment cd is QC = - TC…

A: A Carnot heat engine is a theoretical engine that operates on the Carnot cycle. This system may be…

Q: Q2. Source (A) can supply energy 10000 kJ/min at 315 °C; Source (B) can supply energy100000 kJ/min…

A: Given: Source (A): Energy supply q = 10000 kJ/min Temperature of heat source TH = 315 oC = 588 k…

Q: You are working on a plant where H2S is one of the feed stock to the reactor. The H2S needs to be…

A: Given: H2S is feed stock Preheated from 30oC to 300oC Pressure 40 bar

Q: A ball at 1200K is allowed to cool down in air at an ambient temperature of 300K. Assuming heat is…

A: Since you asked to solve this question by Runge-Kutta of fourth-order which is a lengthy process…

Q: a) The city pool loses 1.0 inch of water every week due to evaporation. If the pool is 25yards long…

A: The objective of the question is to calculate the energy required to keep the pool at 15 degrees…

Q: Nitric acid at a temperature of 20°C and pressure of 2 atm is fed to a heater at steady state open…

A:

Q: 290 K and the pressure is atmospherie. The residence time in the combustor is 0.1 s. As- suming the…

A:

Q: PLEASE I NEED HELP WITH THESE QUESTIONS. Please show work of the worksheet too. 1. Why do you use…

A: 1. Generally highest temperature is taken as it helps in estimate largest amount of heat tranferred.…

Q: Actual vapor quality at turbine's exit Actual work of

A:

Q: QUESTION 4 A cup of coffee with cooling constant A-0.09 per minute is placed in a room at…

A: Given: Cooling constant k = -0.09 per minute Surrounding temperature Ts = 20 oC Serving temperature…

Q: Addition of heat at constant pressure to a gas can result in raising its temperature WITHOUT…

A: The given statement is FALSE

Q: Q2 i Heal is transfemed from a lank of water in a refrigerator atf OC ) degrees to a tank of boiling…

A:

Q: Q1/A power plant operating on Camot cycele that produces (500MW). I tumed out that this represents…

A: Hi and thanks for the question. Since you have posted multiple questions and didn't specify which…

Q: 11.0 kg of methane is found to have a pressure of 3000 kPa when it's temperature is at 400K. Compute…

A: Given: 11 kg of methane, at 3000 kPa (30 bar) at 400K, compressed to saturated liquid at 150K

Q: Q21:- A heat exchanger is used to cool a hot hydrocarbon liquid flowing at rate of 200 Kg/hr from…

A:

Q: 3- As shown in Figure 2, Carnot Heat Engine (HE) working between temperatures T1= 150 °C and T2=4…

A: Write the equation for efficiency for Carnot heat engine as follows: η = WQ11-T2T1 = WQ1     ......1…

Q: Q2. Source (A) can supply energy 10000 kl/min at 315 °c; Source (B) can supply energy100000 kJ/min…

A:

Q: 1. A container of base of area S = 200 cm2 and negligible heat capacity contains a mixture of water…

A: Base area of container = 200 cm2 Mass = 1 kg Calorific value of kerosene = 7×104 kJ/kg Specific heat…

Q: 10 kg of H2O is stored in an icebox at - 13.7 C. After a few days, the temperature is measured at…

A:

Q: Steam is used to cool a polymer reaction. The steam in the steam chest of the apparatus is found to…

A: The initial state of the steam is at a temperature of 250.5°C and a pressure of 4000 kPa. The final…

Q: Suppose the initial energy of a system (internal, kinetic, potential) is E the final energy is E ,an…

A: Given that E1 = Initial energy of a system E2  = final energy Q = amount of energy transferred to…

Q: From the given, calculate: 1. Heat gained by melt water 2. ∆Hfus  (show all calculations)

A: Heat gained by the melt water and enthalpy of fusion is to be calculated.

Q: What is the heat energy required to completely vaporize 10 grams of water at OC? The heat capacity…

A: Given that, The mass of water m = 10 g The initial temperature of water T1 = 0oC = 273 K Water…

Q: Over a 0.1 m X 0.1 m sheet at 175°C, air flows at 25°C and 1 bar with a velocity of 1 m/s. Calculate…

A:

Q: Suppose you have a fermented broth with a mass of 18. 845444kg, it will now undergo the distillation…

A: Given data: Amount of fermented broth=18.845444 kg Here, bioethanol is extracted from the…

Q: After a tough week of exams, you decide that nothing could be better than having a home cooked roast…

A: Thermal diffusivity: In heat transfer, thermal diffusivity is the thermal conductivity divided by…

Q: 4.) Steam undergoes an Isentropic process where it is initially at 1.30 MPa and 200 C then it…

A: Given, The initial pressure, P1 = 1.30 MPa The final pressure, P2 = 0.75 MPa The initial…

Q: I recently needed to replace the hot water beater in the basement of my house. On a typical day, the…

A: Disclaimer: Since you have posted a question with multiple sub-parts, we will solve first three…

Q: Q.9A heat exchanger is used to cool a hot hydrocarbon liquid flowing at rate of 200 Kg/hr from 150°…

A:

Q: 1) Heat capacity of hydrogen is given in terms of polynomial functions of temperature: Cp…

A: Given heat capacity of hydrogen in terms of polynomial functions of temperature is…

Q: 5. A stream of wastewater containing 5.15% mass of chromium from a metal packaging plant is fed to a…

A: Given: The mass percentage of Chromium (Cr) ions in wastewater are 5.15 % 95% of this Chromium is…

Q: Does all the substance available in nature have same heat capacity? Yes/ No. Explain why? Can the…

A:

Q: 8.11 A 60 m room is heated by a thermal energy storage system. The room air originally is at 12 °C…

A: Given that : Volume of room ,v =60 m3T1  = 12 CP1  = 100 KPaQloss  = 0.2 KJ/s   =0.2 KWthermal…