Answered: What capacitance is needed in series…

What capacitance is needed in series with a 100-2 resistor and 15-mH inductor to get a total impedance of 110 N at 2000 Hz?

College Physics

1st Edition

ISBN:9781938168000

Author:Paul Peter Urone, Roger Hinrichs

Publisher:Paul Peter Urone, Roger Hinrichs

Chapter23: Electromagnetic Induction, Ac Circuits, And Electrical Technologies

Section: Chapter Questions

Problem 92PE: An RL circuit consists of a 40.0 (resistor and a 3.00 mH inductor. (a) Find its impedance Z at l60.0...

See similar textbooks

Related questions

Q: Convert: the density of the blood 1060 Kg/m³ to mg/cm³ Answer:

Q: A helium balloon is used to lift a load of 110 N. The weight of the balloon cover is 50 N and its…

A: This question is about to find what should happen when temperature of gas is constant.

Q: A truck goes around a curve, the radius of which is 1/2 mile. The truck will tip over if its normal…

A: Given that The radius of the curve is (r) = 12mile The normal component…

Q: A point charge q = -3.4 µC is located at the origin of a co- ordinate system. Another point charge…

A: The electric force between two charges is given by F = k q1q2/r² Where r is distance…

Q: 3. How long does it take a 750-W electric coffee pot to bring to a boil 0.75 L of water initially at…

A: Given: Power,P=750WMass of water,mW=0.75L=0.75kgInitial Temperature,Ti=80CFinal…

Q: Question 6. You are looking through a microscope using the 50X objective lens. Both ocular lenses…

A: Given, The objective lens has a magnification power of 50X.

Q: The flux of the magnetic field (magnetic induction) is measured in weber (symbol Wb) which in the…

A: The strength of a magnetic field over a given area is measured by a process known as magnetic flux.…

Q: Needs Complete solution don't use chat gpt or ai i definitely upvote you. Be careful Downvote…

Q: A 3800kg elephant is lifted by two helicopters, as shown below. The elephant accelerates upward at…

Q: s an angle of e

Q: 45. (II) Two samples of an ideal gas are initially at the same temperature and pressure; they are…

A: Given two samples of ideal gases at the same temperature initially. let the gases be A and B let…

Q: Needs Complete solution don't use chat gpt or ai i definitely upvote you.

A: GUIDE: (1) Multiplying Two Complex Numbers in Polar Form…

Q: •• A 0.500-mol sample of an ideal monatomic gas at 400 kPa and 300 K, expands quasi-statically until…

Q: C1=100 and C2=12 sorry I can't fit whole question in the picture.

Q: Needs Complete solution don't use chat gpt or ai i definitely upvote you. Be careful Downvote…

Q: (b) What is the electron speed as a fraction of the speed of light? (c) BONUS QUESTION: The…

Q: II) When 2.0 kg of water at 20°C is mixed with 3.0 kg of vater at 80°C in a well-insulated…

A: Given: The mass of water at 20°C is 2 kg. The mass of water at 80°C is 3 kg. To…

Q: 2. A camp is on a mountainside that slopes 30.0°. pull a 20.0 kg sled up the slippery incline for…

Q: A Resistor-Inductor (RL) circuit is an electrical circuit composed of resistors and inductors driven…

A: The differential equation for R-L circuit is given by Ldidt + Ri = E didt + RLi = EL we know that…

Q: Note: When the vectors A and B are parallel cos 0 = 1 and the dot product has maximum value.…

A: According to question we need to find angle between two vectors.

Q: 11. An RLC series circuit consists of a resistor of 100 N, a capacitor of 10.0 µF, and an inductor…

Q: In a calorimetry experiment, two liquid substances X and Y with the same mass are placed in separate…

Q: Uniform B, I to the screen No B No B A proton (mass- 1.67 1027 kg, charge- 1.6-1019C) travelling…

Q: The following table shows the time T, in seconds, it takes for a rock to fall s feet on a certain…

A: The model that describes the system most accurately (relative) is the 1st one. This can be done by…

Q: 1.A. Compute the temperature at which the root-mean-square (rms) speed of an H2 molecule equals the…

A: We have to equate RMS speed of hydrogen and oxygen molecules with escape velocity of earth.

Q: 40. (II) Two parallel circular rings of radius R have their centers on the x axis separated by a…

Q: You are riding a 1500-kg car. The car makes a m radius. If the road is unbanked, what is the maximum…

A: Given : mass of the car=m=1500kg The radius of the road at which the car make a left…

Q: . A15-cm-deep opaque container is empty except for a single coin resting on its bottom surface. When…

Q: 1. In the process of taking a gas from state a to state c, along the curved path, 80 J of heat leave…

A: Solution:-Given thatFor curved path;Qa→c=-80 JWa→C=-55 J

Q: 39. 0. A 15-cm-deep opaque container is empty except for a single coin resting on its bottom…

A: Since we are not given any information about the material that the container is made of, such as…

Q: 4) In the figure shown, The top disk has a moment of inertia 3 times the bottom disk (and the top…

Q: Check the correct statements. * Glide slop provide a vertical guidance to the runway at 10 degrees…

A: Instrument Landing System (ILS) is a precision landing assist developed by the International Civil…

Q: (b) 10 cm from one end of the solenoid, and ✔T (c) 5 cm from one end of the solenoid? B= B = Br= T…

