Answered: What current must be maintained in a… | bartleby

Related questions

Question

Calculate the current to be maintained in square loop.

What current must be maintained in a square loop (50 cm on a side) to create a torque of 1.0N - mabout an
axis through its center and parallel to one of its sides when a magnetic field of magnitude 70 mT is directed at
40° to the plane of the loop?

Expert Solution

Trending now

This is a popular solution!

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Blurred answer

Similar questions

A certain electric motor draws a current of 10 A when connected to 120 V. (b) How much energy does it use during 4 h of operation? Express your answer in kilowatt-hours.
For the circuit shown below, ε = 24 V, L = 6 mH, and R = 4.50. After steady state is reached with S₁ closed and S₂ open, at t = 0, S₂ is closed and S₁ is opened. Determine (a) the current through L at t = 0, (b) the current through L at t = 5.5 x 10-4 s, (c) the voltage across R on the right at t = 5.5 × 10-4 s, and (d) the rate at which current through I changes at t = 5.5 × 10-4 L S. E Hint R S₁ eeee a. The current through L at t = 0 is 5.3 A. Additional Hints for (a). b. The current through Lat t = 5.5 x 10-4 s is A. Additional Hints for (b). c. The voltage across R at t = 5.5 x 10-4 s is V. Additional Hints for (c). d. The rate at which current through L changes at t = 5.5 × 10-4 s is A/s. Additional Hints for (d).
21 V, L 0, S2 is closed and S1 is opened. Determine (a) the current through L at For the circuit shown below, ɛ Si closed and S2 open, at t t = 0, (b) the current through L at t t = 3 x 10-4 4.5 mH, and R = 4N. After steady state is reached with 3 x 10 s, (c) the voltage across R on the right at s, and (d) the rate at which current through L changes att = 3 x 10-4 s. R E .R Hint a. The current through L at t = 0 is 5.25 A. Additional Hints for (a) .4 b. The current through L at t = 3 x 10 s is 4.0211 A. Additional Hints for (b) - 4 c. The voltage across R att 3 x 10 s is 16.17 V. Additional Hints for (c) d. The rate at which current through L changes at t = 3 × 10° s is A/s. Additional Hints for (d). 0000
For the circuit shown below, E = 26 V, L = 2.4 mH, and R = 4.5 n. After steady state is reached with s, closed and s, open, S, is closed and immediately thereafter (at t = 0) s, is opened. R (a) Determine the current through L (in A) at t = 0. A (b) Determine the current through L (in A) at t = 4.0 x 104 s (c) Determine the voltages across L and R (in V) at t = 4.0 x 10* s. V, = VR =
A portion of Nichrome wire of radius 2.50 mm is to be used in winding a heating coil, if the coil must draw a current of 9.25 A when a voltage of 120 V is applied across its ends, find the required resistance of the coll.
The right side of the followingcircuit is in a B-field of strength 0.8T. Find the magnitude and directionof the force felt by the rightmostwire assuming the resistance is 8 Ω,L = 52 cm , and V = 9 V.
What direct current in A will produce the same amount of thermal energy, in a particular resistor, as an alternating current that has a maximum value of 7.2 A?
For the circuit shown below, Ɛ = 24 V, L = 3.6 mH, and R = 3.0 N. After steady state is reached with S, closed and S, open, S, is closed and immediately thereafter (at t = 0) S, is opened. R S2 R (a) Determine the current through L (in A) at t = 0. A (b) Determine the current through L (in A) at t = 4.0 x 10-4 s. A (c) Determine the voltages across L and R (in V) at t = 4.0 x 10-4 s. V, = V VR = V 0000,
The circuit in the figure is under the influence of the magnetic field B= âx5 cos(2n10®t – 0.2ny) µT. Find the current i by accepting R = 15 ohms.
(a) In the figure what value must R have if the current in the circuit is to be 1.1 mA? Take ε1 = 3.0 V, ε2 = 4.2 V, and r1 = r2 = 2.7 Ω. (b) What is the rate at which thermal energy appears in R?
PART (1) Assume capacitor is fully charged when switch is at position 'a' for about 10 minutes. The switch is changed to position 'b' at t= 0. What is the current in the circuit immediately after the switch is closed? Assume after some time, the current in the circuit is 80.0 mA when the switch is at position 'b'. Can you find, what will be that time? 9.0 V 부 Paragraph a itur b 1.0 με PART (II) Assume a magnetic field of 5.2 T present inside the cyclotron. An electron enters the cyclotron with speed of 2.0 x 107 m/s. What is the radius of the electron's orbit just before they exit from the cyclotron. BI U A/ 10 Ω E✓ E GO + v
A galvanometer has a coil resistance of Rgaly I = 2.55 A. If the galvanometer deflects full scale for a current of Igalv 45.2 Q. It is to be made into an ammeter with a full-scale deflection equal to 175 mA, what size shunt resistor should be used? size of shunt resistor: Ω

SEE MORE QUESTIONS