A: Given Data: Length of solenoid (L) = 40 cm = 0.4 m.Diameter (D) = 3 cm= 0.03 m.Number of turns (n) =…

Q: 3. Which way would the magnetic field point, in the given diagram?: * +9Q V FB A. To the left, in…

A: 3. The magnetic force on a point charge will be -…

Q: Problem 3: An infinite plane of charge with surface charge density n = 3.2 μC/m² has a…

A: Given:surface charge density of infinite plate is , η = 3.2 μC/m2diameter of the circular hole, d =…

Q: An insect crawls on the floor along the curved path shown in the figure below. The insect's…

A: Initial velocity is: ( along +y axis)Final velocity is: ( along +x axis)

Q: 5. (III) Suppose the charge Q on the ring of Fig. 21-28 was all distributed uniformly on only the…

Q: 3. The rectilinear motion of a particle is governed by the equation a = 6t – 4 where a is in m/s^2…

Q: i need help with the problem #4! i do not understand problem 4

Question

100%

How do I solve this problem?

*Please make sure the full solution is viewable and does not cut off.

13.
What capacitance is needed in series with a 100-2 resistor and 15-mH inductor to get a total impedance of
110 N at 2000 Hz?
(a) 0.56 µF
(b) 10 µF
(c) 46 µF
(d) 0.14 mF
(e) 0.56 mF

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

An inductor (L = 400 mH), a capacitor (C = 4.43 F), C1 and a resistor (R = 500 11) are connected in series. A 50.0-Hz AC] source produces a peak current of 250 mA in the circuit, (a) Calculate the required peak voltage Vmax (b) Determine the phase angle by which the current leads or lags the applied voltage.
An RLC series circuit hag a 1.00 k(register, a 150 (H inductor, and a 25.0 nF capacitor. (a) Find the circuit’s impedance at 500 Hz. (b) Find the circuit’s impedance at 7.50 kHz. (c) It the voltage source has Vrms = 408 V, what is Irms at each frequency? (d) What is the resonant frequency of the circuit? (e) What is Irms at resonance?
A multimeter in an RL circuit records an rms current of 0.500 A and a 60.0-Hz rms generator voltage of 104 V. A wattmeter shows that the average power delivered to the resistor is 10.0 W. Determine (a) the impedance in the circuit, (b) the resistance R, and (c) the inductance L.
An RLC series circuit has a 2.50 (resistor, a 100 (H inductor, and an 80.0 (F capacitor. (a) Find the circuit's impedance at 120 Hz. (b) Find the circuit’s impedance at 5.00 kHz. (c) If the voltage source has Vrms = 5.60 V, what is Irms at each frequency? (d) What is the resonant frequency of the circuit? (e) What is Irms at resonance?
A series RLC circuit has resistance R = 50.0 and inductance L. = 0.500 H. (a) Find the circuits capacitance C if the voltage source operates at a frequency of f = 60.0 Hz and the impedance is Z = R = 50.0 . (b) What is the phase angle between the current and the voltage?
A series RLC circuit has components with the following values: L = 20.0 mH, C = 100 nF, R = 20.0 , and Vmax = 100 V, with v = Vmax sin t. Find (a) the resonant frequency of the circuit, (b) the amplitude of the current at the resonant frequency, (c) the Q of the circuit, and (d) the amplitude of the voltage across the inductor at resonance.
Review. The voltage phasor diagram for a certain series RLC circuit is shown in Figure P33.59. The resistance of the circuit is 75.0 , and the frequency is 60.0 Hz. Find (a) the maximum voltage Vmax, (b) the phase angle , (c) the maximum current, (d) the impedance, (e) the capacitance and (f) the inductance of the circuit, and (g) the average power delivered to the circuit.
An RLC series circuit has a 1.00 k(resistor, a 1.50 (H inductor, and a 25.0 nF capacitor. (a) Find the power factor at f = 7.50 Hz. (b) What is the phase angle at this frequency? (c) What is the average power at this frequency? (d) Find the average power at the circuit’s resonant frequency.
Problems 71 and 72 paired. Figure P33.71 shows a series RLC circuit with a 25.0- resistor, a 430.0-mH inductor, and a 24.0-F capacitor connected to an AC source with Vmax = 60.0 V operating at 60.0 Hz. What is the maximum voltage across the a. resistor, b. inductor, and c. capacitor in the circuit? FIGURE P33.71 Problems 71 and 72.
An RLC circuit has resistance R = 225 and inductive reactance XL. = 175 . (a) Calculate the circuits capacitive reactance XC if its power factor is cos = 0.707. Repeat the calculation for (b) cos = 1.00 and (c) cos = 1.00 102.
A 1.5k resistor and 30-mH inductor are connected in series, as below, across a120-V(rms)ac power source oscillating at 60-Hz frequency. (a) Find the current in the circuit. (b) Find the voltage drops across the resistor and inductor. (C) Find the impedance of the circuit. (d) Find the power dissipated in the resistor. (e) Find the power dissipated in the inductor. (1) Find the power produced by the source.
In a purely inductive AC circuit as shown in Figure P21.15, Vmax = 100. V. (a) The maximum current is 7.50 A at 50.0 Hz. Calculate the inductance L. (b) At what angular frequency is the maximum current 2.50A? Figure p21.15